Startseite Development of high-temperature thermoelectric materials based on SrTiO3-layered perovskites
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

Development of high-temperature thermoelectric materials based on SrTiO3-layered perovskites

  • Wilfried Wunderlich und Kunihito Koumoto
Veröffentlicht/Copyright: 31. Mai 2013
Veröffentlichen auch Sie bei De Gruyter Brill

Abstract

For improving the performance of ceramic thermoelectric materials an increase in the effective mass is required because it is the main factor determining the Seebeck coefficient, in the case of a semiconductor with sufficiently high carrier concentration. The Ruddlesden–Popper phase Sr3Ti2O7, with its conducting perovskites layer in between the phonon absorbing SrO layers, is an example for advanced material design by nano-block integration. Using ab-initio simulations, the electronic bandstructure was calculated, and from the curvature of the bands the effective mass was deduced. While Sr3Ti2O7 has a smaller effective mass than the Nb-doped SrTiO3, the layered perovskites with substitution of Ta instead of Ti possess very large effective masses (m*/m0=9 in average) and a large thermopower is expected. In the experiments, however, the sufficient charge carrier concentration could not yet be reached.


* Correspondence address: Prof. Dr. rer. nat. Wilfried Wunderlich, Tokai University, Dept. Eng. Material Science, Kitakaname 1117, Hiratsuka, Kanagawa, 259-1292, Japan, Tel.: +819074360253, Fax: +81463502056. E-mail:

Dedicated to Professor Dr. Fritz Aldinger on the occasion of his 65th birthday


References

[1] S.Ohta, T.Nomura, H.Ohta, K.Koumoto: J. Appl. Phys.97 (2005) 034106.10.1063/1.1847723Suche in Google Scholar

[2] S.Ohta, T.Nomura, H.Ohta, K.Koumoto: Appl. Phys. Lett.87 (2005) 092108.10.1063/1.2035889Suche in Google Scholar

[3] W.Wunderlich, H.Ohta, K.Koumoto: ArXiv/condmat0510013.Suche in Google Scholar

[4] R.Moos, A.Gnudi, K.H.Haerdtl: J. Appl. Phys.78 [8] (1995) 5042.10.1063/1.359731Suche in Google Scholar

[5] K.Koumoto, S.Ohta, H.Ohta: Proc. Int Conf. Thermoelectrics ICT 2004, Adelaine (in press).Suche in Google Scholar

[6] H.Muta, K.Kurosaki, S.Yamanaka: J. Alloy. Comp.350 (2003) 292.10.1016/S0925-8388(02)00972-6Suche in Google Scholar

[7] H.Muta, K.Kurosaki, S.Yamanaka: J. Alloy. Comp.368 (2004) 22.10.1016/j.jallcom.2003.07.016Suche in Google Scholar

[8] I.Terasaki, Y.Sasago, K.Uchinokura: Phys. Rev.B56 [20] (1997) R12685.10.1103/PhysRevB.56.R12685Suche in Google Scholar

[9] S.Li, R.Funahashi, R.Matsubara, K.Ueno, H.Yamada: J. Mat. Chem.9 (1999) 1659.10.1039/a904413bSuche in Google Scholar

[10] S.N.Ruddlesden, P.Popper: Acta Cryst.11 (1958) 54.10.1107/S0365110X58000128Suche in Google Scholar

[11] J.H.Haeni, C.D.Theis, D.G.Shlom, W.Tian, X.Q.Pan, H.Chang, I.Takeuchi, X.D.Xiang: Appl. Phys. Lett.78 [1] (2001) 3292.10.1063/1.1371788Suche in Google Scholar

[12] C.B.Vining: J. Appl. Phys.69 (1991) 331.10.1063/1.347717Suche in Google Scholar

[13] Y.Matumoto, U.Unal, N.Tanaka, A.Kudo, H.Kato: J. Sol. State Chem.177 (2004) 4205.10.1016/j.jssc.2004.08.001Suche in Google Scholar

[14] I.G.Ismailzade: Kristallografiya7 (1962) 718.Suche in Google Scholar

[15] H.-G.Krane, S.Kek, K.F.Fischer: Zeitschrift fuer Kristallographie12 (1997) 129.Suche in Google Scholar

[16] M.Gasperin: Comptes Rendus Hebdomadaires des Seances de l'Academie des Sciences240 (1955) 2340.Suche in Google Scholar

[17] M.Gasperin: Bull. Soc. Franc. Mine. Cristall.83 (1960) 1.Suche in Google Scholar

[18] C.H.Chen, S.Xie, E.Sperling, A.S.Yang, G.Henriksen, K.Amine: Solid State Ionics167 [3–4] (2004) 263.10.1016/j.ssi.2004.01.008Suche in Google Scholar

[19] N.S.P.Bhuvanesh, M.P.Crosnier-Lopez, J.L.Duroy, H.Fourquet: J. Mater. Chem.9 (1999) 3093.10.1039/a903720iSuche in Google Scholar

[20] M.P.Crosnier-Lopez, J.L.Fourquet: Solid State Sciences7 (2005) 530.10.1016/j.solidstatesciences.2005.01.015Suche in Google Scholar

[21] G.Kresse, J.Hafner: Phys. Rev.B49 (1994) 14251.Suche in Google Scholar

[22] G.Chen, M.S.Dresselhaus, G.Dresselhaus, J.P.Fleuiral, T.Caillat: Int. Mater. Rev.48 [1] (2003) 1.10.1179/095066003225010182Suche in Google Scholar

[23] C.Villagonzalo, R.A.Roemer, M.Schreiber, A.MacKinnon: Phys. Rev. B62 [24] (2000) 16446.10.1103/PhysRevB.62.16446Suche in Google Scholar

[24] S.Ichikawa, I.Terasaki, Phys. Rev.B68 (2003) 23310110.1103/PhysRevB.68.233101Suche in Google Scholar

Received: 2005-10-30
Accepted: 2006-2-7
Published Online: 2013-05-31
Published in Print: 2006-05-01

© 2006, Carl Hanser Verlag, München

Artikel in diesem Heft

  1. Contents
  2. Contents
  3. Editorial
  4. Editorial
  5. Basic
  6. Three-dimensional printing of TiAl3/Al2O3 composites
  7. Microemulsion mediated synthesis of nanocrystalline BaTiO3: possibilities, potential and perspectives
  8. Solid-State 17O NMR studies on Yttria-stabilized zirconia
  9. Twinning in ultrathin silicon nanowires
  10. Re-optimization of the Mg–Sb system under topological constraints
  11. Mg-rich phase equilibria of Mg–Mn–Zn alloys analyzed by computational thermochemistry
  12. The In–Pt–Sb phase diagram
  13. Thermodynamic evaluation of the Al–Cr–C system
  14. Thermodynamic description of the Ni–Si–Ti ternary system
  15. Enthalpies of formation measurements and thermodynamic description of the Ag–Cu–Zn system
  16. Thermodynamic assessment of the Mn–Cr–O system for solid oxide fuel cell (SOFC) materials
  17. Subsolidus phase equilibria in the CeO2−x–SiO2–ZrO2 system: An experimental study
  18. Generalized Maugis–Dugdale model of an elastic cylinder in non-slipping adhesive contact with a stretched substrate
  19. Implications of linear relationships between local and macroscopic flow stresses in the composite model
  20. Applied
  21. Gas-phase surface alloying under “kinetic control”: A novel approach to improving the surface properties of titanium alloys
  22. Thin film formation by oriented attachment of polymer-capped nanocrystalline ZnO
  23. The sintering mechanism and microstructure evolution in SiC–AlN ceramics studiedby EFTEM
  24. Thermal evolution of free volumes and of crystallization in amorphous Si–B–C–N ceramics
  25. High-temperature deformation behavior of nanocrystalline precursor-derived Si–B–C–N ceramics in controlled atmosphere
  26. Nanopowder dispersion and spray-drying process: the case of Cr2O3
  27. Electroless deposition of brushite (CaHPO4 · 2H2O) crystals on Ti–6Al–4V at room temperature
  28. The role of chemisorbed anions in the aqueous processing of AlN powder
  29. The influence of porosity on the electrical properties of liquid-phase sintered silicon carbide
  30. Development of high-temperature thermoelectric materials based on SrTiO3-layered perovskites
  31. The influence of the preparation method on the microstructure and properties of Al2O3/TiN nanocomposites
  32. Infrared properties of sintered α-MnSe
  33. Quasi-equilibrium sintering of particle clusters containing Bernal holes
  34. Design of metal ceramic composites
  35. Notifications
  36. DGM News
Heruntergeladen am 1.10.2025 von https://www.degruyterbrill.com/document/doi/10.3139/146.101286/html
Button zum nach oben scrollen