Contents

Articles in the same Issue

1. Contents
2. Contents
3. Editorial
4. Editorial
5. Basic
6. Three-dimensional printing of TiAl₃/Al₂O₃ composites
7. Microemulsion mediated synthesis of nanocrystalline BaTiO₃: possibilities, potential and perspectives
8. Solid-State ¹⁷O NMR studies on Yttria-stabilized zirconia
9. Twinning in ultrathin silicon nanowires
10. Re-optimization of the Mg–Sb system under topological constraints
11. Mg-rich phase equilibria of Mg–Mn–Zn alloys analyzed by computational thermochemistry
12. The In–Pt–Sb phase diagram
13. Thermodynamic evaluation of the Al–Cr–C system
14. Thermodynamic description of the Ni–Si–Ti ternary system
15. Enthalpies of formation measurements and thermodynamic description of the Ag–Cu–Zn system
16. Thermodynamic assessment of the Mn–Cr–O system for solid oxide fuel cell (SOFC) materials
17. Subsolidus phase equilibria in the CeO_2−x–SiO₂–ZrO₂ system: An experimental study
18. Generalized Maugis–Dugdale model of an elastic cylinder in non-slipping adhesive contact with a stretched substrate
19. Implications of linear relationships between local and macroscopic flow stresses in the composite model
20. Applied
21. Gas-phase surface alloying under “kinetic control”: A novel approach to improving the surface properties of titanium alloys
22. Thin film formation by oriented attachment of polymer-capped nanocrystalline ZnO
23. The sintering mechanism and microstructure evolution in SiC–AlN ceramics studiedby EFTEM
24. Thermal evolution of free volumes and of crystallization in amorphous Si–B–C–N ceramics
25. High-temperature deformation behavior of nanocrystalline precursor-derived Si–B–C–N ceramics in controlled atmosphere
26. Nanopowder dispersion and spray-drying process: the case of Cr₂O₃
27. Electroless deposition of brushite (CaHPO₄ · 2H₂O) crystals on Ti–6Al–4V at room temperature
28. The role of chemisorbed anions in the aqueous processing of AlN powder
29. The influence of porosity on the electrical properties of liquid-phase sintered silicon carbide
30. Development of high-temperature thermoelectric materials based on SrTiO₃-layered perovskites
31. The influence of the preparation method on the microstructure and properties of Al₂O₃/TiN nanocomposites
32. Infrared properties of sintered α-MnSe
33. Quasi-equilibrium sintering of particle clusters containing Bernal holes
34. Design of metal ceramic composites
35. Notifications
36. DGM News