Startseite Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy

  • Georgina De Micco EMAIL logo , Ana Ester Bohé und Daniel Miguel Pasquevich
Veröffentlicht/Copyright: 12. Januar 2022
Veröffentlichen auch Sie bei De Gruyter Brill
Informationen für Autor*innen
International Journal of Materials Research
Aus der Zeitschrift International Journal of Materials Research Band 97 Heft 8

Abstract

In the present work we study the phase transformation reaction of a Cu-20Zn-7Al (wt.%) alloy by isothermal and nonisothermal in situ X-ray diffraction. An effective activation energy for each phase is obtained for the range between 275 and 395 °C. The experimental data are also adjusted with the JMA equations. Finally, we present the TTT (time – temperature – transformation) diagram corresponding to the precipitation of alpha and gamma for the lower temperatures. Below 340 °C, we found for this alloy that the gamma phase precedes the formation of alpha.

Keywords: CuZnAl alloys; Transformation kinetics; TTT diagram; Phase transformation
Georgina De Micco Centro Atómico Bariloche (CAB) Bustillo 9.500 R84002AGP S.C. de Bariloche – Río Negro, Argentina Tel.: +54 2944 44 5293 Fax: +54 2944 44 5299

  1. The authors would like to thank the Materials Characterization Division of Centro Atómico Bariloche CNEA for the XRD facility, and to Ernesto Scerbo for obtaining the XRD profiles. We also wish to thank the Agencia Nacional de Promoción Científica y Tecnológica (ANPCyT), CONICET and Universidad del Comahue of Argentina for the financial support of this work.

6. References

[1] G. Petzow, G. Effenberg: Ternary Alloys A Comprehensive Compendium of Evaluated Constitutional Data and Phase Diagrams, Weinhein, Basel, Switzerland/ Cambridge/New York, NY: VCH, Vol. V (1992).Suche in Google Scholar

[2] M.L. Castro: Phd. Thesis, Universidad Nacional del Centro de la Provincia de Buenos Aires, Argentina(1999).Suche in Google Scholar

[3] E.-S. Lee, Y.G. Kim: Met. Trans. A 21 (1990) 1681.10.1007/BF02672584Suche in Google Scholar

[4] S. Yon, Y. Han: J. Mater. Sci. 21 (1986) 2711.10.1007/BF00551477Suche in Google Scholar

[5] E.-S. Lee, Y.G. Kim: Scripta Met. et Mater. 24 (1990) 745.10.1016/0956-716X(90)90235-9Suche in Google Scholar

[6] S.K. Mannan, G. Vaidehi, M. Vijayalakdhmi, V. Seetharaman: J. Mater. Sci. 19 (1984) 2465.10.1007/BF00550799Suche in Google Scholar

[7] A.J. Fletcher, T.D. Lloyd: J. of Inst. of Met. 98 (1970) 188.Suche in Google Scholar

[8] N.F. Kennon, D.P. Dunne, L. Middleton: Met. Trans. A 13 (1982) 551.10.1007/BF02644418Suche in Google Scholar

[9] T.B. Massalski, H.W. King: Progr. Mater. Sci. 10 (1961) 43.Suche in Google Scholar

[10] R. Rapacioli, M. Ahlers: Scripta Met. 11 (1977) 1147.10.1016/0036-9748(77)90324-6Suche in Google Scholar

[11] R. Romero, J.L. Pelegrina: Mater. Sci. and Eng. A 354 (2003) 243.10.1016/S0921-5093(03)00013-3Suche in Google Scholar

[12] E.J. Mittemeijer: J. Mater. Sci. 27 (1992) 3977.10.1007/BF01105093Suche in Google Scholar

[13] M. Avrami: J. Chem. Phys. 7 (1939) 1103.10.1063/1.1750380Suche in Google Scholar

[14] M. Avrami: J. Chem. Phys. 8 (1940) 212.10.1063/1.1750631Suche in Google Scholar

[15] M. Avrami: J. Chem. Phys. 9 (1941) 177.10.1063/1.1750872Suche in Google Scholar

[16] W.A. Johnson, R.F. Mehl: Trans. Am. Inst. Min. (Metall.) Engs. 135 (1939) 416.Suche in Google Scholar

[17] A.T.W. Kempen, F. Sommer, E.J. Mittemeijer: J. Mater. Sci. 37 (2002) 1321.10.1023/A:1014556109351Suche in Google Scholar

[18] A.T.W. Kempen, F. Sommer, E.J. Mittemeijer: Acta Mater. 50 (2002) 1319.10.1016/S1359-6454(01)00428-1Suche in Google Scholar

[19] J.W. Christian: The Theory of transformations in metals and alloys. Pergamon Press, Oxford (1965).Suche in Google Scholar

[20] Automated Powder Diffraction v.3.6, Philips Electronics N. V. 1995.Suche in Google Scholar
Received: 2004-10-08
Accepted: 2006-04-16
Published Online: 2022-01-12

© 2006 Carl Hanser Verlag, München

Artikel in diesem Heft

  1. Contents
  2. Extended editorial with anecdotes
  3. Anelastic relaxation and structure of ternary Fe–Al–Me alloys with Me = Co, Cr, Ge, Mn, Nb, Si, Ta, Ti, Zr
  4. Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy
  5. Calorimetric investigation of the binary Cu–In system
  6. Thermodynamic properties of liquid Cu–In–Zn alloys
  7. Comparing the thermodynamic behaviour of Al(l) + ZrO2(4% Y2O3) and Al(l) + Al2O3
  8. Failure-mode dependence of the strengthening effect in Ti3AlC2/10 vol.% Al2O3 composite
  9. Investigation of Cu-graphite composites prepared by electroforming
  10. Neutron diffraction analysis of martensite ageing in high-carbon FeCMnSi steel
  11. Effect of reinforcement size hybridization on the wear properties of SiCp/Cu Composites
  12. Temperature dependence of lattice mismatch and γ′ volume fraction of a fourth-generation monocrystalline nickel-based superalloy
  13. Novel combinatorial microstructures in Ti-6Al-4V alloy achieved by an electric-current-pulse treatment
  14. The Effect of Ti–B and Sr on the mechanical behaviour of the Zinc–Aluminum-based ZA-12 alloy produced by gravity casting
  15. Determination of retained austenite in multiphase steels by magnetic force microscopy
  16. Filtration resistance during pressure filtration tests of liquid aluminium alloys
  17. Microstructure of a Damascene sabre after annealing
  18. Effect of tin added to the zinc bath on the formation and the microstructure of hot-dip galvanized coatings
  19. Personal
  20. Conferences
  21. Contents
  22. Editorial
  23. Extended editorial with anecdotes
  24. Basic
  25. Anelastic relaxation and structure of ternary Fe–Al–Me alloys with Me = Co, Cr, Ge, Mn, Nb, Si, Ta, Ti, Zr
  26. Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy
  27. Calorimetric investigation of the binary Cu–In system
  28. Thermodynamic properties of liquid Cu–In–Zn alloys
  29. Comparing the thermodynamic behaviour of Al(l) + ZrO2(4% Y2O3) and Al(l) + Al2O3
  30. Failure-mode dependence of the strengthening effect in Ti3AlC2/10 vol.% Al2O3 composite
  31. Investigation of Cu-graphite composites prepared by electroforming
  32. Neutron diffraction analysis of martensite ageing in high-carbon FeCMnSi steel
  33. Applied
  34. Effect of reinforcement size hybridization on the wear properties of SiCp/Cu Composites
  35. Temperature dependence of lattice mismatch and γ′ volume fraction of a fourth-generation monocrystalline nickel-based superalloy
  36. Novel combinatorial microstructures in Ti-6Al-4V alloy achieved by an electric-current-pulse treatment
  37. The Effect of Ti–B and Sr on the mechanical behaviour of the Zinc–Aluminum-based ZA-12 alloy produced by gravity casting
  38. Determination of retained austenite in multiphase steels by magnetic force microscopy
  39. Filtration resistance during pressure filtration tests of liquid aluminium alloys
  40. Microstructure of a Damascene sabre after annealing
  41. Effect of tin added to the zinc bath on the formation and the microstructure of hot-dip galvanized coatings
  42. Notifications
  43. Personal
  44. Conferences
https://doi.org/10.3139/ijmr-2006-0171
Schlagwörter für diesen Artikel
CuZnAl alloys; Transformation kinetics; TTT diagram; Phase transformation

Artikel in diesem Heft

  1. Contents
  2. Extended editorial with anecdotes
  3. Anelastic relaxation and structure of ternary Fe–Al–Me alloys with Me = Co, Cr, Ge, Mn, Nb, Si, Ta, Ti, Zr
  4. Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy
  5. Calorimetric investigation of the binary Cu–In system
  6. Thermodynamic properties of liquid Cu–In–Zn alloys
  7. Comparing the thermodynamic behaviour of Al(l) + ZrO2(4% Y2O3) and Al(l) + Al2O3
  8. Failure-mode dependence of the strengthening effect in Ti3AlC2/10 vol.% Al2O3 composite
  9. Investigation of Cu-graphite composites prepared by electroforming
  10. Neutron diffraction analysis of martensite ageing in high-carbon FeCMnSi steel
  11. Effect of reinforcement size hybridization on the wear properties of SiCp/Cu Composites
  12. Temperature dependence of lattice mismatch and γ′ volume fraction of a fourth-generation monocrystalline nickel-based superalloy
  13. Novel combinatorial microstructures in Ti-6Al-4V alloy achieved by an electric-current-pulse treatment
  14. The Effect of Ti–B and Sr on the mechanical behaviour of the Zinc–Aluminum-based ZA-12 alloy produced by gravity casting
  15. Determination of retained austenite in multiphase steels by magnetic force microscopy
  16. Filtration resistance during pressure filtration tests of liquid aluminium alloys
  17. Microstructure of a Damascene sabre after annealing
  18. Effect of tin added to the zinc bath on the formation and the microstructure of hot-dip galvanized coatings
  19. Personal
  20. Conferences
  21. Contents
  22. Editorial
  23. Extended editorial with anecdotes
  24. Basic
  25. Anelastic relaxation and structure of ternary Fe–Al–Me alloys with Me = Co, Cr, Ge, Mn, Nb, Si, Ta, Ti, Zr
  26. Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy
  27. Calorimetric investigation of the binary Cu–In system
  28. Thermodynamic properties of liquid Cu–In–Zn alloys
  29. Comparing the thermodynamic behaviour of Al(l) + ZrO2(4% Y2O3) and Al(l) + Al2O3
  30. Failure-mode dependence of the strengthening effect in Ti3AlC2/10 vol.% Al2O3 composite
  31. Investigation of Cu-graphite composites prepared by electroforming
  32. Neutron diffraction analysis of martensite ageing in high-carbon FeCMnSi steel
  33. Applied
  34. Effect of reinforcement size hybridization on the wear properties of SiCp/Cu Composites
  35. Temperature dependence of lattice mismatch and γ′ volume fraction of a fourth-generation monocrystalline nickel-based superalloy
  36. Novel combinatorial microstructures in Ti-6Al-4V alloy achieved by an electric-current-pulse treatment
  37. The Effect of Ti–B and Sr on the mechanical behaviour of the Zinc–Aluminum-based ZA-12 alloy produced by gravity casting
  38. Determination of retained austenite in multiphase steels by magnetic force microscopy
  39. Filtration resistance during pressure filtration tests of liquid aluminium alloys
  40. Microstructure of a Damascene sabre after annealing
  41. Effect of tin added to the zinc bath on the formation and the microstructure of hot-dip galvanized coatings
  42. Notifications
  43. Personal
  44. Conferences
Jetzt anmelden und 20% sparen
Institutioneller Zugang
Wie funktioniert Authentifizierung?
Haben Sie eine Idee, wie wir unsere Website verbessern können?
Bitte schreiben Sie uns.
© 2025 De Gruyter Brill
Heruntergeladen am 26.9.2025 von https://www.degruyterbrill.com/document/doi/10.3139/ijmr-2006-0171/html
Button zum nach oben scrollen