Home Calorimetric investigation of the binary Cu–In system
Article
Licensed
Unlicensed Requires Authentication

Calorimetric investigation of the binary Cu–In system

  • S. Knott EMAIL logo and A. Mikula
Published/Copyright: January 12, 2022
Become an author with De Gruyter Brill
Author Information
International Journal of Materials Research
From the journal International Journal of Materials Research Volume 97 Issue 8

Abstract

Although some investigations of the integral enthalpy of mixing of the binary Cu–In system have already been done, there is a lack of conformity of these data within the literature. Therefore the integral enthalpy of mixing was determined with a Calvet-type calorimeter. The measurements were performed at four different temperatures to determine the temperature dependence of the integral enthalpy of mixing.

Keywords: Calorimetry; Lead-free solders; Enthalpy of mixing; Thermodynamic values
Mag. Dr. Sabine Knott Währingerstr. 42, A-1090 Vienna, Austria Tel.: +43 142 775 2913

References

[1] O.J. Kleppa: J. Phys. Chem. 60 (1956) 852.10.1021/j150541a005Search in Google Scholar

[2] K. Itagaki, A. Yazawa: J. Jpn. Inst. Met. 35 (1971) 383.10.2320/jinstmet1952.35.4_383Search in Google Scholar

[3] T. Kang, R. Castanet: J. Less Common Metals 51 (1977) 125.10.1016/0022-5088(77)90180-1Search in Google Scholar

[4] T. Kang, R. Castanet: J. Less Common Metals 53 (1977) 153.10.1016/0022-5088(77)90100-XSearch in Google Scholar

[5] K. Kameda: Mater. Trans. JIM 32 (1991) 345.10.2320/matertrans1989.32.345Search in Google Scholar

[6] B. Predel, U. Schallner: Z. Metallkd. 63 (1972) 119.10.1515/ijmr-1972-630302Search in Google Scholar

[7] P.R. Subramanian, D.E. Laughlin: Bulletin of Alloy Phase Diagrams 10 (1989) 554.10.1007/BF02882415Search in Google Scholar

[8] J. Hertz, K. El Aissaoui, L. Bourden: J. Phase Equilibria 23 (2002) 473.10.1361/105497102770331163Search in Google Scholar

[9] Z. Bahari, E. Dichi, B. Legendre, J. Dugué: Termochimica Acta 401 (1993) 131.10.1016/S0040-6031(02)00500-2Search in Google Scholar

[10] C.R. Kao, A. Bolcavage, S.-L. Chen, S.W. Chen, Y.A. Chang: J. Phase Equilibria 14 (1993) 22.10.1007/BF02652158Search in Google Scholar

[11] H.S. Liu, X.J. Liu, Y. Cui, C.P. Wang, I. Ohnuma, R. Kainuma, Z.P. Jin, K. Ishida: J. Phase Equilibria 23 (2002) 409.10.1361/105497102770331352Search in Google Scholar

[12] R. Hultgren, P.S. Desai, D.T. Hawkins, M. Gleiser, K.K. Kelley: Selected Values of the Thermodynamic Properties of Binary Alloys, ASM, Metals Park, OH (1973).Search in Google Scholar

[13] T. Azakami, A. Yazawa: J. Mining Met. Inst. Japan 85 (1969) 97.10.2473/shigentosozai1953.85.970_97Search in Google Scholar

[14] H. Flandorfer, F. Gehringer, E. Hayer: Thermochim. Acta 382 (2002) 77.10.1016/S0040-6031(01)00739-0Search in Google Scholar

[15] A.T. Dinsdale: Calphad 15 (1991) 317.10.1016/0364-5916(91)90030-NSearch in Google Scholar
Received: 2005-04-29
Accepted: 2005-11-19
Published Online: 2022-01-12

© 2006 Carl Hanser Verlag, München

Articles in the same Issue

  1. Contents
  2. Extended editorial with anecdotes
  3. Anelastic relaxation and structure of ternary Fe–Al–Me alloys with Me = Co, Cr, Ge, Mn, Nb, Si, Ta, Ti, Zr
  4. Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy
  5. Calorimetric investigation of the binary Cu–In system
  6. Thermodynamic properties of liquid Cu–In–Zn alloys
  7. Comparing the thermodynamic behaviour of Al(l) + ZrO2(4% Y2O3) and Al(l) + Al2O3
  8. Failure-mode dependence of the strengthening effect in Ti3AlC2/10 vol.% Al2O3 composite
  9. Investigation of Cu-graphite composites prepared by electroforming
  10. Neutron diffraction analysis of martensite ageing in high-carbon FeCMnSi steel
  11. Effect of reinforcement size hybridization on the wear properties of SiCp/Cu Composites
  12. Temperature dependence of lattice mismatch and γ′ volume fraction of a fourth-generation monocrystalline nickel-based superalloy
  13. Novel combinatorial microstructures in Ti-6Al-4V alloy achieved by an electric-current-pulse treatment
  14. The Effect of Ti–B and Sr on the mechanical behaviour of the Zinc–Aluminum-based ZA-12 alloy produced by gravity casting
  15. Determination of retained austenite in multiphase steels by magnetic force microscopy
  16. Filtration resistance during pressure filtration tests of liquid aluminium alloys
  17. Microstructure of a Damascene sabre after annealing
  18. Effect of tin added to the zinc bath on the formation and the microstructure of hot-dip galvanized coatings
  19. Personal
  20. Conferences
  21. Contents
  22. Editorial
  23. Extended editorial with anecdotes
  24. Basic
  25. Anelastic relaxation and structure of ternary Fe–Al–Me alloys with Me = Co, Cr, Ge, Mn, Nb, Si, Ta, Ti, Zr
  26. Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy
  27. Calorimetric investigation of the binary Cu–In system
  28. Thermodynamic properties of liquid Cu–In–Zn alloys
  29. Comparing the thermodynamic behaviour of Al(l) + ZrO2(4% Y2O3) and Al(l) + Al2O3
  30. Failure-mode dependence of the strengthening effect in Ti3AlC2/10 vol.% Al2O3 composite
  31. Investigation of Cu-graphite composites prepared by electroforming
  32. Neutron diffraction analysis of martensite ageing in high-carbon FeCMnSi steel
  33. Applied
  34. Effect of reinforcement size hybridization on the wear properties of SiCp/Cu Composites
  35. Temperature dependence of lattice mismatch and γ′ volume fraction of a fourth-generation monocrystalline nickel-based superalloy
  36. Novel combinatorial microstructures in Ti-6Al-4V alloy achieved by an electric-current-pulse treatment
  37. The Effect of Ti–B and Sr on the mechanical behaviour of the Zinc–Aluminum-based ZA-12 alloy produced by gravity casting
  38. Determination of retained austenite in multiphase steels by magnetic force microscopy
  39. Filtration resistance during pressure filtration tests of liquid aluminium alloys
  40. Microstructure of a Damascene sabre after annealing
  41. Effect of tin added to the zinc bath on the formation and the microstructure of hot-dip galvanized coatings
  42. Notifications
  43. Personal
  44. Conferences
https://doi.org/10.1515/ijmr-2006-0172
Keywords for this article
Calorimetry; Lead-free solders; Enthalpy of mixing; Thermodynamic values

Articles in the same Issue

  1. Contents
  2. Extended editorial with anecdotes
  3. Anelastic relaxation and structure of ternary Fe–Al–Me alloys with Me = Co, Cr, Ge, Mn, Nb, Si, Ta, Ti, Zr
  4. Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy
  5. Calorimetric investigation of the binary Cu–In system
  6. Thermodynamic properties of liquid Cu–In–Zn alloys
  7. Comparing the thermodynamic behaviour of Al(l) + ZrO2(4% Y2O3) and Al(l) + Al2O3
  8. Failure-mode dependence of the strengthening effect in Ti3AlC2/10 vol.% Al2O3 composite
  9. Investigation of Cu-graphite composites prepared by electroforming
  10. Neutron diffraction analysis of martensite ageing in high-carbon FeCMnSi steel
  11. Effect of reinforcement size hybridization on the wear properties of SiCp/Cu Composites
  12. Temperature dependence of lattice mismatch and γ′ volume fraction of a fourth-generation monocrystalline nickel-based superalloy
  13. Novel combinatorial microstructures in Ti-6Al-4V alloy achieved by an electric-current-pulse treatment
  14. The Effect of Ti–B and Sr on the mechanical behaviour of the Zinc–Aluminum-based ZA-12 alloy produced by gravity casting
  15. Determination of retained austenite in multiphase steels by magnetic force microscopy
  16. Filtration resistance during pressure filtration tests of liquid aluminium alloys
  17. Microstructure of a Damascene sabre after annealing
  18. Effect of tin added to the zinc bath on the formation and the microstructure of hot-dip galvanized coatings
  19. Personal
  20. Conferences
  21. Contents
  22. Editorial
  23. Extended editorial with anecdotes
  24. Basic
  25. Anelastic relaxation and structure of ternary Fe–Al–Me alloys with Me = Co, Cr, Ge, Mn, Nb, Si, Ta, Ti, Zr
  26. Kinetic study of the β → α + γ transformation reaction in a CuZnAl alloy
  27. Calorimetric investigation of the binary Cu–In system
  28. Thermodynamic properties of liquid Cu–In–Zn alloys
  29. Comparing the thermodynamic behaviour of Al(l) + ZrO2(4% Y2O3) and Al(l) + Al2O3
  30. Failure-mode dependence of the strengthening effect in Ti3AlC2/10 vol.% Al2O3 composite
  31. Investigation of Cu-graphite composites prepared by electroforming
  32. Neutron diffraction analysis of martensite ageing in high-carbon FeCMnSi steel
  33. Applied
  34. Effect of reinforcement size hybridization on the wear properties of SiCp/Cu Composites
  35. Temperature dependence of lattice mismatch and γ′ volume fraction of a fourth-generation monocrystalline nickel-based superalloy
  36. Novel combinatorial microstructures in Ti-6Al-4V alloy achieved by an electric-current-pulse treatment
  37. The Effect of Ti–B and Sr on the mechanical behaviour of the Zinc–Aluminum-based ZA-12 alloy produced by gravity casting
  38. Determination of retained austenite in multiphase steels by magnetic force microscopy
  39. Filtration resistance during pressure filtration tests of liquid aluminium alloys
  40. Microstructure of a Damascene sabre after annealing
  41. Effect of tin added to the zinc bath on the formation and the microstructure of hot-dip galvanized coatings
  42. Notifications
  43. Personal
  44. Conferences
Sign up now to receive a 20% welcome discount
Institutional Access
How does access work?
Have an idea on how to improve our website?
Please write us.
© 2025 De Gruyter Brill
Downloaded on 28.9.2025 from https://www.degruyterbrill.com/document/doi/10.1515/ijmr-2006-0172/html
Scroll to top button