Frontmatter

Articles in the same Issue

1. Frontmatter
2. Editorial
3. Additive manufacturing and allied technologies
4. Original Papers
5. Influence of process parameters on ageing and free vibration characteristics of fiber-reinforced polymer composites by fusion filament fabrication process
6. 3D biomimetic scaffold’s dimensional accuracy: a crucial geometrical response for bone tissue engineering
7. Investigation of mechanical and microstructure properties of metal inert gas based wire arc additive manufactured Inconel 600 superalloy
8. Study on the influence of surface roughness on tensile and low-cycle fatigue behavior of electron beam melted Ti‐6Al‐4V
9. Effect of tool pin profile on the heat generation model of the friction stir welding of aluminium alloy
10. Effect of clamping position on the residual stress in wire arc additive manufacturing
11. Effect of welding speed on butt joint quality of laser powder bed fusion AlSi10Mg parts welded using Nd:YAG laser
12. Mechanical behaviour, microstructure and texture studies of wire arc additive manufactured 304L stainless steel
13. Evolution of microstructure and properties of CoCrFeMnNi high entropy alloy fabricated by selective laser melting
14. Effect of laser energy density on surface morphology, microstructure and mechanical behaviour of direct metal laser melted 17-4 PH stainless steel
15. The influence of rheology in the fabrication of ceramic-based scaffold for bone tissue engineering
16. Behaviour of glass fiber reinforced polymer (GFRP) structural profile columns under axial compression
17. Desirability function analysis approach for optimization of fused deposition modelling process parameters
18. Effect of robotic weaving motion on mechanical and microstructural characteristics of wire arc additively manufactured NiTi shape memory alloy
19. Rapid tooling of composite aluminium filled epoxy mould for injection moulding of polypropylene parts with small protruded features
20. Investigation of microstructural evolution in a hybrid additively manufactured steel bead
21. Fused filament fabricated PEEK based polymer composites for orthopaedic implants: a review
22. Design of fixture for ultrasonic assisted gas tungsten arc welding using an integrated approach
23. Effect of post-processing treatment on 3D-printed polylactic acid parts: layer interfaces and mechanical properties
24. Investigating the effect of input parameters on tool wear in incremental sheet metal forming
25. Microstructural evolution and improved corrosion resistance of NiCrSiFeB coatings prepared by laser cladding
26. Microstructure and electrochemical behaviour of laser clad stainless steel 410 substrate with stainless steel 420 particles
27. News
28. DGM – Deutsche Gesellschaft für Materialkunde