Frontmatter

Articles in the same Issue

1. Frontmatter
2. Editorial
3. Editorial ICPCM 2021
4. Original Papers
5. Developing easy-to-use, cost-effective wound dressing material by coating commercial cotton bandages with nanomaterials
6. Temperature and magnetic field controlled dielectric relaxation and magnetodielectric response in KBiFe_1.9Co_0.1O₅ polycrystalline
7. Influence of thermo-mechanical treatment in austenitic and ferritic field condition on microstructural and mechanical properties of reduced activation ferritic-martensitic steel
8. Effect of nanoparticle on mechanical properties of activated tungsten gas welding of austenite stainless steel 316L and optimization of process parameters
9. Flexural behavior of carbon/glass inter-ply hybrid FRP composites under elevated temperature environments
10. Surfactant assisted single step electrodeposition of CuInSe₂ thin films with rich indium selenide surface over layer
11. Optimization of hot rolling parameters of CRNO steel with the aid of hot compression test and deformation map
12. Reduced graphene oxide synthesis by dry planetary ball milling followed by arc plasma treatment of high pure graphite
13. Influence of interphase characteristics on the elastic modulus of unidirectional glass-reinforced epoxy composites: a computational micromechanics study
14. Investigation of dielectric, impedance, and magnetodielectric behavior in Bi₅Ti₃FeO₁₅–Bi₂Fe₄O₉ composites prepared by sol–gel modified method
15. Effect of spheroidization annealing on low cycle fatigue (LCF) characteristics of cold forged steel components
16. Growth of CuO nanoparticles using one step chemical bath deposition under microwave heating and their characterizations
17. Phase formation and electrical properties study of PVDF thick films synthesized by solution casting method
18. Generation of microchannels on PMMA using an in-house fabricated μ-ECDM system
19. Temperature dependent constitutive plastic flow behaviour of titanium alloy Ti6Al4V
20. Production and characterization of Al–Cu binary alloy produced by using novel continuous casting process
21. Synthesis of Al–Sn alloys by direct chill casting under the effect of mechanical stirring: an experimental and simulation optimization study
22. Evaluation of characteristics for microwave-assisted polymer coating of the steel substrate
23. Synthesis and fabrication of acrylic acid treated rattan fiber epoxy composite
24. Development of superhydrophobic hybrid silica-cellulose aerogel as promising thermal insulation and sound absorption
25. Effect of thermal annealing on structure and magnetic properties in a Ni–Cr multilayer
26. Effect of heat input on corrosion behavior of automotive zinc-coated steel joint
27. Development of Al–SiC–TiO₂ hybrid composite using powder metallurgy route and the influence of TiO₂ content variation on microstructure and mechanical properties
28. News
29. DGM – Deutsche Gesellschaft für Materialkunde