Grain boundary characterization and grain size measurement in an ultrafine-grained steel

Articles in the same Issue

1. Frontmatter
2. Editorial
3. Editorial
4. Articles Basic
5. Thermally assisted motion of dislocations in solid solution-strengthened fcc alloys and the concept of “stress equivalence”
6. From single to collective dislocation glide instabilities: A hierarchy of scales, embracing the Neumann strain bursts
7. Geometry and surface state effects on the mechanical response of Au nanostructures
8. Microstructural evolution and its effect on the mechanical properties of Cu–Ag microcomposites
9. Deformation behaviour of strontium titanate between room temperature and 1800 K under ambient pressure
10. The deformation response of ultra-thin polymer films on steel sheet in a tensile straining test: the role of slip bands emerging at the polymer/metal interface
11. Influence of dissolved gas molecules on the size recovery kinetics of cold-rolled BPA-PC
12. Comparison between Monte Carlo and Cluster Variation method calculations in the BCC Fe–Al system including tetrahedron interactions
13. Experimental study and Cluster Variation modelling of the A2/B2 equilibria at the titanium-rich side of the Ti–Fe system
14. Phases and phase equilibria in the Fe–Al–Zr system
15. On the plate-like τ-phase formation in MnAl–C alloys
16. Articles Applied
17. The grain boundary hardness in austenitic stainless steels studied by nanoindentations
18. The effect of grain size on the mechanical properties of nanonickel examined by nanoindentation
19. Microstructures and mechanical properties of V–V₃Si eutectic composites
20. Grain boundary characterization and grain size measurement in an ultrafine-grained steel
21. On the determination of the volume fraction of Ni₄Ti₃ precipitates in binary Ni-rich NiTi shape memory alloys
22. Mechanical properties of NiAl–Cr alloys in relation to microstructure and atomic defects
23. Characterization of the cyclic deformation behaviour and fatigue crack initiation on titanium in physiological media by electrochemical techniques
24. Effect of prestraining on high-temperature fatigue behaviour of two Ni-base superalloys
25. Influence of surface defects and edge geometry on the bending strength of slip-cast ZrO₂ micro-specimens
26. Tensile failure in a superplastic alumina
27. Notifications/Mitteilungen
28. Personal/Personelles
29. Conferences/Konferenzen