DGM News

Artikel in diesem Heft

1. Contents
2. Contents
3. Original Contributions
4. Thermodynamic modeling of the In–Pt–Sb system
5. Classical controlled rolling of low C steels microalloyed with Ti and Mo
6. Development of carbide intermetallic layer by electric discharge alloying on AISI-D2 tool steel and its wear resistance
7. Comparison of fatigue crack growth rate of selective laser sintered RapidSteel via computational fracture mechanics
8. Wear resistance and fracture mechanics of WC–Co composites
9. Thermal expansion behavior of CNT/Ag nanocomposite
10. Thermophysical properties of solid phase rhodium measured by the pulse calorimetry technique over a wide temperature range
11. Influence of Co₃O₄ addition on the ionic conductivity and microstructural properties of yttria-stabilized zirconia (8YSZ)
12. High-activity of Pd catalyst supported on antimony tin oxide for hydrogen peroxide electroreduction
13. Investigation of low k interfacial layer characteristics of LaAlO₃ thin films grown on Si (100)
14. In-situ catalytic growth of MgAl₂O₄ spinel whiskers in MgO–C refractories
15. Short Communications
16. Preparation and characterization of boron nitride/carbon fiber composite with high specific surface area
17. Crevice corrosion resistance of high alloyed materials in 3.5 % NaCl solution
18. Effect of grain size on the microstructure and mechanical properties of Mg-4Y-3Nd-0.5Zr alloy
19. People
20. Professor Ulrich Martin on his 65^th birthday
21. DGM News
22. DGM News