Elevated Temperature Deformation of P/M Dispersion - Strengthened Copper and Aluminium
-
G. S. Upadhyaya
Abstract
Paper deals with the low cost route of the preparation of SiC/Si3N4 nanocomposite. It is shown that SiC nanoinclusions distributed within the Si3N4 matrix can be produced by carbothermal reduction of fine SiO2 particles added into a starting mixture. The amount of SiC nanoinclusions can be adjusted by the appropriate amount of SiO2 + C additives. Almost full density of the final composite was achieved by hot-pressing at 1750 °C using a “special” heating regime allowing the outgasing of CO as a product of carbothermal reduction.
References
1 Humphreys, F.J.; Martin, J.W.:Phil. Mag.17 (1968) 365.10.1080/14786436808226169Search in Google Scholar
2 Baker, I.; Martin, J.W., in: N. Hansen, A.R. Jones, T. Leffers (eds.), Proc. 1st Riso Int. Symp. Metallurgy and Materials Science, Riso National Laboratory, Roskilde (1980) 27.Search in Google Scholar
3 Oblak, J.M.; Owczarski, W.A.:Metall. Trans. 3 (1972) 617.10.1007/BF02642742Search in Google Scholar
4 Brown, L.M.; Ham, R.K., in: A. Kelly and R.B. Nicholson (eds.), Strengthening Methods in Crystals, Applied Science, Barking (1971)9.Search in Google Scholar
5 Lagneborg, R.:Scripta Metall. 7 (1973) 605.10.1016/0036-9748(73)90222-6Search in Google Scholar
6 Shewfelt, R.S.W.; Brown, L.M.:Philos. Mag. 30 (1974) 1135.10.1080/14786437408207265Search in Google Scholar
7 Idem, ibid.35 (1977) 945.10.1080/14786437708232636Search in Google Scholar
8 Arzt, E.; Ashby, M.F.:Scripta Metall. 16 (1952) 1285.10.1016/0036-9748(82)90484-7Search in Google Scholar
9 Nordone, V.C.; Tien, J.K.:ibid.17 (1983) 467.10.1016/0036-9748(83)90333-2Search in Google Scholar
10 Arzt, E.; Schroder, J.:Acta Metall.32 (1984) 1079.10.1016/0001-6160(84)90011-7Search in Google Scholar
11 Rösier, J. ; Arzt, E.:ibid. 38 (1990) 671.10.1016/0956-7151(90)90223-4Search in Google Scholar
12 Arzt, E.; Rösier, J., in: Y.W. Kim and W.M. Griffith (eds.), Dispersion Strengthened Aluminium Alloys, TMS, Warrendale, PA (1988).Search in Google Scholar
13 Stephens, J.J.; Romero, J.A.; Hills, C.R., in: H.J. Cialoni, M.E. Blum, G.W.E. Johnson and G.F. Vandervoort (eds.), Micro structural Science, Vol. 16, International Metallographic Society, Columbus, OH and ASM International, Metals Park, OH (1988) 245.Search in Google Scholar
14 Nadkarni, A.V.; Klar,E.; Shafer,W.M.:Met. Eng. Q., August (1976) 10.Search in Google Scholar
15 Conrad, H.:J. Metals16(1964) 582.10.1007/BF03378292Search in Google Scholar
16 Jonas, J.J.; Luton,M.J.:Advances in Deformation Processing, Plenum Press, New York (1974) 215.Search in Google Scholar
17 Weiss, I.; Jonas, J.J.:Metall. Trans., A11(1980) 215.10.1007/BF02668404Search in Google Scholar
18 Chandra, T.; Weiss, I.; Jonas, J.J.:Met. Sci. J. 16 (1982) 97.10.1179/msc.1982.16.2.97Search in Google Scholar
19 Chandra, T.; Weiss, I.; Jonas, J.J.:Canad. Metall. Q. 20(1981) 421.10.1179/cmq.1981.20.4.421Search in Google Scholar
20 Gill Sevillano, J. ; Houtte, P.V. ; Aernoudt, E. :Progr. Mater. Sci.25(1981)61.Search in Google Scholar
21 Jonas, J.J.; Semiatin, S.L.:Formability and Workability of Metals: Plastic Instability and Flow Localization, ASM, Metals Park, OH (1984) 43.Search in Google Scholar
22 Semiatin, S.L.; Oh, S.I.; Jonas, J.J.:Metall. Trans., A23(1992) 963.10.1007/BF02675571Search in Google Scholar
23 Aernoudt, E.; Garvin-Salazar, R.; Houtte, P.V.; Follon, M.; Neut jens, P.; in: P. Ramakrishnaan (ed.), Powder Metallurgy and Related High Temperature Materials, Trans Tech Publications, Aerdermannsdorf (1987) 373.Search in Google Scholar
24 Kimmel,E.R.; Peterson, L.G.; Queeney, R.A.:Thermomechanical Processing of Oxide Dispersion-strengthened Copper, The International Copper Research Association, New York, January (1971).Search in Google Scholar
25 Guyot, P., in: H.H. Hausner (ed.), Modern Developments in Powder Metallurgy, Vol. 2Plenum Press, New York (1966) 112.10.1007/978-1-4684-7882-2_8Search in Google Scholar
© 2001 Carl Hanser Verlag, München
Articles in the same Issue
- Frontmatter
- Editorial
- Günter Lange 65 Years
- Aufsätze/Articles
- Deformation and Microstructure of Titanium Chips and Workpiece
- Eigenspannungsabbau in zügig und zyklisch beanspruchten Schweißverbindungen
- Bruchmechanische Nachweise zur Stahlgütewahl für moderne Feinkornbaustähle
- Experimental Analysis of the Interaction of “Hot” and “Cold” Volume Elements during Thermal Fatigue of a Cooled Component Made from AISI 3161 Steel
- Microstructure and Cyclic Deformation Behavior of Wheel and Tire Steels in Technically Relevant Heat Treatments
- Dehnratenabhängige Beschreibung der Fließkurven für erhoöhte Temperaturen
- Ein einfaches Modell für die Kinetik der Rekristallisation
- Determination of the Elastic Modulus of Wear Resistant Coatings by Quantitative Acoustic Microscopy
- Processing, Microstructure and Properties of Nb–TiO2 ODS Materials for Surgical Implants
- Influence of Surface Treatment on the Pitting Corrosion Behaviour of High Alloyed Stainless Steels in a Chloride Solution
- Unfall durch Drahtseilriss in einer Tunnelbaustelle
- Synthesis of Nanocrystalline B2 Structured (Ru, Ir) Al in the Ternary Ru–Al–Ir System by Mechanical Alloying and its Thermal Stability
- Preparation of Ca-α-sialon Ceramics with Compositions along the Si3N4-1/2 Ca3N2:3AIN Line
- SiC–Si3N4 Nanocomposite Prepared by the Addition of SiO2 + C
- Ceramics in the Si3N4–ZrO2–CeO2 System: Phase Composition Changes and Properties
- The Al–Ca System, Part 1: Experimental Investigation of Phase Equilibria and Crystal Structures
- The Al–Ca System, Part 2: Calorimetrie Measurements and Thermodynamic Assessment
- Phase Relationships of the Gd-Zn System
- Ableitung des Kristallisationspfades in ternären Gusslegierungen
- Bildanalyse komplexer Werkstoffgefüge durch Texturanalyse und Korrelation mit den Eigenschaften durch neuronale Netze
- Grain Growth in the Nanocrystalline W–Cu and Cu–Pb Composite Powders Prepared by Mechanical Alloying
- Toughening and Strengthening Response in Ni3Al-Bonded Titanium Carbide Cermets
- Creep Behavior of γ-TiAl-Based Alloys with Fully Lamellar Microstore
- Elevated Temperature Deformation of P/M Dispersion - Strengthened Copper and Aluminium
- Evolution of the Microstructure during Hot Working of Gamma-Based TiAl Alloys
- Interface Motion of β-Silicon Nitride in a Liquid Phase
- Internal Friction and Creep of Titanium Aluminides with Different Microstructure
- Mitteilungen/Notifications
- Personen
- Conferences
Articles in the same Issue
- Frontmatter
- Editorial
- Günter Lange 65 Years
- Aufsätze/Articles
- Deformation and Microstructure of Titanium Chips and Workpiece
- Eigenspannungsabbau in zügig und zyklisch beanspruchten Schweißverbindungen
- Bruchmechanische Nachweise zur Stahlgütewahl für moderne Feinkornbaustähle
- Experimental Analysis of the Interaction of “Hot” and “Cold” Volume Elements during Thermal Fatigue of a Cooled Component Made from AISI 3161 Steel
- Microstructure and Cyclic Deformation Behavior of Wheel and Tire Steels in Technically Relevant Heat Treatments
- Dehnratenabhängige Beschreibung der Fließkurven für erhoöhte Temperaturen
- Ein einfaches Modell für die Kinetik der Rekristallisation
- Determination of the Elastic Modulus of Wear Resistant Coatings by Quantitative Acoustic Microscopy
- Processing, Microstructure and Properties of Nb–TiO2 ODS Materials for Surgical Implants
- Influence of Surface Treatment on the Pitting Corrosion Behaviour of High Alloyed Stainless Steels in a Chloride Solution
- Unfall durch Drahtseilriss in einer Tunnelbaustelle
- Synthesis of Nanocrystalline B2 Structured (Ru, Ir) Al in the Ternary Ru–Al–Ir System by Mechanical Alloying and its Thermal Stability
- Preparation of Ca-α-sialon Ceramics with Compositions along the Si3N4-1/2 Ca3N2:3AIN Line
- SiC–Si3N4 Nanocomposite Prepared by the Addition of SiO2 + C
- Ceramics in the Si3N4–ZrO2–CeO2 System: Phase Composition Changes and Properties
- The Al–Ca System, Part 1: Experimental Investigation of Phase Equilibria and Crystal Structures
- The Al–Ca System, Part 2: Calorimetrie Measurements and Thermodynamic Assessment
- Phase Relationships of the Gd-Zn System
- Ableitung des Kristallisationspfades in ternären Gusslegierungen
- Bildanalyse komplexer Werkstoffgefüge durch Texturanalyse und Korrelation mit den Eigenschaften durch neuronale Netze
- Grain Growth in the Nanocrystalline W–Cu and Cu–Pb Composite Powders Prepared by Mechanical Alloying
- Toughening and Strengthening Response in Ni3Al-Bonded Titanium Carbide Cermets
- Creep Behavior of γ-TiAl-Based Alloys with Fully Lamellar Microstore
- Elevated Temperature Deformation of P/M Dispersion - Strengthened Copper and Aluminium
- Evolution of the Microstructure during Hot Working of Gamma-Based TiAl Alloys
- Interface Motion of β-Silicon Nitride in a Liquid Phase
- Internal Friction and Creep of Titanium Aluminides with Different Microstructure
- Mitteilungen/Notifications
- Personen
- Conferences
