Determination of the Elastic Modulus of Wear Resistant Coatings by Quantitative Acoustic Microscopy
-
Hermann Vetters
,
Ellen Matthaei-Schulz
Abstract
For the quality assessment of coatings there is an increasing need of test methods which are able to fulfil the requirements to a high reliability of the test results. The exact knowledge of the coating properties and their objective assessment helps the coating industry for an optimum coating development as well as the user which will use the coated parts under a specific purpose. As part of an European project four laboratories deal with the determination of elastic moduli of hard coatings by means of quantitative acoustic microscopy. On titanium nitride coatings and C doped chromium coatings on M2 tool steel basic and continuing research studies were accomplished, guidelines have been developed and proofed in round-robin tests.
References
1 Vetters, H.R.; Schulz, A.; Mayr, P.; Saunders, S.R.J.: Surf. Coat. Technol. 86–87 (1996) 345.10.1016/S0257-8972(96)02989-1Search in Google Scholar
2 Development and Validation of Test Methods for Thin Hard Coatings (FASTE); project within the SM&T programme of the European Commission; 1994–1997, Contract No. Mat 1 Ct 940045.Search in Google Scholar
3 Matthaei-Schulz, E., in: H.-J. Hunger (éd.), Werkstoffanalytische Verfahren, Deutscher Verlag fur Grundstoffmdustrie, Leipzig (1995) 430.Search in Google Scholar
4 Laing, K.; Hampshire, J.; Teer, D.; Chester, G.: Surf. Coat. Technol. 112 (1999) 177.10.1016/S0257-8972(98)00790-7Search in Google Scholar
5 Vetters, H, in: H.-J. Hunger (éd.), Werkstoffanalytische Verfahren, Deutscher Verlag für Grundstoffmdustrie, Leipzig (1995) 409.Search in Google Scholar
6 Briggs, G.A.D.; Rowe, J.M.; Sinton, A.M.; Spencer, D.S.: Ultrasonics Symposium (1988) 743.Search in Google Scholar
7 Lefeuvre, O.; Zinin, P.; Every, A.G; Briggs, G.A.D.: Appl. Phys. Lett. 72 (1998) 856.10.1063/1.120916Search in Google Scholar
8 Robert, L; Brunei, N.; Flaherty, T; Randies, T; Matthaei-Schulz, E; Vetters, H; Rats, D.; von Stebut, J.: Surf. Coat. Technol. 116–119 (1999) 327.10.1016/S0257-8972(99)00316-3Search in Google Scholar
© 2001 Carl Hanser Verlag, München
Articles in the same Issue
- Frontmatter
- Editorial
- Günter Lange 65 Years
- Aufsätze/Articles
- Deformation and Microstructure of Titanium Chips and Workpiece
- Eigenspannungsabbau in zügig und zyklisch beanspruchten Schweißverbindungen
- Bruchmechanische Nachweise zur Stahlgütewahl für moderne Feinkornbaustähle
- Experimental Analysis of the Interaction of “Hot” and “Cold” Volume Elements during Thermal Fatigue of a Cooled Component Made from AISI 3161 Steel
- Microstructure and Cyclic Deformation Behavior of Wheel and Tire Steels in Technically Relevant Heat Treatments
- Dehnratenabhängige Beschreibung der Fließkurven für erhoöhte Temperaturen
- Ein einfaches Modell für die Kinetik der Rekristallisation
- Determination of the Elastic Modulus of Wear Resistant Coatings by Quantitative Acoustic Microscopy
- Processing, Microstructure and Properties of Nb–TiO2 ODS Materials for Surgical Implants
- Influence of Surface Treatment on the Pitting Corrosion Behaviour of High Alloyed Stainless Steels in a Chloride Solution
- Unfall durch Drahtseilriss in einer Tunnelbaustelle
- Synthesis of Nanocrystalline B2 Structured (Ru, Ir) Al in the Ternary Ru–Al–Ir System by Mechanical Alloying and its Thermal Stability
- Preparation of Ca-α-sialon Ceramics with Compositions along the Si3N4-1/2 Ca3N2:3AIN Line
- SiC–Si3N4 Nanocomposite Prepared by the Addition of SiO2 + C
- Ceramics in the Si3N4–ZrO2–CeO2 System: Phase Composition Changes and Properties
- The Al–Ca System, Part 1: Experimental Investigation of Phase Equilibria and Crystal Structures
- The Al–Ca System, Part 2: Calorimetrie Measurements and Thermodynamic Assessment
- Phase Relationships of the Gd-Zn System
- Ableitung des Kristallisationspfades in ternären Gusslegierungen
- Bildanalyse komplexer Werkstoffgefüge durch Texturanalyse und Korrelation mit den Eigenschaften durch neuronale Netze
- Grain Growth in the Nanocrystalline W–Cu and Cu–Pb Composite Powders Prepared by Mechanical Alloying
- Toughening and Strengthening Response in Ni3Al-Bonded Titanium Carbide Cermets
- Creep Behavior of γ-TiAl-Based Alloys with Fully Lamellar Microstore
- Elevated Temperature Deformation of P/M Dispersion - Strengthened Copper and Aluminium
- Evolution of the Microstructure during Hot Working of Gamma-Based TiAl Alloys
- Interface Motion of β-Silicon Nitride in a Liquid Phase
- Internal Friction and Creep of Titanium Aluminides with Different Microstructure
- Mitteilungen/Notifications
- Personen
- Conferences
Articles in the same Issue
- Frontmatter
- Editorial
- Günter Lange 65 Years
- Aufsätze/Articles
- Deformation and Microstructure of Titanium Chips and Workpiece
- Eigenspannungsabbau in zügig und zyklisch beanspruchten Schweißverbindungen
- Bruchmechanische Nachweise zur Stahlgütewahl für moderne Feinkornbaustähle
- Experimental Analysis of the Interaction of “Hot” and “Cold” Volume Elements during Thermal Fatigue of a Cooled Component Made from AISI 3161 Steel
- Microstructure and Cyclic Deformation Behavior of Wheel and Tire Steels in Technically Relevant Heat Treatments
- Dehnratenabhängige Beschreibung der Fließkurven für erhoöhte Temperaturen
- Ein einfaches Modell für die Kinetik der Rekristallisation
- Determination of the Elastic Modulus of Wear Resistant Coatings by Quantitative Acoustic Microscopy
- Processing, Microstructure and Properties of Nb–TiO2 ODS Materials for Surgical Implants
- Influence of Surface Treatment on the Pitting Corrosion Behaviour of High Alloyed Stainless Steels in a Chloride Solution
- Unfall durch Drahtseilriss in einer Tunnelbaustelle
- Synthesis of Nanocrystalline B2 Structured (Ru, Ir) Al in the Ternary Ru–Al–Ir System by Mechanical Alloying and its Thermal Stability
- Preparation of Ca-α-sialon Ceramics with Compositions along the Si3N4-1/2 Ca3N2:3AIN Line
- SiC–Si3N4 Nanocomposite Prepared by the Addition of SiO2 + C
- Ceramics in the Si3N4–ZrO2–CeO2 System: Phase Composition Changes and Properties
- The Al–Ca System, Part 1: Experimental Investigation of Phase Equilibria and Crystal Structures
- The Al–Ca System, Part 2: Calorimetrie Measurements and Thermodynamic Assessment
- Phase Relationships of the Gd-Zn System
- Ableitung des Kristallisationspfades in ternären Gusslegierungen
- Bildanalyse komplexer Werkstoffgefüge durch Texturanalyse und Korrelation mit den Eigenschaften durch neuronale Netze
- Grain Growth in the Nanocrystalline W–Cu and Cu–Pb Composite Powders Prepared by Mechanical Alloying
- Toughening and Strengthening Response in Ni3Al-Bonded Titanium Carbide Cermets
- Creep Behavior of γ-TiAl-Based Alloys with Fully Lamellar Microstore
- Elevated Temperature Deformation of P/M Dispersion - Strengthened Copper and Aluminium
- Evolution of the Microstructure during Hot Working of Gamma-Based TiAl Alloys
- Interface Motion of β-Silicon Nitride in a Liquid Phase
- Internal Friction and Creep of Titanium Aluminides with Different Microstructure
- Mitteilungen/Notifications
- Personen
- Conferences
