Article
Licensed
Unlicensed
Requires Authentication
Contents
Published/Copyright:
July 3, 2018
Published Online: 2018-07-03
Published in Print: 2018-02-02
© 2018, Carl Hanser Verlag, München
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Inhalt/Contents
- Contents
- Fachbeiträge/Technical Contributions
- SteBLife – A new short-time procedure for the calculation of S-N curves and failure probabilities
- Surface treatment for effective bonding in the sports industry
- Effect of different rotational speeds on mechanical and metallurgical properties of friction welded dissimilar steels
- Comparison of titanium and FGM dental implants with different coating types
- Weld quality and productivity of AISI 4140 steel welded by unpulsed and pulsed GMAW
- Corrosion behavior of Hastelloy® C–4® Ni–Cr–Mo–Fe alloys for coal gasification syngas plants
- Application of FactSage® thermodynamic modeling for predicting the ash transformation with temperatures under partial slagging entrained flow coal gasification condition
- Röntgen- und Neutronentomographie am knöchernen Innenohr der Bartenwale
- Partial repair of thermally sprayed and sealed corrosion protection – Organic coating material or thermal spraying?
- Experimental study on solidification of Cu(II)-contaminated soil using red mud with cement and Ca(OH)2
- Tribological study of sintered iron based and copper based brake materials by pin-on-disc method
- Influence of drilling parameters on temperature and surface roughness of AISI O2 steel
- Multi-fractal characteristics of particle size distribution of granular backfilling materials under different loads
- Dry sliding behavior of aluminum alloy 8011 with 4 % fly ash
- Optimization of the milling parameters for an Al/Si3N4 functionally graded composite using grey relational analysis
Articles in the same Issue
- Inhalt/Contents
- Contents
- Fachbeiträge/Technical Contributions
- SteBLife – A new short-time procedure for the calculation of S-N curves and failure probabilities
- Surface treatment for effective bonding in the sports industry
- Effect of different rotational speeds on mechanical and metallurgical properties of friction welded dissimilar steels
- Comparison of titanium and FGM dental implants with different coating types
- Weld quality and productivity of AISI 4140 steel welded by unpulsed and pulsed GMAW
- Corrosion behavior of Hastelloy® C–4® Ni–Cr–Mo–Fe alloys for coal gasification syngas plants
- Application of FactSage® thermodynamic modeling for predicting the ash transformation with temperatures under partial slagging entrained flow coal gasification condition
- Röntgen- und Neutronentomographie am knöchernen Innenohr der Bartenwale
- Partial repair of thermally sprayed and sealed corrosion protection – Organic coating material or thermal spraying?
- Experimental study on solidification of Cu(II)-contaminated soil using red mud with cement and Ca(OH)2
- Tribological study of sintered iron based and copper based brake materials by pin-on-disc method
- Influence of drilling parameters on temperature and surface roughness of AISI O2 steel
- Multi-fractal characteristics of particle size distribution of granular backfilling materials under different loads
- Dry sliding behavior of aluminum alloy 8011 with 4 % fly ash
- Optimization of the milling parameters for an Al/Si3N4 functionally graded composite using grey relational analysis
