PPS news

Artikel in diesem Heft

1. Contents
2. Regular Contributed Articles
3. An Improvement on Design of Sheet Extrusion Dies
4. Organic-Inorganic Hybrid Material Synthesis by on Line Coupling Twin Screw Extruder with a Microwave Oven
5. Water Penetration Stability in Water Assisted Injection Molded Symmetric Ribs
6. A New Plasticating Model for Amorphous and Semi-crystalline Polymers in Single Screw Extruders
7. Simultaneous Biaxial Stretching of Polypropylene Resins of Varying Tacticity
8. Optimization of a Flat Die Including Elongational Viscosity Effects
9. Experimental Study on Factors Influencing Throughput Rate and Process of Polymer-Mineral Filler Mixing in a Twin Screw Extruder
10. 3D Finite Element Simulation of Processing of Generalized Newtonian Fluids in Counter-rotating and Tangential TSE and Die Combination
11. Simulation of Heat Transfer in Laser Transmission Welding
12. Influence of Power Law and Isothermal Simplification on the Accuracy in Single Screw Extrusion
13. Melt Intercalation in Montmorillonite/Polystyrene Nanocomposites
14. Experimental Investigation of the Effect of the Bubble Cone on the Cooling Jets used in the Blown Film Manufacturing Process
15. Molding of Thin Sheets Using Impact Micro-injection Molding
16. Rapid communications
17. Ultrasonic Vibration Hot Embossing
18. PPS news
19. PPS news
20. Seikei-kakou abstracts
21. Seikei-kakou abstracts