Startseite Thermal and chemical stability of Cr2AlC in contact with α-Al2O3 and NiAl
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

Thermal and chemical stability of Cr2AlC in contact with α-Al2O3 and NiAl

  • David E. Hajas , Mirjam Scholz , Sergey Ershov , Bengt Hallstedt , Jens-Petter Palmquist und Jochen M. Schneider
Veröffentlicht/Copyright: 11. Juni 2013
Veröffentlichen auch Sie bei De Gruyter Brill
Informationen für Autor*innen
International Journal of Materials Research
Aus der Zeitschrift International Journal of Materials Research Band 101 Heft 12

Abstract

The thermal and chemical stability of Cr2AlC, Cr2AlC–NiAl and Cr2AlC–α-Al2O3 have been studied. No enthalpic effects indicating phase transformations or chemical reactions were observed for the Cr2AlC–α-Al2O3 powder mixtures at T < 1476°C, while a melting onset temperature of 1310°C was measured for the Cr2AlC–NiAl powder mixture by differential thermal analysis. However, the formation of chromium carbide is also predicted to occur below this temperature based on our thermodynamic calculations, and was observed by X-ray diffraction of powders annealed at 1000 and 1300°C. The carbide formation is caused by the reaction of Cr2AlC with NiAl and can be understood by considering the large solid solution range of Al in NiAl. These results indicate that the application potential of Cr2AlC–NiAl composites is limited by the Al solubility in the NiAl.

Keywords: Cr < Al–C; Thermal stability; Differential thermal analysis
* Correspondence address, Prof. Jochen M. Schneider, Ph.D., Materials Chemistry, RWTH Aachen University, Mies-van-der-Rohe-Str. 20, D-52074 Aachen, Germany. Tel.: +49 241 8025967, Fax: +49 241 8022295. E-mail:

References

[1] W.Jeitschko, H.Nowotny, F.Benesovsky: Monatshefte Chem.94 (1963) 672.10.1007/BF00913068Suche in Google Scholar

[2] M.W.Barsoum: Prog. Solid State Chem.28 (2001) 201.10.1016/S0079-6786(00)00006-6Suche in Google Scholar

[3] M.W.Barsoum, T.El-Raghy: J. Am. Ceram. Soc.79 (1996) 1953.10.1111/j.1151-2916.1996.tb08018.xSuche in Google Scholar

[4] M.W.Barsoum, T.El-Raghy: J. Electrochem. Soc.144 (1997) 2508.10.1149/1.1837846Suche in Google Scholar

[5] T.El-Raghy, M.W.Barsoum, A.Zavaliangos, S.R.Kalidini: J. Am. Ceram. Soc.82 (1999) 2855.10.1111/j.1151-2916.1999.tb02167.xSuche in Google Scholar

[6] J.D.Hettinger, S.E.Lofland, P.Finkel, T.Meehan, J.Palma, K.Harrell, S.Gupta, A.Ganguly, T.El-Raghy, M.W.Barsoum: Phys. Rev. B72 (2005) 115120.10.1103/PhysRevB.72.115120Suche in Google Scholar

[7] D.Music, A.Houben, R.Dronskowski, J.M.Schneider: Phys. Rev. B75 (2007) 174102.10.1103/PhysRevB.75.174102Suche in Google Scholar

[8] J.M.Schneider, D.P.Sigumonrong, D.Music, C.Walter, J.Emmerlich, R.Iskandar, J.Mayer: Scripta Mater.57 (2007) 1137.10.1016/j.scriptamat.2007.08.006Suche in Google Scholar

[9] Z.J.Lin, M.S.Li, J.Y.Wang, Y.C.Zhou: Acta Mater.55 (2007) 6182.10.1016/j.actamat.2007.07.024Suche in Google Scholar

[10] W.Tian, P.Wang, Y.Kan, G.Zhang: J. Mater. Sci.43 (2008) 2785.10.1007/s10853-008-2516-2Suche in Google Scholar

[11] S.E.Lofland, J.D.Hettinger, K.Harrell, P.Finkel, S.Gupta, M.W.Barsoum, G.Hug: Appl. Phys. Lett.84 (2004) 508.10.1063/1.1641177Suche in Google Scholar

[12] J.M.Schneider, Z.Sun, R.Mertens, F.UestelR.Ahuja: Solid State Commun.130 (2004) 445.10.1016/j.ssc.2004.02.047Suche in Google Scholar

[13] R.Mertens. Z.Sun, D.Music, J.M.Schneider: Adv. Eng. Mater.6 (2004) 903.10.1002/adem.200400096Suche in Google Scholar

[14] D.T.Wan, Y.C.Zhou, Y.W.Bao, L.Z.Liu: J. Am. Ceram. Soc.90 (2007) 553.10.1111/j.1551-2916.2006.01448.xSuche in Google Scholar

[15] D.T.Wan, C.F.Hu, Y.W.Bao, Y.C.Zhou: Wear262 (2007) 826.Suche in Google Scholar

[16] S.L.Draper, I.E.Locci: J. Mater. Res.9 (1994) 1397.10.1557/JMR.1994.1397Suche in Google Scholar

[17] J.B.Davis, J.Yang, A.G.Evans: Acta Metall. Mater.43 (1995) 259.Suche in Google Scholar

[18] D.E.Hajas, S.Kyrsta, J.M.Schneider: Scripta Mater.55 (2006) 219.10.1016/j.scriptamat.2006.04.011Suche in Google Scholar

[19] W.Hu, T.Weirich, B.Hallstedt, H.Chen, Y.Zhong, G.Gottstein: Acta Mater.54 (2006) 2473.10.1016/j.actamat.2006.01.032Suche in Google Scholar

[20] D.Music, Z.Sun, A.A.Voevodin, J.M.Schneider: Solid State Commun139 (2006) 139.10.1016/j.ssc.2006.06.007Suche in Google Scholar

[21] B.Hallstedt, D.Music, Z.Sun: Int. J. Mater. Res.97 (2006) 539.Suche in Google Scholar

[22] B.Hallstedt: J. Phase Equilib.14 (1993) 662.10.1007/BF02667878Suche in Google Scholar

[23] E.Povoden, A.N.Grundy, L.J.Gauckler: J. Phase Equilib. Diffus.27 (2006) 353.Suche in Google Scholar

[24] N.Dupin, I.AnsaraB.Sundman: Calphad25 (2001) 279.10.1016/S0364-5916(01)00049-9Suche in Google Scholar

[25] B.J.Lee: Calphad16 (1992) 121.10.1016/0364-5916(92)90002-FSuche in Google Scholar

[26] H.Ohtani, M.Yamano, M.Hasebe: Calphad28 (2004) 177.10.1016/j.calphad.2004.08.003Suche in Google Scholar

[27] L.L.Oden, N.A.Gokcen: Metall. Mater. Trans. A28 (1997) 2453.10.1007/s11661-997-0002-0Suche in Google Scholar

[28] Y.Kimura, K.Lida, F.-G.Wei, Y.Mishima: Intermetallics14 (2006) 508.10.1016/j.intermet.2005.09.004Suche in Google Scholar

Received: 2009-12-2
Accepted: 2010-10-4
Published Online: 2013-06-11
Published in Print: 2010-12-01

© 2010, Carl Hanser Verlag, München

Artikel in diesem Heft

  1. Basic
  2. High-temperature in-situ microscopy during stress-induced phase transformations in Co49Ni21Ga30 shape memory alloy single crystals
  3. Contents
  4. contents
  5. Editorial
  6. Editorial December 2010
  7. Basic
  8. Atomic mobilities and diffusivities in the fcc, L12 and B2 phases of the Ni-Al system
  9. Experimental investigation of the Zn–Fe–V system at 450°C
  10. Time resolved X-ray imaging of eutectic cellular patterns evolving during solidification of ternary Al–Cu–Ag alloys
  11. Reassessment of the Mg–Ge binary system using CALPHAD supported by first-principles calculation
  12. A quantitative modeling of the unloading behavior of metals during a tensile test
  13. A technique for diameter enlargement in SiC crystal growth
  14. Applied
  15. Thermal and chemical stability of Cr2AlC in contact with α-Al2O3 and NiAl
  16. Microstructure and mechanical properties of Zn25Al3Cu based composites with large Al2O3 particles at room and elevated temperatures
  17. An investigation on Incoloy800-SS304 clad plate by explosive welding
  18. Effect of grain boundary precipitates on vibration damping of FeüCrüMgüAl/Si alloy
  19. Adsorption of metal ions on magnetic carbon nanomaterials bearing chitosan-functionalized silica
  20. Tensile and in-vitro degradation study of electro spun fibrous mat produced from eri silk fibroin
  21. Study of the influence of UV-irradiation on the photodegradation of plasticized poly(para-tert-butylstyrene) films
  22. Enhanced photocatalytic activity of beryllium doped titania in visible light on the degradation of methyl orange dye
  23. Progress in chemistry modelling for vapour and aerosol transport analyses
  24. DGM News
  25. Personal
https://doi.org/10.3139/146.110439
Schlagwörter für diesen Artikel
Cr < Al–C; Thermal stability; Differential thermal analysis

Artikel in diesem Heft

  1. Basic
  2. High-temperature in-situ microscopy during stress-induced phase transformations in Co49Ni21Ga30 shape memory alloy single crystals
  3. Contents
  4. contents
  5. Editorial
  6. Editorial December 2010
  7. Basic
  8. Atomic mobilities and diffusivities in the fcc, L12 and B2 phases of the Ni-Al system
  9. Experimental investigation of the Zn–Fe–V system at 450°C
  10. Time resolved X-ray imaging of eutectic cellular patterns evolving during solidification of ternary Al–Cu–Ag alloys
  11. Reassessment of the Mg–Ge binary system using CALPHAD supported by first-principles calculation
  12. A quantitative modeling of the unloading behavior of metals during a tensile test
  13. A technique for diameter enlargement in SiC crystal growth
  14. Applied
  15. Thermal and chemical stability of Cr2AlC in contact with α-Al2O3 and NiAl
  16. Microstructure and mechanical properties of Zn25Al3Cu based composites with large Al2O3 particles at room and elevated temperatures
  17. An investigation on Incoloy800-SS304 clad plate by explosive welding
  18. Effect of grain boundary precipitates on vibration damping of FeüCrüMgüAl/Si alloy
  19. Adsorption of metal ions on magnetic carbon nanomaterials bearing chitosan-functionalized silica
  20. Tensile and in-vitro degradation study of electro spun fibrous mat produced from eri silk fibroin
  21. Study of the influence of UV-irradiation on the photodegradation of plasticized poly(para-tert-butylstyrene) films
  22. Enhanced photocatalytic activity of beryllium doped titania in visible light on the degradation of methyl orange dye
  23. Progress in chemistry modelling for vapour and aerosol transport analyses
  24. DGM News
  25. Personal
Jetzt anmelden und 20% sparen
Institutioneller Zugang
Wie funktioniert Authentifizierung?
Haben Sie eine Idee, wie wir unsere Website verbessern können?
Bitte schreiben Sie uns.
© 2025 De Gruyter Brill
Heruntergeladen am 16.11.2025 von https://www.degruyterbrill.com/document/doi/10.3139/146.110439/html
Button zum nach oben scrollen