Contents

Articles in the same Issue

1. Contents
2. Contents
3. Basic
4. Microcracks in superalloys: From local in-situ measurements to lifetime prediction
5. Residual stress development due to thermal cycling of the particle-reinforced alloy EN AW-6061– experiment and simulation
6. Analysis of defect configurations with positron lifetime measurements by pulsed low energy beams
7. The nature of the TRIP-effect in metastable austenitic steels
8. Investigation and modelling of theplasticity-induced martensite formation in metastable austenites
9. Thermal relaxation of residual stresses in TiN films deposited by arc ion plating
10. On the Hall–Petch relation between flow stress and grain size
11. Polymer-derived Si–C–N ceramics reinforced by single-wall carbon nanotubes
12. Applied
13. Strengthening of silicon nitride ceramics by shot peening
14. Assessment of creep behaviour of the die-cast cylinder-head alloy AlSi6Cu4-T6
15. New aspects of bending rotation fatigue in ultra-fine-grained pseudo-elastic NiTi wires
16. Anwendung des lokalen Dauerfestigkeitskonzepts zur Bewertung der Wirksamkeit von Schweißnahtnachbehandlungsmaßnahmen
17. Investigation of the thermoelastic response of long-fibre reinforced thermoplasticsby comparison with different non-contactstrain measurement techniques
18. Effect of surface roughening on increasingthe spectral selectivity of cermet solarselective absorbers
19. Experimental observations on thecorrelation between microstructure andfracture of multiphase steels
20. Pressure solidification – a novel moulding technique for plastic parts with superior dimensional stability
21. DGM News
22. DGM News