On the estimation of cyclic material properties – Part 2: Introduction of a new estimation method

Articles in the same Issue

1. Inhalt/Contents
2. Contents
3. Laudatio
4. Professor Dr.-Ing. Harald Zenner: on the occasion of his eightieth birthday
5. Fachbeiträge/Technical Contributions
6. Fatigue life curve – A continuous Wöhler curve from LCF to VHCF
7. On the accuracy of estimating fatigue notch factors
8. Analytical strength assessments of austempered ductile iron components
9. On the estimation of cyclic material properties – Part 1: Quality of known estimation methods
10. On the estimation of cyclic material properties – Part 2: Introduction of a new estimation method
11. Execution and evaluation of cyclic tests at constant load amplitudes – DIN 50100:2016
12. Wear resistance of laser cladded Stellite 31 coating on AISI 316L steel
13. Determination of the Johnson-Cook damage parameter D₄ by Charpy impact testing
14. Effect of residual Alclad on friction stir spot welds of AA2219 alloys
15. Effect of cooling rate on microstructure, mechanical properties and residual stress of 7075 aluminum alloy
16. Failure analysis of an adhesively joined composite pipe system under internal pressure
17. Non-metallic inclusions and fatigue strength of steel 34CrNiMo6
18. Untersuchungen des Schädigungsgrades von Polyethylenformstoffen als Werkstoffe von Heizöllagerbehältern nach einer Nutzungsdauer von über 30 Jahren
19. Microstructure and mechanical properties of AZ31 Mg alloy produced by a new compound extrusion technique
20. Failure analysis of a cracked Q125 casing for ultra-deep wells at the Tarim Oilfield