Contents

Artikel in diesem Heft

1. Contents
2. Contents
3. Regular Contributed Articles
4. The Dynamic Apparent Viscosity of Polymer Melts During Pulsatile Extrusion Flow with Vibration Force Field
5. Generation of Microcellular Foams by Supercritical Carbon Dioxidein a PMMA Compound
6. Influence of Uniaxial Extension on the Mechanical Properties of PET and PEN Films
7. Analysis of the Isothermal Compression in Nanoimprint Lithography Assuming a Power-Law Fluid
8. Non-Isothermal Simulation of the Film Blowing Process Using Multi-Mode Extended Pom-Pom Model
9. Flow Analysis of Flat Spiral Dies and Comparison with Cylindrical Spiral Mandrel Dies
10. Development of Polymer Blend Morphology along an Extruder with Different Screw Geometries
11. A Mechanical Model for Stress Developmentin PA12 Tube Extrusion
12. Shrinkage Analysis on Convex Shellby Injection Molding
13. Melting Mechanism of Thermoplastic Elastomers and Comparison to Polyolefin Thermoplastic Melting Studies in a Single Screw Extruder
14. Thermal Degradation of Meta- and Para-Aramid Fibers in Different Atmospheres
15. Experimental Studies on Screw Characteristics in Closely Intermeshing Counter-rotating Twin Screw Extruder
16. Experimental Analysis of Heat Transfer in Rotational Molding Process
17. Polyetheretherketone Films with Low Thermal Expansion for Flexible Printed Circuit Boards
18. Experimental Study and Modeling of Flow Behavior and Orientation Kinetics of Layered Silicate/Polypropylene Nanocomposites in Start-up of Shear Flows
19. Polystyrene/Phosphonium Organoclay Nanocomposites by Melt Compounding
20. PPS News
21. PPS News
22. Seikei-Kakou Abstracts
23. Seikei-Kakou Abstracts