PPS News

Artikel in diesem Heft

1. Contents
2. Contents
3. Regular Contributed Articles
4. Pressure and Temperature Dependence of LDPE Viscosity and Free Volume: The Effect of Molecular Structure
5. Correlations between Injection Molding Parameters, Morphology and Mechanical Properties of PPS Using Artificial Neural Networks
6. Investigations into Kinematic Reversal in Non-isothermal Flows in Single-screw Machines
7. The Effect of Post-extrusion Conditions in Ribbon Extrusion of Polymer Blends
8. Effect of the Chemical and Morphological Conditions of the Die Wall on the Extrusion of Linear Polyolefins
9. Investigation of the Heat Affected Zone of Hot-gas Welded PP Joints
10. Method for the Optimisation of Screw Elements for Tightly Intermeshing, Co-rotating Twin Screw Extruders
11. Rheology and Processing of Molten Poly(methyl methacrylate) Resins
12. PLLA Morphology Controlled by Dry-cast Process
13. Two Component Injection Molding of Phase Separating Blends
14. A Low Force Valve for Dynamic Control of Molten Plastics in a Mold
15. Influence of Drawing and Temperature on the Optical and Structural Properties of Monofilament PP Sutures
16. Mechanical Properties of Rubber-toughened Post-industrial Glass-fiber-reinforced PA66
17. Thermal Flow Instability in Metal Injection Molding: Experiment and Simulation
18. Review Paper
19. State of the Art: Recycling of EPDM Rubber Vulcanizates
20. PPS News
21. PPS News
22. Seikei-Kakou Abstracts
23. Seikei-Kakou Abstracts