Seikei-Kakou Abstracts

Artikel in diesem Heft

1. Contents
2. Contents
3. Regular Contributed Articles
4. Influence of Melt-Mixing Process Conditions on Mechanical Performance of Organoclay/Fluoroelastomer Nanocomposites
5. Melt Creep Recovery of Polyamide 6 and Polypropylene Nanocomposites Blended with Layered Silicate
6. Dielectric Behavior of OPEFB Reinforced Polycaprolactone Composites at X-Band Frequency
7. Numerical Modeling of Bubble Growth in Microcellular Polypropylene Produced in a Core-Back Injection Process Using Chemical Blowing Agents
8. Numerical Simulation and Experimental Validation of Granite Powder Filled Jute Epoxy Composite for Slurry Jet Erosive Wear
9. Rheological Modeling of Polymeric Melts in Extruders upon Two-Dimensional Shear Flow
10. Experimental Investigation on Curing Stress in Polymer Composite Using Digital Gradient Sensing Technique
11. Experimental and Numerical Investigation of Shrinkage and Warpage of a U-Shaped Injection Molded Part
12. Modeling for Starve Fed/Flood Fed Mixing Single-Screw Extruders
13. The Comparative Study of Different Mixing Methods for Microcrystalline Cellulose/Polyethylene Composites
14. Fabrication of Superhydrophobic Polyethylene Parts by Rotomolding
15. Numerical Simulation of Chaotic Mixing in Single Screw Extruders with Different Baffle Heights
16. PPS News
17. PPS News
18. Seikei Kakou Abstracts
19. Seikei-Kakou Abstracts