Contents

Artikel in diesem Heft

1. Contents
2. Contents
3. Regular Contributed Articles
4. Converging-Diverging Flow in a Novel Extruder and its Application in Film Blowing
5. Modeling of Plasticating Injection Molding – Experimental Assessment
6. Viscosity Analysis of a Polymer-Based Drug Delivery System Using Open-Source CFD Methods and High-Pressure Capillary Rheometry
7. Thermal Properties and Morphology Characteristics of a PP Mono-Filament and its Foam
8. Thermal and Tensile Behavior of HD-PE Films Containing Iron (III) Acetylacetonate after UV Irradiation
9. Carbon Black Reinforced Thermoplastic Vulcanizates Based on High Impact Polystyrene/Styrene-Butadiene-Styrene Block Copolymer/Styrene-Butadiene Rubber Blends
10. A Study of the Bubbles in UV Micro Roll-to-Roll Imprinting
11. An Annular Rotating-Die Technique in Extrusion Process: Effect of Mandrel Rotating Speed on Extrudate Swell Behavior of HDPE Parison
12. Investigation of the Structural Robustness of Deep Depth Injection Mold with Cavity Pressure and Mold Design
13. Verifying the Melting Behavior in Single-Screw Plasticization Units Using a Novel Simulation Model and Experimental Method
14. Processing of Polyetherimide/Cloisite 30B Nanocomposite by Vibration Casting Method
15. Comparison between 1D and 3D Approaches for Twin-Screw Extrusion Simulation
16. Study on the Polymer Melt Flow in a Closely Intermeshing Counter-Rotating Twin Screw Extruder
17. The Influence of Moisture and Laminate Setup on the De-Consolidation Behavior of PA6/GF Thermoplastic Matrix Composites
18. PPS News
19. PPS News
20. Seikei Kakou Abstracts
21. Seikei Kakou Abstracts