Startseite Tribological performance and corrosion behavior of aluminum alloy protected by Cr-doped diamond-like carbon thin film
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

Tribological performance and corrosion behavior of aluminum alloy protected by Cr-doped diamond-like carbon thin film

  • Xiaoyu Yang , Hong Xu , Hongkui Mao , Gang Wang , Wei Liu , Wei Gao und Lideng Zhu
Veröffentlicht/Copyright: 17. Mai 2019
Veröffentlichen auch Sie bei De Gruyter Brill

Abstract

A gradient layer of Al/Cr diamond-like carbon film has been prepared by magnetron sputtering on 2024 Al-alloy. Emphasis has been placed on the anti-corrosion and tribological properties of the Cr-doped diamond-like film. Experimental research: scanning electron microscopy, X-ray photoelectron spectroscopy, Raman spectrometry, nano-indentation testing, potentiodynamic polarization, electrochemical impedance spectroscopy and tribological tests were undertaken to investigate the surface morphology, surface structures, chemical composition, anti-corrosion and mechanical properties of the as-prepared gradient diamond-like carbon film. The results indicated that the Cr-doped diamond-like carbon film with intermediate transition chromium layer showed improvements with regards to hardness and corrosion prevention due to the dense surface structure and decreased electrical conductivity. Cr-doped diamond-like carbon film also displayed excellent tribological properties such as a low friction coefficient and wear rate during tribological testing.


Correspondence address, Dr Xiaoyu Yang, Shandong Nuclear Power Equipment Manufacturing co., LTD, Shandong Province, Haiyang 265118, P.R. China, Tel: +86 86694901, Fax: +86 574 86685159, E-mail address:
∗∗ Professor Xu Hong, School of Materials Science and Engineering, North University of China, Shanxi Province, Taiyuan 030000, P.R. China, Tel: + 86 86694101, Fax: +86 574 86685159, E-mail address:

References

[1] J.X.Liao, L.F.Xia, M.R.Sun, Y.Sun, W.M.Liu, T.Xu, Q.J.Xue: Wear256 (2004) 840. 10.1016/s0043-1648(03)00521-0Suche in Google Scholar

[2] L.Guzman, G.Bonini, M.Adami, P.M.Ossi, A.Miotello, M.Vittori-Antisari, A.M.Serventi, E.Voltolini: Surf. Coat. Technol.83 (1996) 284. 10.1016/0257-8972(95)02795-5Suche in Google Scholar

[3] Y.Lifshitz: Diamond Relat. Mater.5 (1996) 388. 10.1016/0925-9635(95)00445-9Suche in Google Scholar

[4] Q.Ding, L.Wang, Y.Wang, S.C.Wang, L.Hu, Q.Xue: Tribol. Lett.41 (2010) 439. 10.1007/s11249-010-9730-1Suche in Google Scholar

[5] K.Y.Fu, Y.F.Mei, M.Y.Fu, X.Y.Liu, P.K.Chu: Diamond Relat. Mater.14 (2005) 1489. 10.1016/j.diamond.2005.03.006Suche in Google Scholar

[6] N.W.Khun, E.Liu: J. Nanosci. Nanotechnol.10 (2010) 4767. 21128496; 10.1166/jnn.2010.1682Suche in Google Scholar PubMed

[7] C.Donnet, J.Fontaine, A.Grill, T.L.Mognea: Tribol. Lett.9 (2000) 137. 10.1007/s11249-004-8077-xSuche in Google Scholar

[8] A.ErdemirU, O.L.Eryilmaz, I.B.Nilufer, G.R.Fenske: Surf. Coat. Technol.133–134 (2000) 448. 10.1016/S0257-9872(00)00968-3Suche in Google Scholar

[9] H.Ronkainen, S.Varjus, J.Koskinen, K.Holmberg: Wear249 (2001) 260. 10.1016/S0043-1648(01)00558-0Suche in Google Scholar

[10] Y.L.Su, W.H.Kao: J. Mater. Eng. Perform.9 (2000) 38. 10.1361/105994900770346268Suche in Google Scholar

[11] S.Aisenberg: J. Appl. Phys.42 (1971) 2953. 10.1063/1.1660654Suche in Google Scholar

[12] M.C.Polo, J.L.Andu′jara, A.Hartb, J.Robertson, W.I.Milne: Diamond Relat. Mater.9 (2000) 663. 10.1016/S0925-9635(99)00339-8Suche in Google Scholar

[13] M.Umeno, S.Adhikary: Diamond Relat. Mater.14 (2005) 1973. 10.1016/j.diamond.2005.09.030Suche in Google Scholar

[14] T.Mikami, H.Nakazawa, M.Kudo, M.Mashita: Thin Solid Films488 (2005) 87. 10.1016/j.tsf.2005.04.064Suche in Google Scholar

[15] A.Hu, I.Alkhesho, H.Zhou, W.W.Duley: Diamond Relat. Mater.16 (2007) 149. 10.1016/j.diamond.2006.04.008Suche in Google Scholar

[16] C.Srividya, S.V.Babu: Chem. Mater.8 (1996) 2528. 10.1021/cm9601594Suche in Google Scholar

[17] W.Dai, H.Zheng, G.Wu, A.Wang: Vacuum85 (2010) 231. 10.1016/j.vacuum.2010.06.001Suche in Google Scholar

[18] W.M.Silva, J.R.Carneiro, V.J.Trava-Airoldi: Diamond Relat. Mater.42 (2014) 58. 10.1016/j.diamond.2013.12.004Suche in Google Scholar

[19] C.Liu, D.Hu, J.Xu, D.Yang, M.Qi: Thin Solid Films496 (2006) 457. 10.1016/j.tsf.2005.09.109Suche in Google Scholar

[20] J.Robertson: Mater. Sci. Eng. R37 (2002) 129. 10.1016/S0927-796X(02)00005-0Suche in Google Scholar

[21] Y.Qi, E.Konca, A.T.Alpas: Surf. Sci.600 (2006) 2955. 10.1016/j.susc.2006.05.008Suche in Google Scholar

[22] G.W.Malaczynski, A.H.Hamdi, A.A.Elmoursi, X.Qiu: Surf. Coat. Technol.93 (1997) 280. 10.1016/S0257-8972(97)00061-3Suche in Google Scholar

[23] J.Ou, W.Hu, M.Xue, F.Wang, W.Li: ACS Appl. Mater. Interfaces5 (2013) 3101. 10.1021/am4000134Suche in Google Scholar PubMed

[24] L.Qin, W.Zhao, H.Hou, Y.Jin, Z.Zeng, X.Wu, Q.Xue: RSC Adv.4 (2014) 60307. 10.1039/c4ra10112jSuche in Google Scholar

[25] S.Viswanathan, L.Mohan, P.Bera, V.P.Kumar, H.C.Barshilia, C.Anandan: J. Mater. Eng. Perform.26 (2017) 3633. 10.1007/s11665-017-2783-7Suche in Google Scholar

[26] S.Gayathri, N.Kumar, R.Krishnan, T.R.Ravindran, S.Amirthapandian, S.Dash, A.K.Tyagi, M.Sridharan: Ceram. Int.41 (2015) 1797. 10.1016/j.ceramint.2014.09.125Suche in Google Scholar

[27] S.Gayathri, N.Kumar, R.Krishnan, T.R.Ravindran, S.Dash, A.K.Tyagi, M.Sridharan: Mater. Chem. Phy.167 (2015) 194. 10.1016/j.matchemphys.2015.10.031Suche in Google Scholar

[28] F.C.Tai, S.C.Lee, J.Chen, C.Wei, S.H.Chang: J. Raman Spectrosc.40 (2009) 1055. 10.1002/jrs.2234Suche in Google Scholar

[29] T.Benabbouha, M.Siniti, H. ElAttari, K.Chefira, F.Chibi, R.Nmila, H.Rchid: Journal of Bio- and Tribo-Corros.4 (2018). 10.1007/s40735-018-0161-0Suche in Google Scholar

[30] S.Viswanathan, L.Mohan, P.Bera, S.Shanthiswaroop, M.Muniprakash, H.C.Barshilia, C.Anandan: Surf. Interface Anal.50 (2018) 265. 10.1002/sia.6353Suche in Google Scholar

[31] C.Casiraghi, A.Ferrari, J.Robertson: Phys. Rev. B72 (2005). 10.1103/PhysRevB.72.085401Suche in Google Scholar

[32] J.Kovac, G.Scarel, M.Sancrotti, M.G.Beghi, C.E.Bottani, P.M.Ossi, L.Calliari, M.Bonelli, A.Miotello: J. Appl. Phys.86 (1999) 5566. 10.1063/1.371561Suche in Google Scholar

[33] B.Schultrich, H.-J.Scheibe, D.Drescher, H.Ziegele: Surf. Coat. Technol.98 (1998) 1097. 10.1016/S0257-8972(97)00386-1Suche in Google Scholar

[34] C.Wang, S.Yang, Q.Wang, Z.Wang, J.Zhang: J. Appl. Phys.103 (2008) 123531. 10.1063/1.2938747Suche in Google Scholar

[35] J.Ou, W.Hu, M.Xue, F.Wang, W.Li: ACS Appl. Mater. Interfaces5 (2013) 9867. 10.1021/am402303jSuche in Google Scholar PubMed

[36] V.Mišković-Stanković, I.Jevremović, I.Jung, K.Rhee: Carbon75 (2014) 335. 10.1016/j.carbon.2014.04.012Suche in Google Scholar

[37] S.V.Lamaka, M.L.Zheludkevich, K.A.Yasakau, R.Serra, S.Poznyak, M.Ferreira: Prog. Org. Coat.58 (2007) 127. 10.1016/j.porgcoat.2006.08.029Suche in Google Scholar

[38] M.L.Zheludkevich, R.Serra, M.F.Montemor, K.A.Yasakau, I.M.M.Salvado, M.G.S.Ferreira: Electrochim. Acta51 (2005) 208. 10.1016/j.electacta.2005.04.021Suche in Google Scholar

[39] M.Zamanzade, A.Barnoush: Corros. Sci.78 (2014) 223. 10.1016/j.corsci.2013.10.002Suche in Google Scholar

[40] T.L.Schmitz, J.E.Action, D.L.Burris, J.C.Ziegert, W.G.Sawyer: J. Tribol.126 (2004) 802. 10.1115/1.1792675Suche in Google Scholar

Received: 2018-03-06
Accepted: 2018-11-19
Published Online: 2019-05-17
Published in Print: 2019-05-15

© 2019, Carl Hanser Verlag, München

Artikel in diesem Heft

  1. Contents
  2. Contents
  3. Original Contributions
  4. Relationship between the variation in transformation temperatures, resistivity and dislocation density during thermal cycling of Ni50Ti50 shape memory alloy
  5. A critical analysis of the X-ray diffraction intensities in concentrated multicomponent alloys
  6. Thermodynamic investigations in the Al–Fe system: Thermodynamic modeling using CALPHAD
  7. Investigation of semi-solid microstructures of an A356 alloy containing rare-earth Gd during isothermal heat treatment
  8. Effects of double-ageing on the mechanical properties and microstructural evolution in the 1460 alloy
  9. Mechanical properties characterisation of AlSi10Mg parts produced by laser powder bed fusion additive manufacturing
  10. Tribological performance and corrosion behavior of aluminum alloy protected by Cr-doped diamond-like carbon thin film
  11. Effect of sintering temperature on the densification and optical properties of spark plasma sintered ZnSe ceramics
  12. Mono-crystalline SnTe with micro-octahedroncharacteristic: One-pot facile synthesis and comprehensive crystallographic evidence
  13. Finite element simulation of the residual stress in Ti6Al4V titanium alloy laser welded joint
  14. Short Communications
  15. Mechanism of the effect of electron beam melting on the distribution of oxygen, nitrogen and carbon in silicon
  16. Synthesis and study of structural, morphological, optical and toxicological properties of ferromagnetic cobalt oxide nanoparticles in liver carcinoma cell line
  17. DGM News
  18. DGM News
Heruntergeladen am 27.11.2025 von https://www.degruyterbrill.com/document/doi/10.3139/146.111764/html?lang=de
Button zum nach oben scrollen