Startseite Dynamic observation of twin evolution during austenite grain growth in an Fe–C–Mn–Si alloy
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

Dynamic observation of twin evolution during austenite grain growth in an Fe–C–Mn–Si alloy

  • Haijiang Hu , Guang Xu , Feng Liu , Li Wang , Lixin Zhou und Zhengliang Xue
Veröffentlicht/Copyright: 12. April 2014
Veröffentlichen auch Sie bei De Gruyter Brill
Informationen für Autor*innen
International Journal of Materials Research
Aus der Zeitschrift International Journal of Materials Research Band 105 Heft 4

Abstract

For the first time, investigation of twin evolution during austenite grain growth in an Fe–C–Mn–Si alloy was conducted with in-situ observation using high temperature laser scanning confocal microscopy during austenization. It was found that twins nucleated in austenite grains, some of which might disappear during isothermal holding, even as new twins might nucleate at grain boundaries. In addition, the effects of twins and austenite grains on bainite morphology were also examined. The twins can restrain the growth of bainite sheaves and smaller austenite grains result in shorter bainite laths. The investigation of dynamic evolution of twins and the analysis of the effect of austenite twins on bainite morphology can only be realized by means of in-situ observation.

Keywords: Austenite twin; Dynamic observation; Austenite grain; Bainite morphology
* Correspondence address, Dr. Prof. Guang Xu, Faculty of Materials and Metallurgy, Wuhan University of Science and Technology, Wuhan 430081, China, Tel.: +86-027-68862813, Fax: +86-027-68862807, E-mail:

References

[1] H.Carpenter, S.Tamura: Proc. R. Soc. A113 (1926) 161. 10.1098/rspa.1926.0144Suche in Google Scholar

[2] J.R.Cahoon, Q.Y.Li, N.L.Richards: Mater. Sci. Eng. A526 (2009) 56. 10.1016/j.msea.2009.07.021Suche in Google Scholar

[3] K.H.Song, Y.B.Chun, S.K.Hwang: Mater. Sci. Eng. A454–455 (2007) 629.Suche in Google Scholar

[4] W.C.Cheng, H.Y.Lin: Mater. Sci. Eng. A341 (2003) 106. 10.1016/S0921-5093(02)00211-3Suche in Google Scholar

[5] T.Baudin, A.L.Etter, R.Penelle: Mater. Charact.58 (2007) 947. 10.1016/j.matchar.2006.09.009Suche in Google Scholar

[6] J.Bystrzycki, W.Przetakiewicz, K.J.Kurzydłowski: Acta. Mater.41 (1993) 2639.10.1016/0956-7151(93)90133-DSuche in Google Scholar

[7] S.Mahajan: Scripta Mater.68 (2013) 95. 10.1016/j.scriptamat.2012.09.011Suche in Google Scholar

[8] Y.Zhang, N.R.Tao, K.Lu: Scripta Mater.60 (2009) 211. 10.1016/j.scriptamat.2008.10.005Suche in Google Scholar

[9] Y.Li, Y.H.Zhao, W.Liu, C.Xu, Z.Horita, X.Z.Liao, Y.T.Zhu, T.G.Langdon, E.J.Lavernia: Mater. Sci. Eng. A527 (2010) 3942. 10.1016/j.msea.2009.12.026Suche in Google Scholar

[10] D.P.Field, B.W.True, T.M.Lillo, J.E.Flinn: Mater. Sci. Eng. A372 (2004) 173. 10.1016/j.msea.2003.12.044Suche in Google Scholar

[11] S.H.Choi, E.J.Shin, B.S.Seong: Acta Mater.55 (2007) 4181. 10.1016/j.actamat.2006.09.006Suche in Google Scholar

[12] L.C.Zhang, J.G.Wang, G.L.Chen, G.Sauthoff: Mater. Lett.45 (2000) 320. 10.1016/S0167-577X(00)00082-3Suche in Google Scholar

[13] L.C.Zhang, G.L.Chen, H.Q.Ye: Mater. Sci. Eng. A299 (2001) 267. 10.1016/S0921-5093(00)01377-0Suche in Google Scholar

[14] S.Mahajan, C.S.Pande, M.A.Imam, B.B.Rath: Acta Mater45 (1997) 2633. 10.1016/S1359-6454(96)00336-9Suche in Google Scholar

[15] C.S.Pande, M.A.Imam, B.B.Rath: Met. Trans. A21A (1990) 2891. 10.1007/BF02647209Suche in Google Scholar

[16] C.S.Pande, M.A.Imam: Mater. Sci. Eng. A512 (2009) 82. 10.1016/j.msea.2009.01.030Suche in Google Scholar

[17] J.E.Burke: J. Metals188 (1950) 1324.10.1007/BF03399157Suche in Google Scholar

[18] R.L.Fullman, J.C.Fischer: J. Appl. Phys.22 (1951) 1350. 10.1063/1.1699865Suche in Google Scholar

[19] H.Gleiter: Acta Metall.17 (1969) 1421. 10.1016/0001-6160(69)90004-2Suche in Google Scholar

[20] G.Gindraux, W.J.Form: J. Inst. Metals101 (1973) 85.Suche in Google Scholar

[21] S.Dash, N.Brown: Acta Metall.11 (1963) 1067. 10.1016/0001-6160(63)90195-0Suche in Google Scholar

[22] M.A.Meyers, L.E.Murr: Acta Metall.26 (1978) 951. 10.1016/0001-6160(78)90046-9Suche in Google Scholar

[23] K.Fujiwara, K.Maeda, N.Usami, G.Sazaki, Y.Nose, K.Nakajima: Scripta Mater.57 (2007) 81. 10.1016/j.scriptamat.2007.03.052Suche in Google Scholar

[24] K.Kutsukake, T.Abe, N.Usami, K.Fujiwara, K.Morishita, K.Nakajima: Scripta Mater.65 (2011) 556. 10.1016/j.scriptamat.2011.06.028Suche in Google Scholar

[25] G.Xu, F.Liu, L.Wang, H.J.Hu: Scripta Mater.68 (2013) 833. 10.1016/j.scriptamat.2012.09.023Suche in Google Scholar

Received: 2013-10-21
Accepted: 2013-12-18
Published Online: 2014-04-12
Published in Print: 2014-04-14

© 2014, Carl Hanser Verlag, München

Artikel in diesem Heft

  1. Contents
  2. Contents
  3. Original Contributions
  4. Microstructure and residual stresses of laser remelted surfaces of a hot work tool steel
  5. Dynamic observation of twin evolution during austenite grain growth in an Fe–C–Mn–Si alloy
  6. Hot ductility behavior of Incoloy901 superalloy in the cast and wrought conditions
  7. The influence of aluminium intermediate layer in dissimilar friction welds
  8. Effect of TiO2 in aluminum matrix on workability behavior of powder metallurgy composites during cold upsetting
  9. Approach to evaluation of the overall strengthening and toughening effect of continuous fiber-reinforced ceramic matrix composites
  10. The effect of SiC/Al2O3 particles used during FSP on mechanical properties of AZ91 magnesium alloy
  11. Studies on salt fog corrosion behavior of friction stir welded AA7075–T651 aluminum alloy
  12. Evaluation of corrosion performance of two Mn-containing stainless steel alloys
  13. Carbothermal synthesis of β-SiC powders from silicon and SiO2-coated carbon powders
  14. Synthesis and application of TiO2 nanotubes in environmental pollutant removal
  15. Mechanical properties of polyvinyl alcohol sponge under different strain rates
  16. Short Communications
  17. Effects of Al2O3 phase composition on AlON powder synthesis via aluminothermic reduction and nitridation
  18. Atomic group rotation mechanism of {1013} twinning in HCP materials
  19. Self-propagation high-temperature sintering of the Ti–Al–C-diamond/BN system
  20. People
  21. The German Materials Society congratulates its long-time Managing Director Dr. Peter Paul Schepp on the occasion of his 65th birthday
  22. Dr. Margarethe Hofmann-Amtenbrink on her 65th birthday
  23. DGM News
  24. DGM News
https://doi.org/10.3139/146.111037
Schlagwörter für diesen Artikel
Austenite twin; Dynamic observation; Austenite grain; Bainite morphology

Artikel in diesem Heft

  1. Contents
  2. Contents
  3. Original Contributions
  4. Microstructure and residual stresses of laser remelted surfaces of a hot work tool steel
  5. Dynamic observation of twin evolution during austenite grain growth in an Fe–C–Mn–Si alloy
  6. Hot ductility behavior of Incoloy901 superalloy in the cast and wrought conditions
  7. The influence of aluminium intermediate layer in dissimilar friction welds
  8. Effect of TiO2 in aluminum matrix on workability behavior of powder metallurgy composites during cold upsetting
  9. Approach to evaluation of the overall strengthening and toughening effect of continuous fiber-reinforced ceramic matrix composites
  10. The effect of SiC/Al2O3 particles used during FSP on mechanical properties of AZ91 magnesium alloy
  11. Studies on salt fog corrosion behavior of friction stir welded AA7075–T651 aluminum alloy
  12. Evaluation of corrosion performance of two Mn-containing stainless steel alloys
  13. Carbothermal synthesis of β-SiC powders from silicon and SiO2-coated carbon powders
  14. Synthesis and application of TiO2 nanotubes in environmental pollutant removal
  15. Mechanical properties of polyvinyl alcohol sponge under different strain rates
  16. Short Communications
  17. Effects of Al2O3 phase composition on AlON powder synthesis via aluminothermic reduction and nitridation
  18. Atomic group rotation mechanism of {1013} twinning in HCP materials
  19. Self-propagation high-temperature sintering of the Ti–Al–C-diamond/BN system
  20. People
  21. The German Materials Society congratulates its long-time Managing Director Dr. Peter Paul Schepp on the occasion of his 65th birthday
  22. Dr. Margarethe Hofmann-Amtenbrink on her 65th birthday
  23. DGM News
  24. DGM News
Jetzt anmelden und 20% sparen
Institutioneller Zugang
Wie funktioniert Authentifizierung?
Haben Sie eine Idee, wie wir unsere Website verbessern können?
Bitte schreiben Sie uns.
© 2025 De Gruyter Brill
Heruntergeladen am 25.10.2025 von https://www.degruyterbrill.com/document/doi/10.3139/146.111037/html
Button zum nach oben scrollen