Contents

Artikel in diesem Heft

1. Contents
2. Contents
3. Basic
4. A model to calculate the viscosity of silicate melts
5. A model to calculate the viscosity of silicate melts
6. A note on the application of the phase rule
7. Thermodynamic properties of liquid silver–indium–tin alloys determined from emf measurements
8. Unconstrained solidification and characterisation of near-eutectic Al–Cu–Ag alloys
9. Tensile properties of L1₂ intermetallic foils fabricated by cold rolling
10. Microstructural control of FeB-inoculated mottled low-alloy white iron by a design of experiments approach
11. Applied
12. Dislocation structure and crystallite size distribution in lath martensite determined by X-ray diffraction peak profile analysis
13. Effect of minor addition of Pb upon interfacial reactions and mechanical properties at Sn-3.0Ag-0.5Cu/Cu and Sn-58Bi/Cu solder joints
14. Elastic properties of braided ceramic matrix composites
15. The influence of microstructural characteristics and contaminants on the mechanical properties and fracture topography of low cost Ti6Al4V alloy
16. Microstructure and room temperature mechanical properties of Hf and Sn-doped Nb-20Ti-5Cr-3Al-18Si alloy
17. The effect of alloying elements on constrained carbon equilibrium due to a quench and partition process
18. Hardfacing behavior of Cr–Ni stainless steel with Co-based super alloys
19. Development of SMD 32.768 kHz tuning fork-type crystals
20. Notification
21. DGM News