Frontmatter

Articles in the same Issue

1. Frontmatter
2. Original articles
3. Microstructures and physical properties of laser amorphous reinforced composite coatings
4. The thermal resistance, flame retardance, and smoke control mechanism of nano MH/GF/NBR composite material
5. The effect of sodium hydroxide treatment and fiber length on the tensile property of coir fiber-reinforced epoxy composites
6. Evaluation of morphological characteristics and mechanical performance of Rockforce mineral fiber- and glass fiber-reinforced polyamide-6 composites
7. Synthesis of superabsorbent resin with the properties of temperature tolerant, salt tolerant, and water absorbency deferred
8. A study on tribological characterization of Al-Cu-Mg-B composites subjected to mechanical wear
9. Microstructure and wear behavior of TiAl₃ matrix self-lubricating composites by addition of fluoride solid lubricants
10. Mechanical properties of Ni-nano-Al₂O₃ composite coatings on AISI 304 stainless steel by pulsed electrodeposition
11. Improvement of Khorasan mortar with fly ash for restoration of historical buildings
12. Combined effect of waste colemanite and silica fume on properties of cement mortar
13. Effect of heat treatment temperature on ground pumice activation in geopolymer composites
14. Stress intensity factor analysis of epoxy/SWCNTs based on global-local multiscale method
15. Numerical elastoplastic analysis of the shear stress distribution in the adhesive layer for single-lap joints
16. Analysis of three-layer composite plates with a new higher-order layerwise formulation
17. Ceramic-polytetrafluoroethylene composite material-based miniaturized split-ring patch antenna
18. Prediction of the influence of processing parameters on synthesis of Al2024-B₄C composite powders in a planetary mill using an artificial neural network
19. Different method to make laminates by shear thickening fluid
20. Thermal control design for an automated fiber placement machine
21. Estimate of cutting forces and surface roughness in end milling of glass fiber reinforced plastic composites using fuzzy logic system
22. Electrical discharge machining of Al-TiB₂ with a low-frequency vibrating tool
23. Vibration behavior of a radially functionally graded annular disc with variable geometry
24. Buckling behaviors of the impacted composite plates