Home The damping behavior of a Ni-50 at.%Ti shape memory alloy
Article
Licensed
Unlicensed Requires Authentication

The damping behavior of a Ni-50 at.%Ti shape memory alloy

  • Fuxing Yin , Susumu Takamori , Yoshiaki Ohsawa and Kohji Kawahara
Published/Copyright: February 7, 2022
Become an author with De Gruyter Brill
Author Information
International Journal of Materials Research
From the journal International Journal of Materials Research Volume 94 Issue 9

Abstract

In order to utilize the shape memory alloys (SMAs) for prospective damping applications, a near equiatomic NiTi alloy was investigated on a dynamic mechanical analyzer in the infrasonic frequency range. A high damping capacity stable to the variation of temperature can be obtained during a two-stage phase transformation and in the martensite state approaching to the martensite-parent phase transformation temperature in the NiTi SMA. The transient damping peaks associated with the phase transformation in the NiTi SMA shows a strong frequency dependence in both solutionized and annealed specimens. The frequency dependence parameter, n, was found to be in the range 0.3 – 0.6. For the applied strain amplitudes from 8.5 × 10–6 to 5.0 × 10 –5 a clear strain amplitude dependence was not observed in the damping peaks, except for the solutionized specimens. While the damping capacity of the martensite state, characterized at 300 K, showed obvious frequency dependences in both the solutionized and annealed specimens, only the annealed specimens manifested the strain amplitude dependence. The different damping behavior was attributed to the internal structure of martensite, including dislocations, the twinning types and variant interfaces, changeable with the prior thermomechanical treatments.

Keywords: NiTi alloy; Shape memory alloy; Damping capacity; Strain amplitude; Two-stage phase transformation; Dislocation; Twin boundary
F. Yin National Institute for Materials Science Sengen 1-2-1, Tsukuba, Ibaraki 305-0047, Japan Tel.: +81 29 8 59 21 42 Fax: +81 29 8 59 21 01

References

[1] H. Funakubo: Shape Memory Alloys, Gordon and Break Science Publishers, New York (1987).Search in Google Scholar

[2] Y. Liu, Z. Xie, J. Van Humbeek: J. Phys. IV 7 (1997) C5–519.Search in Google Scholar

[3] Y. Liu, Z. Xie, J. Van Humbeek: Mater. Sci. Eng. A 273 (1999) 673.10.1016/S0921-5093(99)00347-0Search in Google Scholar

[4] K. Sugimoto, K. Kamei, T. Sugimoto, T. Sodeoka in: Proc. Int. Conf. Mart. Transf., K. Shimizu (Ed.), Jpn. Inst. Metals, Nara (1986) 729.Search in Google Scholar

[5] Y. Liu, J. Van Humbeeck, R. Stalmans, L. Delaey: J. Alloys Comp. 247 (1997) 115.10.1016/S0925-8388(96)02572-8Search in Google Scholar

[6] I. Yoshida, T. Ono, M. Asai: J. Alloys Comp. 310 (2000) 339.10.1016/S0925-8388(00)00957-9Search in Google Scholar

[7] Y. Wang, W. Chen, H. Shen, in: Proc. 9th Int. Conf. Internal Friction and Ultrasonic Attention in Solids, T. Ke (Ed.), Int. Academic Publ., Beijing (1990) 305.Search in Google Scholar

[8] S. Golyandin, S. Fustov, K. Sapozhnikov, M. Parlinska, R. Gotthardt, J. Van Hunbeeck, R. De Batist: J. Alloys Comp. 310 (2000) 312.10.1016/S0925-8388(00)01018-5Search in Google Scholar

[9] B. Coluzzi, A. Biscarini, R. Campanella, G. Mazzolai, L. Trotta, F. M. Mazolai: J. Alloys Comp. 310 (2000) 300.10.1016/S0925-8388(00)00968-3Search in Google Scholar

[10] Z. Xie, Y. Liu, J. Van Humbeeck: Acta Mater. 468 (1998) 1989.10.1016/S1359-6454(97)00379-0Search in Google Scholar

[11] Y. Liu, Z. Xie, J. Van Humbeeck, L. Delaey: Mater. Sci. Eng. A 273 (1999) 679.10.1016/S0921-5093(99)00348-2Search in Google Scholar

[12] K. Sugimoto, T. Mori, S. Shiode: Metal Sci. J. 7 (1973)103.10.1179/030634573790445604Search in Google Scholar

[13] O. Mercier, K. Melton, G. Gremaud, J. Hagi: J. Appl. Phys. 41 (1980) 1833.10.1063/1.327750Search in Google Scholar

[14] H. Lin, S. Wu, M. Yeh: Metall. Trans. A 22 (1993) 2189.10.1007/BF02648593Search in Google Scholar

[15] S. Miyazaki, K. Otsuka: Metall. Trans. A 17 (1986) 53.10.1007/BF02644442Search in Google Scholar

[16] M. Nishida, C M. Wayman: Metallography 21 (1988) 255.10.1016/0026-0800(88)90024-9Search in Google Scholar

[17] M. Nishida, C M. Wayman, A. Chiba: Metallography 21 (1988) 275.10.1016/0026-0800(88)90025-0Search in Google Scholar

[18] Y. Liu, Z. Xie, J. Van Humbeek: Materi. Sci. Eng. A 273 (1999) 679.10.1016/S0921-5093(99)00348-2Search in Google Scholar
Received: 2002-11-21
Published Online: 2022-02-07

© 2003 Carl Hanser Verlag, München

Articles in the same Issue

  1. Frontmatter
  2. Articles/Aufsätze
  3. Bulk and grain boundary diffusion of Ag in γ-FeNi alloy
  4. Thermodynamics of ordered intermetallic compounds containing point defects
  5. Relationship between the sodium oxide activity of ceramic (Na-β + β″)-alumina and the sodium activity in the ambience of the material
  6. Calorimetric study of MgZn2 and Mg2Zn11
  7. The (γ + γ′)/γ′ phase boundary in the Ni–Al phase diagram from 600 to 1200 °C
  8. Experimental investigation and thermodynamic calculation of ternary Al–Ca–Mg phase equilibria
  9. Texture development in Al alloys during tensile testing
  10. Dispersion strengthening of copper by internal oxidation of rapidly solidified Cu-RE alloys
  11. The effect of Cu and Al on the mechanical properties of gravity-cast hyper-eutectic Zn–Al-based alloys
  12. Hot deformation characteristics of Ti-6Al-4V
  13. Effect of carbon and nitrogen on the stacking fault energy of high-alloyed iron-based austenite
  14. Influence of charged hydrogen on tensile behavior of a pressure vessel steel at relatively high temperatures
  15. The damping behavior of a Ni-50 at.%Ti shape memory alloy
  16. Development of SMD 32.768 kHz tuning fork-type crystals
  17. Investigation of the miscibility gap region in liquid Ga–Pb alloys
  18. Notifications/Mitteilungen
  19. Werner-Köster-Preis 2002
  20. Personal/Personelles
  21. Information
  22. Books/Bücher
  23. Conferences/Konferenzen
https://doi.org/10.1515/ijmr-2003-0185
Keywords for this article
NiTi alloy; Shape memory alloy; Damping capacity; Strain amplitude; Two-stage phase transformation; Dislocation; Twin boundary

Articles in the same Issue

  1. Frontmatter
  2. Articles/Aufsätze
  3. Bulk and grain boundary diffusion of Ag in γ-FeNi alloy
  4. Thermodynamics of ordered intermetallic compounds containing point defects
  5. Relationship between the sodium oxide activity of ceramic (Na-β + β″)-alumina and the sodium activity in the ambience of the material
  6. Calorimetric study of MgZn2 and Mg2Zn11
  7. The (γ + γ′)/γ′ phase boundary in the Ni–Al phase diagram from 600 to 1200 °C
  8. Experimental investigation and thermodynamic calculation of ternary Al–Ca–Mg phase equilibria
  9. Texture development in Al alloys during tensile testing
  10. Dispersion strengthening of copper by internal oxidation of rapidly solidified Cu-RE alloys
  11. The effect of Cu and Al on the mechanical properties of gravity-cast hyper-eutectic Zn–Al-based alloys
  12. Hot deformation characteristics of Ti-6Al-4V
  13. Effect of carbon and nitrogen on the stacking fault energy of high-alloyed iron-based austenite
  14. Influence of charged hydrogen on tensile behavior of a pressure vessel steel at relatively high temperatures
  15. The damping behavior of a Ni-50 at.%Ti shape memory alloy
  16. Development of SMD 32.768 kHz tuning fork-type crystals
  17. Investigation of the miscibility gap region in liquid Ga–Pb alloys
  18. Notifications/Mitteilungen
  19. Werner-Köster-Preis 2002
  20. Personal/Personelles
  21. Information
  22. Books/Bücher
  23. Conferences/Konferenzen
Sign up now to receive a 20% welcome discount
Institutional Access
How does access work?
Have an idea on how to improve our website?
Please write us.
© 2025 De Gruyter Brill
Downloaded on 13.9.2025 from https://www.degruyterbrill.com/document/doi/10.1515/ijmr-2003-0185/html
Scroll to top button