Influence of Interfacial Oxides Formed During Dry Sliding Wear of NiCrBSiCFe Plasma Coating on AISI 316 Steel Substrates

Articles in the same Issue

1. Frontmatter
2. Creep and Fatigue Behavior in Micro-alloyed Steels – A Review
3. Determination of Flow Stress Using Parametric Linearity Relationship of Arrhenius Power Law
4. Low-Temperature Sintering of Nanosilver Paste on a Gold Film Surface
5. Influence of Interfacial Oxides Formed During Dry Sliding Wear of NiCrBSiCFe Plasma Coating on AISI 316 Steel Substrates
6. Tribological Properties of WC-12Co Coating on AZ91 Magnesium Alloy Fabricated by High Velocity Oxy-Fuel Spray
7. Heat Treatment Study of γ + α₂ Ti Aluminides Obtained through Reaction Synthesis and Hot Deformation
8. The Enhanced Thermoelectric Properties of Ba_0.4Co₄Sb_11.7Te_0.3 Prepared by the High-Pressure and High-Temperature Method
9. Effect of Y and Mg on the Solidification Structure of Fe-36Ni Invar Alloy
10. Deformation Mechanisms of Tandem Hot Rolled GH4169 Superalloy during Creep
11. Effect of Ce₂O₃ and CaO/Al₂O₃ on the Phase, Melting Temperature and Viscosity of CaO-Al₂O₃-10 Mass% SiO₂ Based Slags
12. Microstructural Evolution of Aluminum Alloy 2618 During Homogenization and Its Kinetic Analysis
13. Synthesis and Characterization of New Poly(amide-imide)/organoclay Nanocomposites Derived from N,N′-(4,4′-diphtaloyl)-bis-L-α-aminophenyl Acetic Diacid and 1,2-Bis(4-aminophenoxy)ethane