Article
Licensed
Unlicensed
Requires Authentication
Preparation and Characterization of Poly Methyl Methacrylate-cadmium Sulfide Nanocomposite
-
Davood Ghanbari
Published/Copyright:
December 13, 2012
Abstract
In this work first cadmium sulfide-organic (CdS-or) nanostructures were synthesized via a simple chemical reaction at room temperature and then for preparation of the polymeric nanocomposite, CdS-or nanostructures were added to the poly methyl methacrylate (PMMA). The effect of the nanostructures on the thermal properties of the PMMA matrix was studied using thermogravimetric analysis (TGA). The thermal decomposition of the nanocomposite was shifted towards higher temperature in the presence of the CdS-or nanostructures. Nanostructures and nanocomposite materials were characterized by means of X-ray diffraction (XRD), scanning electron microscopy (SEM), Fourier transform infrared (FT-IR), photoluminescence (PL) and ultraviolet-visible (UV-vis) spectroscopy.
Received: 2012-02-25
Accepted: 2012-03-02
Published Online: 2012-12-13
Published in Print: 2012-12-14
©[2012] by Walter de Gruyter Berlin Boston
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Masthead
- High Temperature Tensile Properties of Equal Channel Angular Pressed Al-Zn-Mg-Cu Alloy
- Hard Finish Turning Parameters Optimization for Machining of High Temperature Stainless Steel
- High Cycle Fatigue and Cyclic Plastic Deformation Behaviour of High Temperature Oxidation Resistant Titanium Aluminide Coated IMI 834 Alloy at 873 K
- Microstructural and Mechanical Properties of Er2O3-ZrO2 Ceramics with Different Er2O3 Contents
- Synthesis of Different Morphologies of PbS Nanostructures via Hydrothermal Process
- Facile Hydrothermal Synthesis of CoSO4ċH2O Nanoparticles and Barite Microcubes from Novel Precursors
- Hot Corrosion of Fe-Cr Alloys with 75 Na2SO4 + 25 NaCl Coating at 1173 K
- A Simple Method for Synthesis of PbS Nanoparticles Using 2-Mercaptoethanol as the Capping Agent
- Influence of Alloy Grain Size on High Temperature Corrosion Behavior of 2.25 Cr-1 Mo Steel in SO2 + O2 Atmosphere
- Encapsulation of Erbium(III) and Thulium(III) Nanocomplexes Containing 18- and 20-Membered Dioxa Tetraaza Macryclic Ligands Within the Framework of Zeolite
- Calculation of the Raman Linewidths of Lattice Modes Close to the α-β Transition in Quartz
- Production and Characterization of Hydroxyapatite-Zirconia Composites
- Influence of Long-term Aging on Microstructure and Creep Behaviors of FGH95 Nickel-based Superalloy
- Remnant Life Assessment and Microstructural Studies on Service Exposed Primary Reformer Tubes of a Catalytic Converter of an Ammonia Plant
- Preparation and Characterization of Poly Methyl Methacrylate-cadmium Sulfide Nanocomposite
- Oxidation Kinetics of Steels Utilized in the Production of Valves in Automobile Industry
Articles in the same Issue
- Masthead
- High Temperature Tensile Properties of Equal Channel Angular Pressed Al-Zn-Mg-Cu Alloy
- Hard Finish Turning Parameters Optimization for Machining of High Temperature Stainless Steel
- High Cycle Fatigue and Cyclic Plastic Deformation Behaviour of High Temperature Oxidation Resistant Titanium Aluminide Coated IMI 834 Alloy at 873 K
- Microstructural and Mechanical Properties of Er2O3-ZrO2 Ceramics with Different Er2O3 Contents
- Synthesis of Different Morphologies of PbS Nanostructures via Hydrothermal Process
- Facile Hydrothermal Synthesis of CoSO4ċH2O Nanoparticles and Barite Microcubes from Novel Precursors
- Hot Corrosion of Fe-Cr Alloys with 75 Na2SO4 + 25 NaCl Coating at 1173 K
- A Simple Method for Synthesis of PbS Nanoparticles Using 2-Mercaptoethanol as the Capping Agent
- Influence of Alloy Grain Size on High Temperature Corrosion Behavior of 2.25 Cr-1 Mo Steel in SO2 + O2 Atmosphere
- Encapsulation of Erbium(III) and Thulium(III) Nanocomplexes Containing 18- and 20-Membered Dioxa Tetraaza Macryclic Ligands Within the Framework of Zeolite
- Calculation of the Raman Linewidths of Lattice Modes Close to the α-β Transition in Quartz
- Production and Characterization of Hydroxyapatite-Zirconia Composites
- Influence of Long-term Aging on Microstructure and Creep Behaviors of FGH95 Nickel-based Superalloy
- Remnant Life Assessment and Microstructural Studies on Service Exposed Primary Reformer Tubes of a Catalytic Converter of an Ammonia Plant
- Preparation and Characterization of Poly Methyl Methacrylate-cadmium Sulfide Nanocomposite
- Oxidation Kinetics of Steels Utilized in the Production of Valves in Automobile Industry
