Comparing the Effect of Chemical and Physical Properties on Complex Electrical Impedance of Scots Pine Wood
-
M. Tiitta
Summary
This study examined the effects of physical (moisture content, water content and wood density) and chemical properties (concentration of phenolics and resin acids) on the electrical properties of Scots pine (Pinus sylvesteris L.) wood specimens. Complex impedance was measured from heartwood and sapwood specimens using frequencies between 5 kHz and 1 MHz. Significant correlation between density and electrical properties was found at high frequencies with sapwood specimens in which the extractive content was low. Moisture content had an effect on electrical properties over the whole frequency range. Electrical properties of heartwood samples with high extractive content were differently affected by the chemical and physical properties. Electrical properties were sufficient to distinguish between the samples from the brown-rot resistant and susceptible Scots pine trees.
Copyright © 2003 by Walter de Gruyter GmbH & Co. KG
Artikel in diesem Heft
- Topochemical Characterisation of Phenolic Extractives in Discoloured Beechwood (Fagus sylvatica L.)
- Detection and Species Identification of Wood-Decaying Fungi by Hybridization of Immobilized Sequence-Specific Oligonucleotide Probes with PCR-Amplified Fungal Ribosomal DNA Internal Transcribed Spacers
- Analysis of Protein Expression along the Normal to Tension Wood Gradient in Eucalyptus gunnii
- Phenolic and Lipophilic Extractives in Scots Pine Knots and Stemwood
- Chemical Characterisation of Wood of Roman Ships Brought to Light in the Recently Discovered Ancient Harbour of Pisa (Tuscany, Italy)
- Lignin Structures in Normal and Compression Wood. Evaluation by Thioacidolysis Using Ethanethiol and Methanethiol
- Lignin-Carbohydrate Condensation Product Formation in a Biomimetic Model Pulp Bleaching System
- Viscoelastic Behaviour of Wood Fibres during the Hot Pressing of Medium Density Fibreboard
- Measuring Relative Fibre Length in Scots Pine by Non-Destructive Wood Sampling
- Modelling Log-End Cracks Due to Growth Stresses: Calculation of the Elastic Energy Release Rate
- Modeling Ovendry Softwood Resistivity Based on the Resistor Network Theory
- Comparison of the TL-Shear Strength of Normal and Compression Wood of European Larch
- A Theoretical Analysis of Timber Drying in Oscillating Climates
- Comparing the Effect of Chemical and Physical Properties on Complex Electrical Impedance of Scots Pine Wood
- Wood-Derived Porous Ceramics via Infiltration of SiO2-Sol and Carbothermal Reduction
- Manufacture of Fiberboard from Wood Fibers Activated with Fentons Reagent (H2O2/FeSO4)
Artikel in diesem Heft
- Topochemical Characterisation of Phenolic Extractives in Discoloured Beechwood (Fagus sylvatica L.)
- Detection and Species Identification of Wood-Decaying Fungi by Hybridization of Immobilized Sequence-Specific Oligonucleotide Probes with PCR-Amplified Fungal Ribosomal DNA Internal Transcribed Spacers
- Analysis of Protein Expression along the Normal to Tension Wood Gradient in Eucalyptus gunnii
- Phenolic and Lipophilic Extractives in Scots Pine Knots and Stemwood
- Chemical Characterisation of Wood of Roman Ships Brought to Light in the Recently Discovered Ancient Harbour of Pisa (Tuscany, Italy)
- Lignin Structures in Normal and Compression Wood. Evaluation by Thioacidolysis Using Ethanethiol and Methanethiol
- Lignin-Carbohydrate Condensation Product Formation in a Biomimetic Model Pulp Bleaching System
- Viscoelastic Behaviour of Wood Fibres during the Hot Pressing of Medium Density Fibreboard
- Measuring Relative Fibre Length in Scots Pine by Non-Destructive Wood Sampling
- Modelling Log-End Cracks Due to Growth Stresses: Calculation of the Elastic Energy Release Rate
- Modeling Ovendry Softwood Resistivity Based on the Resistor Network Theory
- Comparison of the TL-Shear Strength of Normal and Compression Wood of European Larch
- A Theoretical Analysis of Timber Drying in Oscillating Climates
- Comparing the Effect of Chemical and Physical Properties on Complex Electrical Impedance of Scots Pine Wood
- Wood-Derived Porous Ceramics via Infiltration of SiO2-Sol and Carbothermal Reduction
- Manufacture of Fiberboard from Wood Fibers Activated with Fentons Reagent (H2O2/FeSO4)
