Wood-Derived Porous Ceramics via Infiltration of SiO2-Sol and Carbothermal Reduction
-
Summary
The use of wood as a structure-giving material may be the key to producing temperature-resistant ceramics featuring high and directed porosity combined with necessary strength. The objective of this study was to develop a simple process to convert the evolutionarily optimized material wood into highly porous ceramics. Beech and pine, known to be relatively permeable, were pyrolyzed in a nitrogen atmosphere. The carbon-templates formed were infiltrated with various kinds of silica sol (SiO2). The resulting SiO2/C composite was transformed into a SiC-ceramic (silicon carbide) via carbothermal reduction. Through the described process the macroscopic pore-structure of wood was transformed exactly into SiC. The SiC-ceramic produced proved to be thermo-resistant. It remained stable in oxygen atmosphere at 1200°C, after a SiO2 coating around the SiC had been formed. This study focused on the alteration of the cell wall microstructure during the conversion of wood into SiC. Furthermore, the optimization of the individual process steps, pyrolysis, infiltration and ceramization along the most efficient route was pursued.
Copyright © 2003 by Walter de Gruyter GmbH & Co. KG
Articles in the same Issue
- Topochemical Characterisation of Phenolic Extractives in Discoloured Beechwood (Fagus sylvatica L.)
- Detection and Species Identification of Wood-Decaying Fungi by Hybridization of Immobilized Sequence-Specific Oligonucleotide Probes with PCR-Amplified Fungal Ribosomal DNA Internal Transcribed Spacers
- Analysis of Protein Expression along the Normal to Tension Wood Gradient in Eucalyptus gunnii
- Phenolic and Lipophilic Extractives in Scots Pine Knots and Stemwood
- Chemical Characterisation of Wood of Roman Ships Brought to Light in the Recently Discovered Ancient Harbour of Pisa (Tuscany, Italy)
- Lignin Structures in Normal and Compression Wood. Evaluation by Thioacidolysis Using Ethanethiol and Methanethiol
- Lignin-Carbohydrate Condensation Product Formation in a Biomimetic Model Pulp Bleaching System
- Viscoelastic Behaviour of Wood Fibres during the Hot Pressing of Medium Density Fibreboard
- Measuring Relative Fibre Length in Scots Pine by Non-Destructive Wood Sampling
- Modelling Log-End Cracks Due to Growth Stresses: Calculation of the Elastic Energy Release Rate
- Modeling Ovendry Softwood Resistivity Based on the Resistor Network Theory
- Comparison of the TL-Shear Strength of Normal and Compression Wood of European Larch
- A Theoretical Analysis of Timber Drying in Oscillating Climates
- Comparing the Effect of Chemical and Physical Properties on Complex Electrical Impedance of Scots Pine Wood
- Wood-Derived Porous Ceramics via Infiltration of SiO2-Sol and Carbothermal Reduction
- Manufacture of Fiberboard from Wood Fibers Activated with Fentons Reagent (H2O2/FeSO4)
Articles in the same Issue
- Topochemical Characterisation of Phenolic Extractives in Discoloured Beechwood (Fagus sylvatica L.)
- Detection and Species Identification of Wood-Decaying Fungi by Hybridization of Immobilized Sequence-Specific Oligonucleotide Probes with PCR-Amplified Fungal Ribosomal DNA Internal Transcribed Spacers
- Analysis of Protein Expression along the Normal to Tension Wood Gradient in Eucalyptus gunnii
- Phenolic and Lipophilic Extractives in Scots Pine Knots and Stemwood
- Chemical Characterisation of Wood of Roman Ships Brought to Light in the Recently Discovered Ancient Harbour of Pisa (Tuscany, Italy)
- Lignin Structures in Normal and Compression Wood. Evaluation by Thioacidolysis Using Ethanethiol and Methanethiol
- Lignin-Carbohydrate Condensation Product Formation in a Biomimetic Model Pulp Bleaching System
- Viscoelastic Behaviour of Wood Fibres during the Hot Pressing of Medium Density Fibreboard
- Measuring Relative Fibre Length in Scots Pine by Non-Destructive Wood Sampling
- Modelling Log-End Cracks Due to Growth Stresses: Calculation of the Elastic Energy Release Rate
- Modeling Ovendry Softwood Resistivity Based on the Resistor Network Theory
- Comparison of the TL-Shear Strength of Normal and Compression Wood of European Larch
- A Theoretical Analysis of Timber Drying in Oscillating Climates
- Comparing the Effect of Chemical and Physical Properties on Complex Electrical Impedance of Scots Pine Wood
- Wood-Derived Porous Ceramics via Infiltration of SiO2-Sol and Carbothermal Reduction
- Manufacture of Fiberboard from Wood Fibers Activated with Fentons Reagent (H2O2/FeSO4)
