Contents

Articles in the same Issue

1. Inhalt/Contents
2. Contents
3. Fachbeiträge/Technical Contributions
4. An investigation of the crash performance of magnesium, aluminum and advanced high strength steels and different cross-sections for vehicle thin-walled energy absorbers
5. Model-based correlation between change of electrical resistance and change of dislocation density of fatigued-loaded ICE R7 wheel steel specimens
6. Tensile strength of 3D printed materials: Review and reassessment of test parameters
7. Numerical calculation of stress concentration of various subsurface and undercutting pit types
8. Chemical composition of chosen phase constituents in austempered ductile cast iron
9. Investigation of initial yielding in the small punch creep test
10. Optimization and characterization of friction surfaced coatings of ferrous alloys
11. Influence of the milling process on TiB₂ particle reinforced Al-7 wt.-% Si matrix composites
12. In-situ compaction and sintering of Al₂O₃ – GNP nanoparticles using a high-frequency induction system
13. Strain-rate controlled Gleeble experiments to determine the stress-strain behavior of HSLA steel S960QL
14. Thermography using a 1D laser array – From planar to structured heating
15. Schichtdickenbestimmung von Oberflächenschutzsystemen für Beton mit Impulsthermografie
16. Microstructure and mechanical properties of fly ash particulate reinforced AA8011 aluminum alloy composites
17. High temperature compressive behavior of three-dimensional five-directional braided composites
18. Dry sliding behavior of the aluminum alloy 8011 composite with 8 % fly ash
19. Review on nanostructures from catalytic pyrolysis of gas and liquid carbon sources