The effect of rhenium and cobalt additions on the microstructure and gamma prime phase stability of modified nickel-based superalloy, grade MGA1400 by means of a vacuum arc melting method with different contents of rhenium (Re) and cobalt (Co) was investigated. After being subjected to heat treatment, the size of the gamma prime particles was slightly reduced with increasing rhenium content. Then, the alloys were exposed at a temperature of 1173 K for 1800 ks. The results showed that increasing the rhenium addition leads to a slower coarsening rate of the gamma prime particles. Furthermore, the shape of the gamma prime particles changed to a more cubic shape. However, an excessive rhenium content (>1.21 wt.-%) promotes the formation of a topologically close-packed phase after a 360 ks exposure at 1173 K. It can be concluded that an increase in rhenium content can result in a lower coarsening rate of the gamma prime particles. The cobalt addition is beneficial for impeding or slowing the precipitation of topologically close-packed phases at an elevated temperature.
Contents
- Inhalt/Contents
- Fachbeiträge/Technical Contributions
-
Requires Authentication UnlicensedEffect of rhenium and cobalt additions on the microstructure and gamma prime phase stability of vacuum arc melted modified nickel-based superalloys grade MGA 1400LicensedJuly 8, 2019
-
Requires Authentication UnlicensedResidual strength of fire-exposed glass-reinforced epoxy composite pipesLicensedJuly 8, 2019
-
Requires Authentication UnlicensedImpact attenuator conceptual design using lightweight materials and meta-modeling techniqueLicensedJuly 8, 2019
-
Requires Authentication UnlicensedMicrostructure and properties of high strength Al-Fe-Cu-Si-Zn alloy (AA8079) produced by mechanical alloying and powder metallurgyLicensedJuly 8, 2019
-
Requires Authentication UnlicensedDetermination of the static, dynamic and cyclic properties of the heat affected zone for different steel gradesLicensedJuly 8, 2019
-
Requires Authentication UnlicensedFriction stir welded and deep drawn multi-material tailor welded blanksLicensedJuly 8, 2019
-
Requires Authentication UnlicensedEffects of cut-outs on the vibrational characteristics of a hollow shaft systemLicensedJuly 8, 2019
-
Requires Authentication UnlicensedEffect of heat treatment on wear and corrosion behavior of high chromium white cast ironLicensedJuly 8, 2019
-
Requires Authentication UnlicensedEffect of nanoparticle reinforcement on mechanical properties and erosion–corrosion behavior of cast aluminumLicensedJuly 8, 2019
-
Requires Authentication UnlicensedEffect of different grain sizes on the static strain aging behavior of bake hardening steelLicensedJuly 8, 2019
-
Requires Authentication UnlicensedEffect of fillers on vinylester matrix compositesLicensedJuly 8, 2019
-
Requires Authentication UnlicensedImpact of oxygen doping on AC impedance, complex dielectric and electrical modulus spectra of a Hg-Ba-Ca-Cu-O ceramicLicensedJuly 8, 2019
-
Requires Authentication UnlicensedEffect of TiBAl inoculation on abrasive wear resistance of high Cr white cast ironLicensedJuly 8, 2019
-
Requires Authentication UnlicensedStress shielding reduction via graded porosity of a femoral stem implantLicensedJuly 8, 2019