Volume 12, Issue 8 - 12(8) Special Issue: Chemistry and Chemical Engineering - Environmental and Biochemistry

Three mesostructured silica-type carriers, MCM-41 and MCM-41 functionalized by a postsynthesis grafting procedure with hydrophilic aminopropyl groups (MCM-APTES) and hydrophobic vinyl moieties (MCM-VTES), respectively, were investigated in order to elaborate drug delivery systems (DDS) for irinotecan molecules. All studied drug delivery systems exhibited higher cytotoxicity on murine embrionary fibroblastic (MEF) cells than free irinotecan at the same content of the cytostatic agent, whereas no toxicity was observed for the three unloaded carriers. The cytotoxic effect of irinotecan loaded on MCM-41-type carriers continued to increase even 24 h after ceasing the cell exposure to the drug and remained significantly higher than that of free irinotecan. The cellular uptake of silica-type hybrids was investigated by labelling MCM-APTES with Rhodamine B. In the case of the studied DDS, an endocytotic mechanism was found to be involved in the cell uptake process, and it was used to explain the cytotoxicity differences between free irinotecan and drug loaded on MCM-41-type supports.

The aim of this study was to compare several anion exchangers and to investigate the capacity of Amberlite IRA410 to remove zinc as chloride [ZnCl3]− from hydrochloric solutions (1 M). Influence of the process parameters such as stirring rate, resin quantity and zinc initial concentration over the removal process, was considered. The highest experimental ionic exchange capacity between the considered anionic exchangers, in the same working conditions (500 rpm, 5 g resin and 500 mg L−1), was obtained for Amberlite IRA410, 8.34 mg g−1. With an increase of zinc ions concentration, ionic exchange capacity increased up to 19.31 mg g−1 (1100 mg L−1). The experimental data were analysed using Langmuir, Freundlich, Temkin and Dubinin-Radushkevich isotherm models. The results were also analyzed using sorption kinetics models, pseudo-first-, pseudo-second-order, intra-particle and film diffusion models. From the Dubinin-Radushkevich and Temkin isotherm models the mean free energy and heat of sorption were calculated to be 7.45 kJ mol−1, respectively 1×10−4 kJ mol−1, which indicates that zinc sorption is characterized by a physisorption process. Kinetic studies showed that the adsorption followed a pseudo-second-order kinetic model.

In this study, microwave assisted a hydrodistillation process (MWHD) of essential oils from lavender (Lavandula angustifolia Miller) was investigated. In order to examine any potential differences in essential oil extraction, the lavender flowers underwent enzymatic pretreatment. A 23 factorial design of experiments, combined with statistical methods of data analysis were used to optimize enzymatic pretreatment and to evaluate the influence of major variables (enzyme concentration, temperature and pH) on the performance of the microwave assisted extraction. Under optimal conditions, an extraction yield of 24 mg oil g−1 substrate was achieved (an increase by approximately 25% in comparison with the classic extraction conditions of conventional hydrodistillation). The main compounds of the essential oils obtained were analyzed and identified by gas chromatography coupled to mass spectrometry (GC-MS). Analyzing the data obtained indicated that the content of main compounds (linalool and linalyl acetate − 73%) was greater than that obtained by conventional extraction (67%).

Due to their unique features, most nanostructured lipid carriers (NLCs) in association with vegetable oils that exhibit UV filtering properties and bioactivity could be used in many cosmetic formulations. Therefore, in this work, a new application of pomegranate seed oil (PSO) in the cosmetic sector was developed, based on the synthesis of bioactive lipid nanocarriers loaded with various UV filters by the hot high pressure homogenization technique. To get broad spectrum photoprotection, different UVA and UVB filters have been used (Avobenzone — AVO, Octocrylen-OCT, Bemotrizinol — BEMT). The influence of the solid lipids combined with PSO on the particle size, physical stability and entrapment efficiency was investigated using 8 nanocarrier systems. An improved physical stability and an appropriate size were obtained for NLCs prepared with Emulgade, carnauba wax and PSO (e.g. −30.9÷-36.9 mV and 160÷185 nm). NLCs showed an entrapment efficiency above 90% and assured slow release rates of UV filters, especially for BEMT (5%). The developed nanocarriers have been formulated into safe and effective sunscreens containing low amounts of synthetic UV filters coupled with a high percent of natural ingredients. The highest SPF of 34.3 was obtained for a cream comprising of 11% PSO and 3.7% BEMT

Biocatalysts with microorganisms immobilized on solid carriers could provide the solution for development of continuous industrial processes for ethanol obtaining by fermentation of sugars. In this study, modified polyacrylamide hydrogels and marrow stem sunflower are used as supports for Saccharomyces cerevisiae yeast immobilization. The obtained structures are used for fermentation of molasses in batch systems. The free yeast cells are used as reference. The modification of polyacrilamide matrix with (2-hydroxyethyl)methacrylate has a positive effect on structure pore uniformity and fermentation performance. The mechanical properties of the obtained biocatalysts are compared. The novel natural matrix has net superior compression strength.

The aim of this research was to investigate the chemical composition of Coreopsis tinctoria Nutt. fruits extract, to highlight the potential of ultrasound assisted extraction in the fast preparation of extracts rich in polyphenols using different solvents (55%, 78% and 96% hydrous ethanol) and to evaluate the antioxidant potential of formulated extracts. LC-MS/MS was used to characterize the ethanolic extract from Coreopsis tinctoria Nutt. dried fruits. The extract contains different flavonoids (marein, flavanomarein, quercetagetin-7-O-glucoside, okanin aurone, leptosidin, luteolin, apigenin) and phenolic acids (chlorogenic acid, caffeic acid). Several parameters that could affect extraction efficiency were evaluated. Finally, this study focused on determination of plant extracts total phenolic content and their antioxidant capacity. The experimental results allowed the selection of the optimum operating parameters leading to the highest total polyphenolic content, expressed as gallic acid equivalents, and avoiding the degradation of phenolic compounds (ethanol 55%; extraction temperature 323.15 K, extraction time 30 min, liquid/solid ratio 20/1). A good relationship between total phenolic content and antioxidant capacity was obtained.

This study investigated the individual and interactive effects of three factors — temperature, inoculum/substrate ratio (ISR) and inoculum typology — on the anaerobic digestion of corn ethanol distillery wastewater. Biochemical methane potential assays planned with factorial design with two independent quantitative variables on three levels (ISR: 1:1, 2:1 and 3:1; temperature: 30°C, 33.5°C, 37°C) and one independent qualitative variable (inoculum type: suspended, granular, mixed) have been performed. Response Surface Methodology has been used to study the effect of the factors with the aim of maximizing the specific methane yields (YCH4) obtainable with this substrate. The results show that all three investigated factors influence in a significant matter the YCH4, the ISR having the strongest effect on it. The temperature has significant influence on the YCH4 only in combination with high ISR values. The optimal conditions for the maximum YCH4 (551 mL CH4 g−1 VSadded) have been found at 37°C operating temperature, ISR=3:1 and using granular inoculum. These conditions gave rise to a 4-fold increase of YCH4 with respect to the worst combination of factors (YCH4=129 mL g−1 VSadded for the suspended inoculum type, at 30°C and ISR=1:1). The results improve the knowledge on the digestion of this substrate, providing information for successful process up-scaling.

A thermodynamic approach for the complex chemical equilibria investigation of two-phase systems containing hydroxy aluminium sulfate (HAS) minerals in soils has been developed. This approach utilizes thermodynamic relationships combined with original mass balance constraints, where the HAS mineral phases are explicitly expressed. The factors influencing the distribution and concentrations of various soluble aluminium species have been taken into account. The new type of diagrams, based on thermodynamic, graphical and computerized methods, which quantitatively describe the distribution of soluble and insoluble inorganic, and organic, monomeric and polymeric aluminium species in acidic soil solutions in a large range of pH values has been used. The thermodynamics of equilibria of different natural HAS in soils, the conditions under which solids involving common ions can coexist at equilibrium, the acid-base and mineral equilibria and complex formation have been examined. It has been proved that the presence of sulfate ion dramatically alters the HAS mineral solubility under acidic conditions. The obtained data regarding the factors influencing Al speciation, based on the constructed diagrams of heterogeneous chemical equilibria, are in good agreement with the current experimental and theoretical evidence. The proposed approach is intended to determine the dominant processes that are responsible for the Al3+ concentration levels and its speciation in acidic soils.

We study experimentally the dynamics of holographic inscription of gratings in DR1:DNA-CTMA thin films using a degenerate two-wave mixing (DTWM) setup in its initial phase (30 ms) and in a longer time interval (30 s). The temporal pattern of evolution of diffraction efficiency is complex, simple fitting procedures fail to reproduce the data. We point out that the complex dynamics can originate a large span of temporal scales, closely related to the microscale inhomogeneity of local free volume. Some of its hallmarks are found through Monte Carlo simulations.