Texture of Hot Rolled and Annealed Binary Ti –Mn Alloys
-
Abstract
This work describes the development of texture during hot rolling and annealing of two binary Ti –Mn alloys. The alloys Ti –0.4Mn (α-type) and Ti –1.8Mn (near α-type) have been unidirectionally rolled up to 70% reduction at 750 °C, and air-cooled. The samples taken from these hot rolled plates were subjected to isothermal annealing at 700 °C for different lengths of time. After hot rolling, Ti –0.4Mn shows nearly a c-type texture, and Ti –1.8Mn an R-type texture. Annealing of the Ti –0.4Mn alloy generates a T-type texture, whilst annealing of the Ti –1.8Mn alloy leads to a continuous change in the hot rolling R-type texture. These results are compared with hot rolling and annealing textures of titanium and its alloys.
Literature
1 Singh, A.K.; Schwarzer, R.A.: Z. Metallkd. 91 (2000) 702.Search in Google Scholar
2 Bunge, H.J.: Texture Analysis in Materials Science, Butterworths, London (1982).Search in Google Scholar
3 Schäfer, B.: Mater. Sci. Forum 273 – 275 (1998) 113.10.4028/www.scientific.net/MSF.273-275.113Search in Google Scholar
4 McHargue, C.J.; Hammond, J.P.: Trans. AIME 193 (1953) 57.Search in Google Scholar
5 Tanabe, A.; Nishimura, T.; Fukuda, M.; Yoshida, K., Kihara, J.: in: Kimura, H., Izumi, O (eds.), Titanium 80: Science and Technology, Proc. 4th Int. Conf. on Titanium, TMS – ATME, Warrendale, PA (1980) 937.Search in Google Scholar
6 Fukuhara, Y.; Taniguchi, M.; Tsumori, Y.; Morofuji, H.; Ya-sui, K.; Nishimura, T.; Fukuda, M.: Tetsu-to-Hagane 73 (1985) S737.Search in Google Scholar
7 Shindo, T.; Hayakawa, H.; Suzuki, H.: Tetsu-to-Hagane 72 (1985) S1625.Search in Google Scholar
8 Inagaki, H.: Z. Metallkd. 81 (1990) 282.Search in Google Scholar
9 Inagaki, H.: Z. Metallkd. 83 (1992) 40.Search in Google Scholar
10 Inoue, H.; Inakazu, N.: in: 8th Int. Conf. on Textures of Materials (ICOTOM – 8), J.S. Kallend, G. Gottstein (eds.) (1988) 997.Search in Google Scholar
11 Lee, H.P.; Esling, C.; Bunge, H.J.: Textures and Microstructures 7(1988)317.10.1155/TSM.7.317Search in Google Scholar
12 Inagaki, H.: Z. Metallkd. 81 (1990) 540.Search in Google Scholar
13 Inagaki,H.: Z. Metallkd. 81 (1990) 433.Search in Google Scholar
14 Morii, K.; Hartig, C.; Mecking, H.; Nakayama, Y.; Lütjering, G.: in: 8th Int. Conf. on Textures of Materials (ICOTOM –8), J.S. Kallend, G. Gottstein (eds.) (1988) 991.Search in Google Scholar
15 Larson, F.R.; Zarkades, A.; Avery, D.H.: in: Titanium Science and Technology, Vol. 2, Plenum Press, New York (1973) 1169.Search in Google Scholar
16 Peters, M.; Lütjering, G.: as Ref. [5], p. 925.Search in Google Scholar
17 Ankem, S.; Margolin, H.: Metall. Trans. A17 (1986) 2209.10.1007/BF02645919Search in Google Scholar
© 2001 Carl Hanser Verlag, München
Articles in the same Issue
- Frontmatter
- Erratum
- Erratum
- Editorial
- In memoriam
- Aufsätze/Articles
- Low-temperature Processing of (Pb, La)(Zr, Ti) O3 Thick Films on Alumina Substrates
- Processing and Structure of Grain Boundaries in Strontium Titanate
- Stabilisation of MnZn Ferrites by the Re-oxidation of their Grain Boundaries
- Far-infrared Reflectivity Properties of BaTiO3 Ceramics
- Investigations on the Liquid Phase in Barium Titanate Ceramics with CuO Additives
- Chemical Engineering of Superconductive Rare-earth-Barium Cuprates: Melt Solidified Ceramics and Single Crystals
- Orthorhombic Titanium Aluminides: Phases, Phase Transformations and Microstructure Evolution
- Aspects of Sintering Additives for Processing and Microstructure Development of HIP-SSiC
- Investigation of Interlayer Phenomena in Ti/Pt Electrodes for Ferroelectric Thin Film Devices
- The Designing of Properties of Hydroxyapatite/Poly-l-lactide Composite Biomaterials by Hot Pressing
- Hydrolysis Assisted Solidification Process and its Use in Ceramic Wet Forming
- A Model for the Formation of Interdendritic Cavities from Pores Pre-existing in the Melt
- Pendeo-epitaxial Growth and Characterization of Thin Films of Gallium Nitride and Related Materials on SiC(0001) and Si(111) Substrates
- The Effect of Hydrogen Absorption and Desorption on Ta-doped SmFe Nitrides
- The Ternary System Fe–Nd–C
- Mechanical Properties of the Industrial HK40 Reforming Tubes Produced by an Improved Centrifugal Processing
- Texture of Hot Rolled and Annealed Binary Ti –Mn Alloys
- Finite-Element-Simulation des Faserverhalten metallischer Verbundwerkstoffe bei LCF-Beanspruchung
- Mitteilungen/Notifications
- Personal
- Book Reviews
- Tagungen/Conferences
Articles in the same Issue
- Frontmatter
- Erratum
- Erratum
- Editorial
- In memoriam
- Aufsätze/Articles
- Low-temperature Processing of (Pb, La)(Zr, Ti) O3 Thick Films on Alumina Substrates
- Processing and Structure of Grain Boundaries in Strontium Titanate
- Stabilisation of MnZn Ferrites by the Re-oxidation of their Grain Boundaries
- Far-infrared Reflectivity Properties of BaTiO3 Ceramics
- Investigations on the Liquid Phase in Barium Titanate Ceramics with CuO Additives
- Chemical Engineering of Superconductive Rare-earth-Barium Cuprates: Melt Solidified Ceramics and Single Crystals
- Orthorhombic Titanium Aluminides: Phases, Phase Transformations and Microstructure Evolution
- Aspects of Sintering Additives for Processing and Microstructure Development of HIP-SSiC
- Investigation of Interlayer Phenomena in Ti/Pt Electrodes for Ferroelectric Thin Film Devices
- The Designing of Properties of Hydroxyapatite/Poly-l-lactide Composite Biomaterials by Hot Pressing
- Hydrolysis Assisted Solidification Process and its Use in Ceramic Wet Forming
- A Model for the Formation of Interdendritic Cavities from Pores Pre-existing in the Melt
- Pendeo-epitaxial Growth and Characterization of Thin Films of Gallium Nitride and Related Materials on SiC(0001) and Si(111) Substrates
- The Effect of Hydrogen Absorption and Desorption on Ta-doped SmFe Nitrides
- The Ternary System Fe–Nd–C
- Mechanical Properties of the Industrial HK40 Reforming Tubes Produced by an Improved Centrifugal Processing
- Texture of Hot Rolled and Annealed Binary Ti –Mn Alloys
- Finite-Element-Simulation des Faserverhalten metallischer Verbundwerkstoffe bei LCF-Beanspruchung
- Mitteilungen/Notifications
- Personal
- Book Reviews
- Tagungen/Conferences
