Processing and Structure of Grain Boundaries in Strontium Titanate
-
Abstract
This article reports experimental studies on fabricating of well-defined bicrystals of SrTiO3 by diffusion bonding of single crystals in high vacuum. The bicrystals form a special tilt grain boundary with a fixed orientation. The atomistic structure and the composition of these grain boundaries in SrTiO3 are determined by advanced techniques of transmission electron microscopy.
Abstract
Untersuchungen zur Herstellung wohldefinierter SrTiO3-Zweikristalle mittels Diffusionsverschweißung von Einkristallen im Hochvakuum sind Gegenstand des vorliegenden Artikels. So können Zweikristalle mit einer speziellen Kippkorngrenze mit einer festgelegten Orientierung hergestellt werden. Die atomistische Struktur und die Zusammensetzung dieser Korngrenzen in SrTiO3 werden mit Methoden der Durchstrahlungselektronenmikroskopie bestimmt.
Literature
1 Wang, Z.L·; Kong, T.C.: Functional and Smart Materials, Plenum Press, New York/London (1998).10.1007/978-1-4615-5367-0Search in Google Scholar
2 Maier, J. : Festkörper – Fehler und Funktion. Prinzipien der Physikalischen Festkörperchemie, Teubner-Verlag, Stuttgart (2000).10.1007/978-3-322-80120-3Search in Google Scholar
3 Ikeda, J.S.; Chiang, Y.M.: J. Am. Ceram. Soc. 76 (1993) 2437–2446.10.1111/j.1151-2916.1993.tb03964.xSearch in Google Scholar
4 Ikeda, J.S.; Chiang, Y.M.; Garrattreed, A.J.; Vandersande, J.B.: J. Am. Ceram. Soc. 76(1993) 2447 – 2459.10.1111/j.1151-2916.1993.tb03965.xSearch in Google Scholar
5 Kienzle, O.: Ph. D. Thesis, University of Stuttgart (1999).Search in Google Scholar
6 Kienzle, O.; Exner, M.; Ernst, F.: Phys. Stat. Solidi. 166 (1998) 57 – 71.10.1002/(SICI)1521-396X(199803)166:1<57::AID-PSSA57>3.0.CO;2-SSearch in Google Scholar
7 Ernst, E; Kienzle, O.; Rühle, M.: J. Europ. Soc. 19 (1999) 665 – 673.Search in Google Scholar
8 Kienzle, O; Exner, M.; Ernst, F., in: D.J. Smith (ed.): Atomic Resolution Microscopy of Surfaces and Interfaces, Materials Research Society, Pittsburgh PA (1997).Search in Google Scholar
9 Denk, I.; Münch, W.; Maier, J.: J. Am. Ceram. Soc. 78 (1995) 3265 – 3272.10.1111/j.1151-2916.1995.tb07963.xSearch in Google Scholar
10 Mills, M.J.: Mater. Sci. Eng. A166 (1993) 35 – 50.10.1016/0921-5093(93)90308-2Search in Google Scholar
11 Fischmeister, H.F.; Elssner, G.; Gibbesch, B.; Kadow, K.-H.; Kawa, F.; Korn, D.; Mader, W.; Turwitt, M.: Rev. Sci. Instrum. 64 (1993) 234 – 242.10.1063/1.1144443Search in Google Scholar
12 Sutton, A.P.; Vitek, V: Phil. Trans. Roy. Soc. London A 309 (1983) 1 – 35.10.1098/rsta.1983.0020Search in Google Scholar
13 Pond, R.C.; Bollman, W.: Phil. Trans. Roy. Soc. London A 292 (1979) 449 – 472.10.1098/rsta.1979.0069Search in Google Scholar
14 Browning, N.D.; Pennycook, S.J.; Chisholm, M.F.; McGibbon, MM.; McGibbon, A.J.: Interi. Sci. 2 (1995) 397 – 423.Search in Google Scholar
15 Jiang, Q.D.; Pan, X.Q.; Zegenhagen, J.: Phys. Rev. B 56 (1997) 6947 – 6951.10.1103/PhysRevB.56.6947Search in Google Scholar
16 Müllejans, H.; Bruley, J.: J. Microscopy-Oxford 180 (1995) 12 – 21.10.1111/j.1365-2818.1995.tb03652.xSearch in Google Scholar
17 Clarke, D.R.: J. Am. Ceram. Soc. 70 (1987) 15 – 22.10.1111/j.1151-2916.1987.tb04846.xSearch in Google Scholar
© 2001 Carl Hanser Verlag, München
Articles in the same Issue
- Frontmatter
- Erratum
- Erratum
- Editorial
- In memoriam
- Aufsätze/Articles
- Low-temperature Processing of (Pb, La)(Zr, Ti) O3 Thick Films on Alumina Substrates
- Processing and Structure of Grain Boundaries in Strontium Titanate
- Stabilisation of MnZn Ferrites by the Re-oxidation of their Grain Boundaries
- Far-infrared Reflectivity Properties of BaTiO3 Ceramics
- Investigations on the Liquid Phase in Barium Titanate Ceramics with CuO Additives
- Chemical Engineering of Superconductive Rare-earth-Barium Cuprates: Melt Solidified Ceramics and Single Crystals
- Orthorhombic Titanium Aluminides: Phases, Phase Transformations and Microstructure Evolution
- Aspects of Sintering Additives for Processing and Microstructure Development of HIP-SSiC
- Investigation of Interlayer Phenomena in Ti/Pt Electrodes for Ferroelectric Thin Film Devices
- The Designing of Properties of Hydroxyapatite/Poly-l-lactide Composite Biomaterials by Hot Pressing
- Hydrolysis Assisted Solidification Process and its Use in Ceramic Wet Forming
- A Model for the Formation of Interdendritic Cavities from Pores Pre-existing in the Melt
- Pendeo-epitaxial Growth and Characterization of Thin Films of Gallium Nitride and Related Materials on SiC(0001) and Si(111) Substrates
- The Effect of Hydrogen Absorption and Desorption on Ta-doped SmFe Nitrides
- The Ternary System Fe–Nd–C
- Mechanical Properties of the Industrial HK40 Reforming Tubes Produced by an Improved Centrifugal Processing
- Texture of Hot Rolled and Annealed Binary Ti –Mn Alloys
- Finite-Element-Simulation des Faserverhalten metallischer Verbundwerkstoffe bei LCF-Beanspruchung
- Mitteilungen/Notifications
- Personal
- Book Reviews
- Tagungen/Conferences
Articles in the same Issue
- Frontmatter
- Erratum
- Erratum
- Editorial
- In memoriam
- Aufsätze/Articles
- Low-temperature Processing of (Pb, La)(Zr, Ti) O3 Thick Films on Alumina Substrates
- Processing and Structure of Grain Boundaries in Strontium Titanate
- Stabilisation of MnZn Ferrites by the Re-oxidation of their Grain Boundaries
- Far-infrared Reflectivity Properties of BaTiO3 Ceramics
- Investigations on the Liquid Phase in Barium Titanate Ceramics with CuO Additives
- Chemical Engineering of Superconductive Rare-earth-Barium Cuprates: Melt Solidified Ceramics and Single Crystals
- Orthorhombic Titanium Aluminides: Phases, Phase Transformations and Microstructure Evolution
- Aspects of Sintering Additives for Processing and Microstructure Development of HIP-SSiC
- Investigation of Interlayer Phenomena in Ti/Pt Electrodes for Ferroelectric Thin Film Devices
- The Designing of Properties of Hydroxyapatite/Poly-l-lactide Composite Biomaterials by Hot Pressing
- Hydrolysis Assisted Solidification Process and its Use in Ceramic Wet Forming
- A Model for the Formation of Interdendritic Cavities from Pores Pre-existing in the Melt
- Pendeo-epitaxial Growth and Characterization of Thin Films of Gallium Nitride and Related Materials on SiC(0001) and Si(111) Substrates
- The Effect of Hydrogen Absorption and Desorption on Ta-doped SmFe Nitrides
- The Ternary System Fe–Nd–C
- Mechanical Properties of the Industrial HK40 Reforming Tubes Produced by an Improved Centrifugal Processing
- Texture of Hot Rolled and Annealed Binary Ti –Mn Alloys
- Finite-Element-Simulation des Faserverhalten metallischer Verbundwerkstoffe bei LCF-Beanspruchung
- Mitteilungen/Notifications
- Personal
- Book Reviews
- Tagungen/Conferences
