Contents

Articles in the same Issue

1. Contents
2. Contents
3. Regular Contributed Articles
4. A Study of Integration of LIGA and M-EDM Technology on the Micro Injection Molding of Super Thin Plates with Micro Through Holes
5. Carbon Black Filled Polyester as Electrically Conductive Master Batch for Fibers
6. Tip-clearance Effect on Mixing Performance of Twin Screw Extruders
7. Structure Development in Melt Spinning and Cold Drawing of Poly(ethylene-co-octene) Copolymer
8. Effect of Distributor Geometry on Crimp Contraction of PET Side-by-side Bicomponent Fibers
9. Effect of Compatibilizer Distribution on Thermal and Rheological Properties of Gelatinized Starch/Biodegradable Polyesters Blends
10. Numerical Simulation of the Effect of Processing Parameters on the Flow Behavior and Break-through Phenomenon in Co-Injection Molding
11. Study of Shrinkage and Warpage in Microcellular Co-Injection Molding
12. Melting Temperature Characteristics for Polyethylenes from Crystal Size Distribution
13. Experimental/Numerical Analysis of Chaotic Advection in a Three-dimensional Cavity Flow
14. A Numerical Investigation on the Cure Cycle of Composite Brake Blocks
15. PPS News
16. PPS News
17. Seikei-Kakou Abstracts
18. Seikei-Kakou Abstracts