Artikel
Open Access
Experimental investigation of gas/slag/matte/tridymite equilibria in the Cu–Fe–O–S–Si system in controlled gas atmosphere at T = 1 200 °C and P(SO2) = 0.1 atm
-
Ata Fallah-Mehrjardi
Veröffentlicht/Copyright:
3. Juni 2019
Received: 2019-07-16
Accepted: 2019-12-10
Published Online: 2019-06-03
Published in Print: 2019-06-12
© 2019, Carl Hanser Verlag, München
Artikel in diesem Heft
- Original Contributions
- Experimental investigation of gas/slag/matte/tridymite equilibria in the Cu–Fe–O–S–Si system in controlled gas atmosphere at T = 1 200 °C and P(SO2) = 0.1 atm
- Thermodynamic calculation of phase equilibria in the Bi–Mg–Zn ternary system
- Effect of pre-rafting on creep properties of Ni-based single crystal superalloy
- Effect of thermomechanical treatment on the microstructures and mechanical properties of an ultrafine grained steel using bainite starting microstructure
- Deformation response and microstructural evolution of as-cast Mg alloys AM30 and AM50 during hot compression
- Effects of graphene nanoplatelets on the tribological, mechanical, and thermal properties of Mg-3Al alloy nanocomposites
- Increasing cold workability of Ti-6Al-4V alloy via thermo-mechanical processing: simulation and experiment
- Synthesis, characterization, and possible application as sorbents of new low-cost aluminosilicate materials with different Si/Al ratios
- Self-assembly of Pd@Au core/shell nanosheets used as a highly sensitive SERS substrate based on the determination of trace fluorescent dye
- Short Communications
- On the material characteristics of a high carbon cast austenitic stainless steel after solution annealing followed by quenching in a CNT nanofluid
- Influence of in-situ Al2O3 content on mechanical properties of Al2O3 reinforced Fe–Cr–Ni alloys
- Novel synthesis of Ti2SC powder using FeS2 as a sulphur source
Schlagwörter für diesen Artikel
Copper smelting;
Copper slag;
Copper matte;
Phase equilibria
Creative Commons
BY 4.0
Artikel in diesem Heft
- Original Contributions
- Experimental investigation of gas/slag/matte/tridymite equilibria in the Cu–Fe–O–S–Si system in controlled gas atmosphere at T = 1 200 °C and P(SO2) = 0.1 atm
- Thermodynamic calculation of phase equilibria in the Bi–Mg–Zn ternary system
- Effect of pre-rafting on creep properties of Ni-based single crystal superalloy
- Effect of thermomechanical treatment on the microstructures and mechanical properties of an ultrafine grained steel using bainite starting microstructure
- Deformation response and microstructural evolution of as-cast Mg alloys AM30 and AM50 during hot compression
- Effects of graphene nanoplatelets on the tribological, mechanical, and thermal properties of Mg-3Al alloy nanocomposites
- Increasing cold workability of Ti-6Al-4V alloy via thermo-mechanical processing: simulation and experiment
- Synthesis, characterization, and possible application as sorbents of new low-cost aluminosilicate materials with different Si/Al ratios
- Self-assembly of Pd@Au core/shell nanosheets used as a highly sensitive SERS substrate based on the determination of trace fluorescent dye
- Short Communications
- On the material characteristics of a high carbon cast austenitic stainless steel after solution annealing followed by quenching in a CNT nanofluid
- Influence of in-situ Al2O3 content on mechanical properties of Al2O3 reinforced Fe–Cr–Ni alloys
- Novel synthesis of Ti2SC powder using FeS2 as a sulphur source