Tribological performance and corrosion behavior of aluminum alloy protected by Cr-doped diamond-like carbon thin film
-
Xiaoyu Yang
, Hong Xu , Hongkui Mao , Gang Wang , Wei Liu , Wei Gao und Lideng Zhu
Abstract
A gradient layer of Al/Cr diamond-like carbon film has been prepared by magnetron sputtering on 2024 Al-alloy. Emphasis has been placed on the anti-corrosion and tribological properties of the Cr-doped diamond-like film. Experimental research: scanning electron microscopy, X-ray photoelectron spectroscopy, Raman spectrometry, nano-indentation testing, potentiodynamic polarization, electrochemical impedance spectroscopy and tribological tests were undertaken to investigate the surface morphology, surface structures, chemical composition, anti-corrosion and mechanical properties of the as-prepared gradient diamond-like carbon film. The results indicated that the Cr-doped diamond-like carbon film with intermediate transition chromium layer showed improvements with regards to hardness and corrosion prevention due to the dense surface structure and decreased electrical conductivity. Cr-doped diamond-like carbon film also displayed excellent tribological properties such as a low friction coefficient and wear rate during tribological testing.
References
[1] J.X.Liao, L.F.Xia, M.R.Sun, Y.Sun, W.M.Liu, T.Xu, Q.J.Xue: Wear256 (2004) 840. 10.1016/s0043-1648(03)00521-0Suche in Google Scholar
[2] L.Guzman, G.Bonini, M.Adami, P.M.Ossi, A.Miotello, M.Vittori-Antisari, A.M.Serventi, E.Voltolini: Surf. Coat. Technol.83 (1996) 284. 10.1016/0257-8972(95)02795-5Suche in Google Scholar
[3] Y.Lifshitz: Diamond Relat. Mater.5 (1996) 388. 10.1016/0925-9635(95)00445-9Suche in Google Scholar
[4] Q.Ding, L.Wang, Y.Wang, S.C.Wang, L.Hu, Q.Xue: Tribol. Lett.41 (2010) 439. 10.1007/s11249-010-9730-1Suche in Google Scholar
[5] K.Y.Fu, Y.F.Mei, M.Y.Fu, X.Y.Liu, P.K.Chu: Diamond Relat. Mater.14 (2005) 1489. 10.1016/j.diamond.2005.03.006Suche in Google Scholar
[6] N.W.Khun, E.Liu: J. Nanosci. Nanotechnol.10 (2010) 4767. 21128496; 10.1166/jnn.2010.1682Suche in Google Scholar PubMed
[7] C.Donnet, J.Fontaine, A.Grill, T.L.Mognea: Tribol. Lett.9 (2000) 137. 10.1007/s11249-004-8077-xSuche in Google Scholar
[8] A.ErdemirU, O.L.Eryilmaz, I.B.Nilufer, G.R.Fenske: Surf. Coat. Technol.133–134 (2000) 448. 10.1016/S0257-9872(00)00968-3Suche in Google Scholar
[9] H.Ronkainen, S.Varjus, J.Koskinen, K.Holmberg: Wear249 (2001) 260. 10.1016/S0043-1648(01)00558-0Suche in Google Scholar
[10] Y.L.Su, W.H.Kao: J. Mater. Eng. Perform.9 (2000) 38. 10.1361/105994900770346268Suche in Google Scholar
[11] S.Aisenberg: J. Appl. Phys.42 (1971) 2953. 10.1063/1.1660654Suche in Google Scholar
[12] M.C.Polo, J.L.Andu′jara, A.Hartb, J.Robertson, W.I.Milne: Diamond Relat. Mater.9 (2000) 663. 10.1016/S0925-9635(99)00339-8Suche in Google Scholar
[13] M.Umeno, S.Adhikary: Diamond Relat. Mater.14 (2005) 1973. 10.1016/j.diamond.2005.09.030Suche in Google Scholar
[14] T.Mikami, H.Nakazawa, M.Kudo, M.Mashita: Thin Solid Films488 (2005) 87. 10.1016/j.tsf.2005.04.064Suche in Google Scholar
[15] A.Hu, I.Alkhesho, H.Zhou, W.W.Duley: Diamond Relat. Mater.16 (2007) 149. 10.1016/j.diamond.2006.04.008Suche in Google Scholar
[16] C.Srividya, S.V.Babu: Chem. Mater.8 (1996) 2528. 10.1021/cm9601594Suche in Google Scholar
[17] W.Dai, H.Zheng, G.Wu, A.Wang: Vacuum85 (2010) 231. 10.1016/j.vacuum.2010.06.001Suche in Google Scholar
[18] W.M.Silva, J.R.Carneiro, V.J.Trava-Airoldi: Diamond Relat. Mater.42 (2014) 58. 10.1016/j.diamond.2013.12.004Suche in Google Scholar
[19] C.Liu, D.Hu, J.Xu, D.Yang, M.Qi: Thin Solid Films496 (2006) 457. 10.1016/j.tsf.2005.09.109Suche in Google Scholar
[20] J.Robertson: Mater. Sci. Eng. R37 (2002) 129. 10.1016/S0927-796X(02)00005-0Suche in Google Scholar
[21] Y.Qi, E.Konca, A.T.Alpas: Surf. Sci.600 (2006) 2955. 10.1016/j.susc.2006.05.008Suche in Google Scholar
[22] G.W.Malaczynski, A.H.Hamdi, A.A.Elmoursi, X.Qiu: Surf. Coat. Technol.93 (1997) 280. 10.1016/S0257-8972(97)00061-3Suche in Google Scholar
[23] J.Ou, W.Hu, M.Xue, F.Wang, W.Li: ACS Appl. Mater. Interfaces5 (2013) 3101. 10.1021/am4000134Suche in Google Scholar PubMed
[24] L.Qin, W.Zhao, H.Hou, Y.Jin, Z.Zeng, X.Wu, Q.Xue: RSC Adv.4 (2014) 60307. 10.1039/c4ra10112jSuche in Google Scholar
[25] S.Viswanathan, L.Mohan, P.Bera, V.P.Kumar, H.C.Barshilia, C.Anandan: J. Mater. Eng. Perform.26 (2017) 3633. 10.1007/s11665-017-2783-7Suche in Google Scholar
[26] S.Gayathri, N.Kumar, R.Krishnan, T.R.Ravindran, S.Amirthapandian, S.Dash, A.K.Tyagi, M.Sridharan: Ceram. Int.41 (2015) 1797. 10.1016/j.ceramint.2014.09.125Suche in Google Scholar
[27] S.Gayathri, N.Kumar, R.Krishnan, T.R.Ravindran, S.Dash, A.K.Tyagi, M.Sridharan: Mater. Chem. Phy.167 (2015) 194. 10.1016/j.matchemphys.2015.10.031Suche in Google Scholar
[28] F.C.Tai, S.C.Lee, J.Chen, C.Wei, S.H.Chang: J. Raman Spectrosc.40 (2009) 1055. 10.1002/jrs.2234Suche in Google Scholar
[29] T.Benabbouha, M.Siniti, H. ElAttari, K.Chefira, F.Chibi, R.Nmila, H.Rchid: Journal of Bio- and Tribo-Corros.4 (2018). 10.1007/s40735-018-0161-0Suche in Google Scholar
[30] S.Viswanathan, L.Mohan, P.Bera, S.Shanthiswaroop, M.Muniprakash, H.C.Barshilia, C.Anandan: Surf. Interface Anal.50 (2018) 265. 10.1002/sia.6353Suche in Google Scholar
[31] C.Casiraghi, A.Ferrari, J.Robertson: Phys. Rev. B72 (2005). 10.1103/PhysRevB.72.085401Suche in Google Scholar
[32] J.Kovac, G.Scarel, M.Sancrotti, M.G.Beghi, C.E.Bottani, P.M.Ossi, L.Calliari, M.Bonelli, A.Miotello: J. Appl. Phys.86 (1999) 5566. 10.1063/1.371561Suche in Google Scholar
[33] B.Schultrich, H.-J.Scheibe, D.Drescher, H.Ziegele: Surf. Coat. Technol.98 (1998) 1097. 10.1016/S0257-8972(97)00386-1Suche in Google Scholar
[34] C.Wang, S.Yang, Q.Wang, Z.Wang, J.Zhang: J. Appl. Phys.103 (2008) 123531. 10.1063/1.2938747Suche in Google Scholar
[35] J.Ou, W.Hu, M.Xue, F.Wang, W.Li: ACS Appl. Mater. Interfaces5 (2013) 9867. 10.1021/am402303jSuche in Google Scholar PubMed
[36] V.Mišković-Stanković, I.Jevremović, I.Jung, K.Rhee: Carbon75 (2014) 335. 10.1016/j.carbon.2014.04.012Suche in Google Scholar
[37] S.V.Lamaka, M.L.Zheludkevich, K.A.Yasakau, R.Serra, S.Poznyak, M.Ferreira: Prog. Org. Coat.58 (2007) 127. 10.1016/j.porgcoat.2006.08.029Suche in Google Scholar
[38] M.L.Zheludkevich, R.Serra, M.F.Montemor, K.A.Yasakau, I.M.M.Salvado, M.G.S.Ferreira: Electrochim. Acta51 (2005) 208. 10.1016/j.electacta.2005.04.021Suche in Google Scholar
[39] M.Zamanzade, A.Barnoush: Corros. Sci.78 (2014) 223. 10.1016/j.corsci.2013.10.002Suche in Google Scholar
[40] T.L.Schmitz, J.E.Action, D.L.Burris, J.C.Ziegert, W.G.Sawyer: J. Tribol.126 (2004) 802. 10.1115/1.1792675Suche in Google Scholar
© 2019, Carl Hanser Verlag, München
Artikel in diesem Heft
- Contents
- Contents
- Original Contributions
- Relationship between the variation in transformation temperatures, resistivity and dislocation density during thermal cycling of Ni50Ti50 shape memory alloy
- A critical analysis of the X-ray diffraction intensities in concentrated multicomponent alloys
- Thermodynamic investigations in the Al–Fe system: Thermodynamic modeling using CALPHAD
- Investigation of semi-solid microstructures of an A356 alloy containing rare-earth Gd during isothermal heat treatment
- Effects of double-ageing on the mechanical properties and microstructural evolution in the 1460 alloy
- Mechanical properties characterisation of AlSi10Mg parts produced by laser powder bed fusion additive manufacturing
- Tribological performance and corrosion behavior of aluminum alloy protected by Cr-doped diamond-like carbon thin film
- Effect of sintering temperature on the densification and optical properties of spark plasma sintered ZnSe ceramics
- Mono-crystalline SnTe with micro-octahedroncharacteristic: One-pot facile synthesis and comprehensive crystallographic evidence
- Finite element simulation of the residual stress in Ti6Al4V titanium alloy laser welded joint
- Short Communications
- Mechanism of the effect of electron beam melting on the distribution of oxygen, nitrogen and carbon in silicon
- Synthesis and study of structural, morphological, optical and toxicological properties of ferromagnetic cobalt oxide nanoparticles in liver carcinoma cell line
- DGM News
- DGM News
Artikel in diesem Heft
- Contents
- Contents
- Original Contributions
- Relationship between the variation in transformation temperatures, resistivity and dislocation density during thermal cycling of Ni50Ti50 shape memory alloy
- A critical analysis of the X-ray diffraction intensities in concentrated multicomponent alloys
- Thermodynamic investigations in the Al–Fe system: Thermodynamic modeling using CALPHAD
- Investigation of semi-solid microstructures of an A356 alloy containing rare-earth Gd during isothermal heat treatment
- Effects of double-ageing on the mechanical properties and microstructural evolution in the 1460 alloy
- Mechanical properties characterisation of AlSi10Mg parts produced by laser powder bed fusion additive manufacturing
- Tribological performance and corrosion behavior of aluminum alloy protected by Cr-doped diamond-like carbon thin film
- Effect of sintering temperature on the densification and optical properties of spark plasma sintered ZnSe ceramics
- Mono-crystalline SnTe with micro-octahedroncharacteristic: One-pot facile synthesis and comprehensive crystallographic evidence
- Finite element simulation of the residual stress in Ti6Al4V titanium alloy laser welded joint
- Short Communications
- Mechanism of the effect of electron beam melting on the distribution of oxygen, nitrogen and carbon in silicon
- Synthesis and study of structural, morphological, optical and toxicological properties of ferromagnetic cobalt oxide nanoparticles in liver carcinoma cell line
- DGM News
- DGM News