Home Investigation of the influence of Fe on the microstructure and properties of Ti5553 near-β titanium alloy with combinatorial approach
Article
Licensed
Unlicensed Requires Authentication

Investigation of the influence of Fe on the microstructure and properties of Ti5553 near-β titanium alloy with combinatorial approach

  • Di Wu , Ligang Zhang , Libin Liu , Xi Shi , Shuaixiong Huang and Yun Jiang
Published/Copyright: May 4, 2017
Become an author with De Gruyter Brill
Author Information
International Journal of Materials Research
From the journal International Journal of Materials Research Volume 108 Issue 5

Abstract

A combinatorial approach has been applied to build the database of composition dependent microstructure and hardness of the Ti5553–Fe system. The relationship between the composition and microstructure as well as the hardness was obtained. (Ti5553)96-Fe4 was found to have almost the same hardness as that of Ti5553, but a relatively coarser intragranular α phase. High-angle annular dark field imaging revealed that Fe mainly concentrated in the β phase, which strengthened the β phase through solution strengthening. This means that (Ti5553)96-Fe4 may have the same strength as that of Ti5553 but higher fracture toughness. The formation of FeCr compound consumed the β stabilizer elements Fe and Cr, which led to unusual increasing of the nucleation rate and the volume fraction of α phase in (Ti5553)88-Fe12.

Keywords: Near-β titanium alloy; Diffusion multiple; Microstructure; Hardness
*Correspondence address, Libin Liu, Ligang Zhang, School of Material Science and Engineering, Central South University, Lushan Road 932, Changsha, Hunan, 410083, P. R. China, Tel.: +86073188877732, Fax: +86073188876692, E-mail: (Libin Liu, Professor) (Ligang Zhang, Dr.)

References

[1] D.Banerjee, J.C.Williams: Acta Mater.61 (2013) 844. 10.1016/j.actamat.2012.10.043Search in Google Scholar

[2] R.R.Boyer: Mater. Sci. Eng. A213 (1996) 103. 10.1016/0921-5093(96)10233-1Search in Google Scholar

[3] J.C.Fanning: J. Mater. Eng. Perform.14 (6) (2005) 788. 10.1361/105994905X75628Search in Google Scholar

[4] N.G.Jones, R.J.Dashwood, D.Dye, M.Jackson: Mater. Sci. Eng. A490 (2008) 369. 10.1016/j.msea.2008.01.055Search in Google Scholar

[5] J.Huang, Z.Wang, K.Xue: Mater. Sci. Eng. A528 (2011) 8723. 10.1016/j.msea.2011.08.045Search in Google Scholar

[6] N.G.Jones, R.J.Dashwood, M.Jackson, D.Dye: Scr. Mater.60 (2009) 571. 10.1016/j.scriptamat.2008.12.010Search in Google Scholar

[7] S.Nag, R.Banerjee, J.Y.Hwang, M.Harper, H.L.Fraser: Philos. Mag. A89 (2009) 6. 10.1080/14786430802613158Search in Google Scholar

[8] S.Nag, R.Banerjee, R.Srinivasan, J.Y.Hwang, M.Harper, H.L.Fraser: Acta Mater.57 (2009) 2136. 10.1016/j.actamat.2009.01.007Search in Google Scholar

[9] S.L.Raghunathan, A.M.Stapleton, R.J.Dashwood, M.Jackson, D.Dye: Acta Mater. 55 (2007) 6861. 10.1016/j.actamat.2007.08.049Search in Google Scholar

[10] Y.Ohmori, T.Ogo, K.Nakai, S.Kobayashi: Mater. Sci. Eng.A312 (2001) 182. 10.1016/S0921-5093(00)01891-8Search in Google Scholar

[11] W.F.Ho, C.H.Pan, S.C.Wu, H.C.Hsu: J. Alloys Compd.472 (2009) 546. 10.1016/j.jallcom.2008.05.015Search in Google Scholar

[12] S.X.Huang, X.D.Zhang, Y.Jiang, Y.R.Jiang, C.Mao, D.Wu, L.G.Zhang, L.B.Liu: Mater. Des.115 (2017) 170. 10.1016/j.matdes.2016.11.056Search in Google Scholar

[13] Y.R.Jiang, X.Li, Y.Jiang, S.X.Huang, X.Shi, C.Mao, L.G.Zhang, L.B.Liu, F.Zheng: CALPHAD56 (2017) 1. 10.1016/j.calphad.2016.11.004Search in Google Scholar

[14] C.M.Lee, W.F.Ho, C.P.Ju: J. Mater. Sci.-Mater. Med.13 (2002) 695. PMid:15348579; 10.1023/A:1015798011434Search in Google Scholar

[15] J.Das, K.B.Kim, W.Xu, W.Loser, J.Eckert: Mater. Sci. Eng.A449 (2007) 737. 10.1016/j.msea.2006.02.374Search in Google Scholar

[16] R.Banerjee, S.Nag, J.Stechschulte, H.L.Fraser: Biomaterials25 (2004) 3413. PMid:15020114; 10.1016/j.biomaterials.2003.10.041Search in Google Scholar

[17] J.C.Zhao: Prog. Mater. Sci.51 (2006) 557. 10.1016/j.pmatsci.2005.10.001Search in Google Scholar

[18] J.C.Zhao: Adv. Eng. Mater.3 (2001) 143. 10.1007/BF02700985Search in Google Scholar

[19] J.C.Zhao, X.Zheng, D.G.Cahill: Mater. Today12 (2005) 28. 10.1016/S1369-7021(05)71122-6Search in Google Scholar

[20] J.C.Zhao: Annu. Rev. Mater. Res.35 (2005) 51. 10.1146/annurev.matsci.35.100303.111314Search in Google Scholar

[21] X.D.Zhang, L.B.Liu, J.C.Zhao, J.L.Wang, F.Zheng, Z.P.Jin: Mater. Sci. Eng. C39 (2014) 273. PMid:24863225; 10.1016/j.msec.2014.02.039Search in Google Scholar

[22] W.C.Oliver, G.M.Pharr: J. Mater. Res.7 (1992) 1564. 10.1557/JMR.1992.1564Search in Google Scholar

[23] N.Chollacoop, M.Dao, S.Suresh: Acta Mater.51 (2003) 3713. 10.1016/S1359-6454(03)00186-1Search in Google Scholar

[24] S.Nag, Y.Zheng, R.E.A.Williams, A.Devaraj, A.Boyne, Y.Wang, P.C.Collins, G.B.Viswanathan, J.S.Tiley, B.C.Muddle, R.Banerjee, H.L.Fraser: Acta Mater.60 (2012) 6247. 10.1016/j.actamat.2012.07.033Search in Google Scholar

[25] S.K.Kar, A.Ghosh, N.Fulzele, A.Bhattacharjee: Mater. Charact.81 (2013) 37. 10.1016/j.matchar.2013.03.016Search in Google Scholar

[26] Y.F.Zheng: PhD thesis, Nucleation Mechanisms of Refined Alpha Microstructure in Beta Titanium Alloys, The Ohio State University, USA (2013).Search in Google Scholar

[27] V.A.Bykov, T.V.Kulikova, L.B.Vedmid, A.Y.Fishman, K.Y.Shunyaev, N.Y.Tarenkova: Phys. Met. Metall.115 (2014) 705. 10.1134/S0031918X14050020Search in Google Scholar

[28] H.C.Hsua, C.H.Pan, S.C.Wu, W.F.Ho: J. Alloys Compd.474 (2009) 578. 10.1016/j.jallcom.2008.07.003Search in Google Scholar

[29] D.Y.Qin, Y.F.Lu, Q.Liu, L.Zhou: Mater. Sci. Eng. A561 (2013) 460. 10.1016/j.msea.2013.02.029Search in Google Scholar

[30] N.Wain, X.J.Hao, G.A.Ravi, X.Wu: Mater. Sci. Eng. A527 (2010) 7673. 10.1016/j.msea.2010.08.032Search in Google Scholar

[31] A.Ghosh, S.Sivaprasad, A.Bhattacharjee, S.K.Kar: Mater. Sci. Eng. A568 (2013) 61. 10.1016/j.msea.2013.01.017Search in Google Scholar

[32] D.Y.Qin, Y.FLu, D.ZGuo, L.Zheng, Q.Liu, L.Zhou: Mater. Sci. Eng. A587 (2013) 100. 10.1016/j.msea.2013.08.055Search in Google Scholar

[33] S.Nag: PhD thesis, Influence of Beta Instabilities on the Early Stages of Nucleation and Growth of Alpha in Beta Titanium Alloys, The Ohio State University, USA (2008).Search in Google Scholar

[34] T.Furuhara, T.Maki, T.Makino: J. Mater. Process. Technol.117 (2001) 318. 10.1016/S0924-0136(01)00790-Search in Google Scholar

[35] M.Ahmed, T.Li, G.Casillas, J.M.Cairney, D.Wexler, E.V.Pereloma: J. Alloys Compd.629 (2015) 260. 10.1016/j.jallcom.2015.01.005Search in Google Scholar

Received: 2016-09-01
Accepted: 2017-01-17
Published Online: 2017-05-04
Published in Print: 2017-05-15

© 2017, Carl Hanser Verlag, München

Articles in the same Issue

  1. Contents
  2. Contents
  3. Editorial
  4. Downloads and the impact of Open Access at IJMR
  5. Original Contributions
  6. A material selection approach using the TODIM (TOmada de Decisao Interativa Multicriterio) method and its analysis
  7. Investigation of the influence of Fe on the microstructure and properties of Ti5553 near-β titanium alloy with combinatorial approach
  8. Evolution of the temperature, microstructures and microsegregation in equiaxed solidification of Al-5 wt.% Cu alloy
  9. Phase composition and microstructure of materials in the Ir–Ru–B system prepared by arc melting and VHP sintering
  10. Thermal shock behavior of rare earth modified alumina ceramic composites
  11. Investigation of tribological and corrosion properties of CuTi–alumina nanocomposite fabricated by mechanical alloying
  12. Effect of acetic acid on corrosion behavior of AISI 201, 304 and 430 stainless steels
  13. Verification of strength mis-match of electron beam welded heavy thickness titanium alloy
  14. Short Communications
  15. Effect of toughening Fe2B by the addition of tungsten on the wear resistance of Fe–B–C alloy
  16. Microstructural stability of heat-resistant high-pressure die-cast Mg-4Al-4Ce alloy
  17. DGM News
  18. DGM News
https://doi.org/10.3139/146.111487
Keywords for this article
Near-β titanium alloy; Diffusion multiple; Microstructure; Hardness

Articles in the same Issue

  1. Contents
  2. Contents
  3. Editorial
  4. Downloads and the impact of Open Access at IJMR
  5. Original Contributions
  6. A material selection approach using the TODIM (TOmada de Decisao Interativa Multicriterio) method and its analysis
  7. Investigation of the influence of Fe on the microstructure and properties of Ti5553 near-β titanium alloy with combinatorial approach
  8. Evolution of the temperature, microstructures and microsegregation in equiaxed solidification of Al-5 wt.% Cu alloy
  9. Phase composition and microstructure of materials in the Ir–Ru–B system prepared by arc melting and VHP sintering
  10. Thermal shock behavior of rare earth modified alumina ceramic composites
  11. Investigation of tribological and corrosion properties of CuTi–alumina nanocomposite fabricated by mechanical alloying
  12. Effect of acetic acid on corrosion behavior of AISI 201, 304 and 430 stainless steels
  13. Verification of strength mis-match of electron beam welded heavy thickness titanium alloy
  14. Short Communications
  15. Effect of toughening Fe2B by the addition of tungsten on the wear resistance of Fe–B–C alloy
  16. Microstructural stability of heat-resistant high-pressure die-cast Mg-4Al-4Ce alloy
  17. DGM News
  18. DGM News
Sign up now to receive a 20% welcome discount
Institutional Access
How does access work?
Have an idea on how to improve our website?
Please write us.
© 2025 De Gruyter Brill
Downloaded on 16.11.2025 from https://www.degruyterbrill.com/document/doi/10.3139/146.111487/html
Scroll to top button