Contents

Articles in the same Issue

1. Contents
2. Contents
3. Editorial
4. Downloads and the impact of Open Access at IJMR
5. Original Contributions
6. A material selection approach using the TODIM (TOmada de Decisao Interativa Multicriterio) method and its analysis
7. Investigation of the influence of Fe on the microstructure and properties of Ti5553 near-β titanium alloy with combinatorial approach
8. Evolution of the temperature, microstructures and microsegregation in equiaxed solidification of Al-5 wt.% Cu alloy
9. Phase composition and microstructure of materials in the Ir–Ru–B system prepared by arc melting and VHP sintering
10. Thermal shock behavior of rare earth modified alumina ceramic composites
11. Investigation of tribological and corrosion properties of CuTi–alumina nanocomposite fabricated by mechanical alloying
12. Effect of acetic acid on corrosion behavior of AISI 201, 304 and 430 stainless steels
13. Verification of strength mis-match of electron beam welded heavy thickness titanium alloy
14. Short Communications
15. Effect of toughening Fe₂B by the addition of tungsten on the wear resistance of Fe–B–C alloy
16. Microstructural stability of heat-resistant high-pressure die-cast Mg-4Al-4Ce alloy
17. DGM News
18. DGM News