Skip to main content
Article Publicly Available

Downloads and the impact of Open Access at IJMR

Published/Copyright: May 4, 2017
Download Article (PDF)
Become an author with De Gruyter Brill
Submit Manuscript Author Information
International Journal of Materials Research
From the journal International Journal of Materials Research Volume 108 Issue 5

Published Online: 2017-05-04
Published in Print: 2017-05-15

© 2017, Carl Hanser Verlag, München

Articles in the same Issue

  1. Contents
  2. Contents
  3. Editorial
  4. Downloads and the impact of Open Access at IJMR
  5. Original Contributions
  6. A material selection approach using the TODIM (TOmada de Decisao Interativa Multicriterio) method and its analysis
  7. Investigation of the influence of Fe on the microstructure and properties of Ti5553 near-β titanium alloy with combinatorial approach
  8. Evolution of the temperature, microstructures and microsegregation in equiaxed solidification of Al-5 wt.% Cu alloy
  9. Phase composition and microstructure of materials in the Ir–Ru–B system prepared by arc melting and VHP sintering
  10. Thermal shock behavior of rare earth modified alumina ceramic composites
  11. Investigation of tribological and corrosion properties of CuTi–alumina nanocomposite fabricated by mechanical alloying
  12. Effect of acetic acid on corrosion behavior of AISI 201, 304 and 430 stainless steels
  13. Verification of strength mis-match of electron beam welded heavy thickness titanium alloy
  14. Short Communications
  15. Effect of toughening Fe2B by the addition of tungsten on the wear resistance of Fe–B–C alloy
  16. Microstructural stability of heat-resistant high-pressure die-cast Mg-4Al-4Ce alloy
  17. DGM News
  18. DGM News
https://doi.org/10.3139/146.017051

Articles in the same Issue

  1. Contents
  2. Contents
  3. Editorial
  4. Downloads and the impact of Open Access at IJMR
  5. Original Contributions
  6. A material selection approach using the TODIM (TOmada de Decisao Interativa Multicriterio) method and its analysis
  7. Investigation of the influence of Fe on the microstructure and properties of Ti5553 near-β titanium alloy with combinatorial approach
  8. Evolution of the temperature, microstructures and microsegregation in equiaxed solidification of Al-5 wt.% Cu alloy
  9. Phase composition and microstructure of materials in the Ir–Ru–B system prepared by arc melting and VHP sintering
  10. Thermal shock behavior of rare earth modified alumina ceramic composites
  11. Investigation of tribological and corrosion properties of CuTi–alumina nanocomposite fabricated by mechanical alloying
  12. Effect of acetic acid on corrosion behavior of AISI 201, 304 and 430 stainless steels
  13. Verification of strength mis-match of electron beam welded heavy thickness titanium alloy
  14. Short Communications
  15. Effect of toughening Fe2B by the addition of tungsten on the wear resistance of Fe–B–C alloy
  16. Microstructural stability of heat-resistant high-pressure die-cast Mg-4Al-4Ce alloy
  17. DGM News
  18. DGM News
Downloaded on 24.4.2026 from https://www.degruyterbrill.com/document/doi/10.3139/146.017051/html?lang=en
Scroll to top button