Startseite Morphology evolution of γ′ precipitates in GTD-111 Ni-based superalloy with heat treatment parameters
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

Morphology evolution of γ′ precipitates in GTD-111 Ni-based superalloy with heat treatment parameters

  • Mohamad Berahmand und Seyed Abdolkarim Sajjadi
Veröffentlicht/Copyright: 30. März 2014
Veröffentlichen auch Sie bei De Gruyter Brill
Informationen für Autor*innen
International Journal of Materials Research
Aus der Zeitschrift International Journal of Materials Research Band 104 Heft 3

Abstract

GTD-111 is an Ni-based superalloy used in manufacturing of gas turbine blades. The superalloy attains appropriate high temperature strength through precipitation hardening. In this research the effect of isothermal aging on the morphology evolution and characteristics of precipitates was investigated. Two different heat treatment cycles were applied to the specimens. In cycle I all samples were solution-treated at 1 200 °C for 4 h and water quenched to obtain supersaturated solid solution. A microstructure containing fine γ′ precipitates was produced after heat treatment cycle I. The second heat treatment, cycle II, consisted of reheating of the specimens in the precipitate partial dissolution zone at 1 150 °C for 2 h to get coarse primary precipitates, and then water quenching to obtain fine secondary precipitates. The precipitate coarsening in the fine and duplex size precipitate distribution was studied by means of aging of the specimens for various times at 1 000 °C. The results showed that during long-term annealing of the single size distribution (Cycle Ι), precipitates line up to reduce interactive free energy and grow to fairly coarse sizes along a direction. In cycle ΙΙ, the precipitates were split into a group of eight small cuboids or pairs of parallel plates and a large number of γ′ particles were closely aligned along a direction.

Keywords: GTD-111; γ′ precipitate; Coarsening; Splitting; Rafting
* Correspondence address, Seyed Abdolkarim Sajjadi, Dept. of Department of Metallurgical and Materials Engineering, Faculty of Engineering, Ferdowsi University of Mashhad, Vakil-Abad Blvd., Mashhad, Iran. Tel./Fax: 0098-511-8763305, E-mail:

References

[1] S.A.Sajjadi, S.Nategh: Mater. Sci. Eng. A307 (2001) 158–164. 10.1016/S0921-5093(00)01822-0Suche in Google Scholar

[2] S.A.Sajjadi, S.Nategh, R.I.L.Guthrie: Mater. Sci. Eng. A325 (2002) 484–489. 10.1016/S0921-5093(01)01709-9Suche in Google Scholar

[3] I.M.Lifshitz, V.V.Slyozov: J. Phys. Chem. Solids19 (1961) 35–50. 10.1016/0022-3697(61)90054-3Suche in Google Scholar

[4] C.Wagner: Z. Electrochem.65 (1961) 581–591.Suche in Google Scholar

[5] A.J.Ardell: Acta Metall.20 (1972) 61–71. 10.1016/0001-6160(72)90114-9Suche in Google Scholar

[6] P.W.Voorhees, M.E.Glicksman: Acta Metall.32 (1984) 2001–2011. 10.1016/0001-6160(84)90180-9Suche in Google Scholar

[7] Y.Enomoto, M.Tokuyama, K.Kawasaki: Acta Metall.34 (1986) 2119–2128. 10.1016/0001-6160(86)90157-4Suche in Google Scholar

[8] H.J.Ryu, S.H.Hong, J.Weber, J.H.Tundermann: J. Mater. Sci.34 (1999) 329–336. 10.1023/A:1004461724568Suche in Google Scholar

[9] M.Doi, T.Miyazaki, T.Wakatsuki: Mater. Sci. Eng.74 (1985) 139–145. 10.1016/0025-5416(85)90427-6Suche in Google Scholar

[10] M.Doi, T.Miyazaki, T.Wakatsuki: Mater. Sci. Eng.67 (1984) 247–253. 10.1016/0025-5416(84)90056-9Suche in Google Scholar

[11] T.Miyazaki, M.Doi: Mater. Sci. Eng. A110 (1989) 175–185. 10.1016/0921-5093(89)90168-8Suche in Google Scholar

[12] T.Maebashi, M.Doi: Mater. Sci. Eng. A373 (2004) 72–79. 10.1016/j.msea.2003.12.064Suche in Google Scholar

[13] W.C.Johnson, J.W.Cahn: Acta Metall.32 (1984) 1925–1933. 10.1016/0001-6160(84)90174-3Suche in Google Scholar

[14] W.C.Johnson, J.K.Lee: Metall. Trans. A10 (1979) 1141–1149. 10.1007/BF02811659Suche in Google Scholar

[15] M.Doi: Prog. Mater. Sci.40 (1996) 79–l80. 10.1016/0079-6425(96)00001-1Suche in Google Scholar

[16] M.Doi: T. Miyazaki: Mater. Sci. Eng.78 (1986) 87–94. 10.1016/0025-5416(86)90082-0Suche in Google Scholar

[17] H.A.Feng, H.Biermann, H.Mughrabi: Metall. Trans. A31 (2000) 585–597. 10.1007/s11661-000-0002-9Suche in Google Scholar

[18] F.R.N.Nabarro: Metall. Trans. A27 (1996) 513–530. 10.1007/BF02648942Suche in Google Scholar

[19] M.P.Gururajan, T.A.Abinandanan: Acta Mater.55 (2007) 5015–5026. 10.1016/j.actamat.2007.05.021Suche in Google Scholar

[20] N.Matan, D.C.Cox, C.M.F.Rae, R.C.Reed: Acta Mater.47 (1999) 2031–2045. 10.1016/S1359-6454(99)00093-2Suche in Google Scholar

[21] M.Kamaraj, C.Mayr, M.Kolbe, G.Eggeler: Scripta Mater.38 (1998) 589–594. 10.1016/S1359-6462(97)00520-4Suche in Google Scholar

[22] M.Pollock, A.S.Argon: Acta Metall. Mater.42 (1994) 1859–1874. 10.1016/0956-7151(94)90011-6Suche in Google Scholar

[23] N.Kobayashi, S.Onaka, T.Fujii, M.Kato: Mater. Sci. Eng. A392 (2005) 248–253. 10.1016/j.msea.2004.10.042Suche in Google Scholar

Received: 2011-3-30
Accepted: 2012-8-9
Published Online: 2014-03-30
Published in Print: 2013-03-14

© 2013, Carl Hanser Verlag, München

Artikel in diesem Heft

  1. Contents
  2. Contents
  3. Original Contributions
  4. The thermodynamics of boron extraction from liquid silicon using SiO2–CaO–MgO slag treatment
  5. Viscosity estimation of semi-solid alloys based on thermal simulation compression tests
  6. Original Contributions
  7. Experimental study of phase equilibria in the “SnO”–CaO–SiO2 system in equilibrium with tin metal
  8. Prediction of the solidification path of Al-4.37Cu-27.02Mg ternary eutectic alloy with a unified microsegregation model coupled with Thermo-Calc
  9. Evaluation of the effective diffusion coefficient of boron in the Fe2B phase in the presence of chemical stresses
  10. Morphology evolution of γ′ precipitates in GTD-111 Ni-based superalloy with heat treatment parameters
  11. Hot forming of a new steel used in stamping dies and tooling
  12. Mechanical properties and corrosion behaviour of freestanding, precipitate-free magnesium WE43 thin films
  13. Sliding wear performance of Fe-, Ni- and Co-based hardfacing alloys for PTA cladding
  14. The suitability of selected austenitic stainless steels and hastelloy C276 alloys as substrates for thin film deposition using spray pyrolysis
  15. Synthesis, structural, optical and thermal analysis of nanostructured ZnO
  16. Electrical conductivity variation of (Bi2Te3)0.25(Sb2Te3)0.75 crystal grown using the zone melting method
  17. X-ray Absorption Near Edge Structure Studies of Pb1-xMnxTe(In, Ga) Systems
  18. DGM News
  19. DGM News
  20. Grain refining of aluminium alloys and silicon by means of boron-nitride particles
https://doi.org/10.3139/146.110856
Schlagwörter für diesen Artikel
GTD-111; γ′ precipitate; Coarsening; Splitting; Rafting

Artikel in diesem Heft

  1. Contents
  2. Contents
  3. Original Contributions
  4. The thermodynamics of boron extraction from liquid silicon using SiO2–CaO–MgO slag treatment
  5. Viscosity estimation of semi-solid alloys based on thermal simulation compression tests
  6. Original Contributions
  7. Experimental study of phase equilibria in the “SnO”–CaO–SiO2 system in equilibrium with tin metal
  8. Prediction of the solidification path of Al-4.37Cu-27.02Mg ternary eutectic alloy with a unified microsegregation model coupled with Thermo-Calc
  9. Evaluation of the effective diffusion coefficient of boron in the Fe2B phase in the presence of chemical stresses
  10. Morphology evolution of γ′ precipitates in GTD-111 Ni-based superalloy with heat treatment parameters
  11. Hot forming of a new steel used in stamping dies and tooling
  12. Mechanical properties and corrosion behaviour of freestanding, precipitate-free magnesium WE43 thin films
  13. Sliding wear performance of Fe-, Ni- and Co-based hardfacing alloys for PTA cladding
  14. The suitability of selected austenitic stainless steels and hastelloy C276 alloys as substrates for thin film deposition using spray pyrolysis
  15. Synthesis, structural, optical and thermal analysis of nanostructured ZnO
  16. Electrical conductivity variation of (Bi2Te3)0.25(Sb2Te3)0.75 crystal grown using the zone melting method
  17. X-ray Absorption Near Edge Structure Studies of Pb1-xMnxTe(In, Ga) Systems
  18. DGM News
  19. DGM News
  20. Grain refining of aluminium alloys and silicon by means of boron-nitride particles
Jetzt anmelden und 20% sparen
Institutioneller Zugang
Wie funktioniert Authentifizierung?
Haben Sie eine Idee, wie wir unsere Website verbessern können?
Bitte schreiben Sie uns.
© 2025 De Gruyter Brill
Heruntergeladen am 13.11.2025 von https://www.degruyterbrill.com/document/doi/10.3139/146.110856/html?lang=de
Button zum nach oben scrollen