Contents

Artikel in diesem Heft

1. Contents
2. Contents
3. Basic
4. Critical temperature for massive transformation in ultra-low-carbon Fe–C alloys
5. Are data correctly fitted by the sin² ψ and similar methods?
6. Liquidus surface projection of the Fe–Co–C ternary system in the iron-rich corner
7. Prediction of thermodynamic activities in binary iron-based alloys using two-point Padé approximants
8. Study of fatigue dislocation structures in [233] coplanar double-slip-oriented copper single crystals using SEM electronic channelling contrast
9. Microstructures at high temperature of Fe-30 wt.% Cr-xC Alloys with x varying from 0 to 2 wt.%
10. The effect of cooling rate on the microstructure and mechanical properties of Mg–Zn–Gd-based alloys
11. The effect of thermal exposure on the microstructure and hardness of as-cast Mg–Zn–Al alloys with Sn addition
12. Applied
13. Deformation and fracture of Ti-base nanostructured composite
14. Microstructure and some properties of FeCr25Co15 alloy subjected to plastic deformation by complex load
15. Determination of the concentration dependent diffusion coefficient of nitrogen in expanded austenite
16. Suitability of maraging steel weld cladding for repair of die casting tooling
17. Catalytic performance of Fe-, Pd-, and Pd–Fe- mordenites in simulated hydrocarbon-selective catalytic reduction of N₂O by methane in a model flue-gas from nitric acid plants
18. Thermodynamic consideration and experimental study on the preparation of heat-treated hollow nickel fibres
19. A model for the intrinsic kinetic parameters of the direct reduction of MoS₂ with hydrogen
20. Notification
21. DGM News