Herrn Prof. em. Dr. rer. nat. Dr.-Ing. E. h. mult. Prof. h. c. Dr. h. c. Eckard Macherauch zum 80. Geburtstag

Artikel in diesem Heft

1. Contents
2. Contents
3. Editorial
4. Herrn Prof. em. Dr. rer. nat. Dr.-Ing. E. h. mult. Prof. h. c. Dr. h. c. Eckard Macherauch zum 80. Geburtstag
5. Basic
6. Stability of residual stresses in longitudinally and transversely deep rolled sintered iron under quasistatic and cyclic loading
7. Residual stresses in random-planar aluminium/Saffil® short-fibre composites deformed in different loading modes
8. Thermal residual stress analysis in continuous Al₂O₃ fiber reinforced NiAl composites
9. On the fatigue behavior of ultrafine-grained interstitial-free steel
10. Laser Interference Metallurgy – using interference as a tool for micro/nano structuring
11. On dynamic and static strain ageing in Cu-2at.% Mn polycrystals
12. High thermal stability of mechanically-alloyed nanocrystalline Cu–Nb alloys
13. Possibilities and limits in thermohydrogen processing of beta titanium alloy Timetal®10-2-3
14. Applied
15. Cube textured tapes for use in YBa₂Cu₃O₇–δ-coated conductor applications
16. Cavitation erosion of advanced ceramics in water
17. Influence of tension–compression loading history on plastic deformation of Mg wrought alloy AZ31
18. Microstructure and mechanical properties of the extruded Mg-alloys AZ31, AZ61, AZ80
19. Mechanical properties and microstructural changes of ultrafine-grained AA6063T6 during high-cycle fatigue
20. Analysis of failure behaviour of carbon/carbon composite made by chemical vapour infiltration considering fibre, matrix and interface properties
21. Cooperating twin robots form a new X-ray diffractometer for stress analysis
22. Grinding-induced microstructural gradients and residual stresses in the surface layers of carbon steel and pure tungsten
23. Residual-stress-induced subsurface crack nucleation in titanium alloys
24. Microstructure and fatigue strength of the roller-bearing steel 100Cr6 (SAE 52100) after two-step bainitisation and combined bainitic–martensitic heat treatment
25. History
26. Damage tolerance: fracture mechanics in design
27. Description of flow curves over wide ranges of strain rate and temperature
28. Mechanismen und Modellierung der Verformung und Schädigung keramischer Faserverbundwerkstoffe
29. Notifications
30. Personal