Article
Licensed
Unlicensed
Requires Authentication
DGM News
Published/Copyright:
July 8, 2019
Published Online: 2019-07-08
Published in Print: 2019-07-15
© 2019, Carl Hanser Verlag, München
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Contents
- Contents
- Original Contributions
- 3D morphology characterization of graphite and its effect on the thermal conductivity of vermicular graphite iron
- Experimental liquidus studies of the Zn–Fe–Si–O system in air
- Phase transitions in copper–silver alloys under high pressure torsion
- High-temperature oxidation behavior of low sulfur martensitic stainless steel 1Cr13Mo containing cerium
- Microstructure and properties of Cu-bearing carbidic austempered ductile iron
- Fabrication of Al–WC gradient nano-composite via centrifugal casting method
- Properties of vacuum-laser-welded Ti-based bulk metallic glass and Zr-based bulk metallic glass composite
- Optimal design and characterization of novel biomedical Zr-based alloys for hard tissue substitution
- The influence of Mo/B atomic ratio on microstructural evolution and mechanical properties of Mo2FeB2-based cermets
- Piezo-spectroscopic and tribological characterization of diffusion bonded oxide laminate composite ceramics
- Short Communications
- ZnO-modified SnO flower-like microstructures with enhanced photocatalytic performance
- DGM News
- DGM News
Articles in the same Issue
- Contents
- Contents
- Original Contributions
- 3D morphology characterization of graphite and its effect on the thermal conductivity of vermicular graphite iron
- Experimental liquidus studies of the Zn–Fe–Si–O system in air
- Phase transitions in copper–silver alloys under high pressure torsion
- High-temperature oxidation behavior of low sulfur martensitic stainless steel 1Cr13Mo containing cerium
- Microstructure and properties of Cu-bearing carbidic austempered ductile iron
- Fabrication of Al–WC gradient nano-composite via centrifugal casting method
- Properties of vacuum-laser-welded Ti-based bulk metallic glass and Zr-based bulk metallic glass composite
- Optimal design and characterization of novel biomedical Zr-based alloys for hard tissue substitution
- The influence of Mo/B atomic ratio on microstructural evolution and mechanical properties of Mo2FeB2-based cermets
- Piezo-spectroscopic and tribological characterization of diffusion bonded oxide laminate composite ceramics
- Short Communications
- ZnO-modified SnO flower-like microstructures with enhanced photocatalytic performance
- DGM News
- DGM News