Contents

Articles in the same Issue

1. Contents
2. Contents
3. Original Contributions
4. Effect of Peierls stress and strain-hardening parameters on EMR emission in metals and alloys during progressive plastic deformation
5. Relaxation and diffusion barriers at step edges of Cu, Ag and Au homo- and heterogeneous systems: Case of (100) facet
6. Simulation analysis on impurity distribution in mc-Si grown by directional solidification for solar cell applications
7. Experimental investigation and thermodynamic calculation of the Mg–Sr–Zr system
8. Microstructures and properties of Cr–Cu/W–Cu bi-layer composite coatings prepared by mechanical alloying
9. Innovative approach to protect magnesium powder during sintering
10. Friction stir welding of foamable AlSi7 reinforced by B₄C
11. Incorporation of SiC particles in FS welded zone of AZ31 Mg alloy to improve the mechanical properties and corrosion resistance
12. Effects of fiber volume fraction on strain of piezoelectric fiber composites
13. Dry wear behavior of cooling-slope-cast hypoeutectic aluminum alloy
14. Short Communications
15. In-situ grown interwoven NiSe on Ni foam as a catalyst for hydrazine oxidation
16. DGM News
17. DGM News