Design Optimization of a Centrifugal Fan with Splitter Blades
-
Man-Woong Heo
Abstract
Multi-objective optimization of a centrifugal fan with additionally installed splitter blades was performed to simultaneously maximize the efficiency and pressure rise using three-dimensional Reynolds-averaged Navier-Stokes equations and hybrid multi-objective evolutionary algorithm. Two design variables defining the location of splitter, and the height ratio between inlet and outlet of impeller were selected for the optimization. In addition, the aerodynamic characteristics of the centrifugal fan were investigated with the variation of design variables in the design space. Latin hypercube sampling was used to select the training points, and response surface approximation models were constructed as surrogate models of the objective functions. With the optimization, both the efficiency and pressure rise of the centrifugal fan with splitter blades were improved considerably compared to the reference model.
©2015 by De Gruyter
Artikel in diesem Heft
- Frontmatter
- Lean Blow-out Studies in a Swirl Stabilized Annular Gas Turbine Combustor
- Effect of Fuel Particle Size on the Stability of Swirl Stabilized Flame in a Gas Turbine Combustor
- Design Optimization of a Centrifugal Fan with Splitter Blades
- Influence of Additional Leading-Edge Surface Roughness on Performances in Highly Loaded Compressor Cascade
- Virtual Turbine Engine Test Bench Using MGET Test Device
- Gas Turbine Fault Diagnosis Using Probabilistic Neural Networks
- Vibration Characteristics of Squeeze Film Damper during Maneuver Flight
- Aerodynamic Optimization Design of Multi-stage Turbine Using the Continuous Adjoint Method
- A Target Indirect Thrust Measurement Method of Pulse Detonation Engine
- Research on Modeling of Propeller in a Turboprop Engine
Artikel in diesem Heft
- Frontmatter
- Lean Blow-out Studies in a Swirl Stabilized Annular Gas Turbine Combustor
- Effect of Fuel Particle Size on the Stability of Swirl Stabilized Flame in a Gas Turbine Combustor
- Design Optimization of a Centrifugal Fan with Splitter Blades
- Influence of Additional Leading-Edge Surface Roughness on Performances in Highly Loaded Compressor Cascade
- Virtual Turbine Engine Test Bench Using MGET Test Device
- Gas Turbine Fault Diagnosis Using Probabilistic Neural Networks
- Vibration Characteristics of Squeeze Film Damper during Maneuver Flight
- Aerodynamic Optimization Design of Multi-stage Turbine Using the Continuous Adjoint Method
- A Target Indirect Thrust Measurement Method of Pulse Detonation Engine
- Research on Modeling of Propeller in a Turboprop Engine
