Article
Licensed
Unlicensed
Requires Authentication
Modification of Polymer Surfaces Using Atmospheric Pressure Barrier Discharges
-
Pavel Sťahel
,
Martin Šíra
Published/Copyright:
November 30, 2016
Abstract
The objective of the present work is the development of a technique for the deposition of thin films, by means of an atmospheric pressure discharge, onto a pulp board surface, with the desired surface energy, permeability and wear resistant surface. The deposition of thin films was carried out by a surface barrier discharge at the atmospheric pressure. The films were deposited from mixtures of C4F8 with nitrogen. The properties of the thin film substrate systems were investigated by means of contact angle measurement and industrial permeability tests. The chemical composition of the films was studied by means of a Fourier transform infrared spectroscopy. The mechanical properties of the films were studied by means of depth sensing indentation tests performed on samples deposited upon glass plate. The surface topographies of coated and uncoated samples were investigated using a scanning electron microscope.
Received: 2005-12-20
Revised: 2006-2-5
Accepted: 2006-2-10
Published Online: 2016-11-30
Published in Print: 2006-7-1
© 2016 by Walter de Gruyter Berlin/Boston
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Preface
- Power Supply Systems of Ozone Generators with Magnetic Frequency Multipliers
- Simultaneous Decomposition of Diesel Particulate Material and NOx Using Dielectric Barrier Discharge
- Phenol Oxidation in Aqueous Solution by Gas Phase Corona Discharge
- LIF Observation of Ground-State OH Radicals in DC Nozzle-to-Plane Positive Streamer Corona
- Measurement of Low Gas Concentration Using Photonic Bandgap Fiber
- A Study on a Diode-Bridge Type Differential Capacitance Detection Circuit
- Microwave Reactor for Nitrous Oxide Processing
- Volume-Surface Discharge as an Ion Source for Plasma Technologies
- Development of Agricultural Soil Sterilization Using Ozone Generated by High Frequency Dielectric Barrier Discharge
- Modeling of the Temperature Distribution in Arc Discharge Plasma Reactor
- Arc Plasma Reactor Power System with 5-Limb Transformer
- Discharge Plasma Characteristics in Pure Ar Gas at Multi-Atmospheric Pressure Using the Automatically Pre-Ionized Plasma Electrode
- A New Type of Reactor with a Combination of Surface Discharge and Advanced Oxidation Process in Air and its Applications
- Study of a Wide Area Carbon Nanotubes Preparation for an Environmental Application
- Research on Waste Water Purification by Ozone Treatment and Pulsed Discharge Treatment
- Energetic of the Oxidation of NOx by Ozone Using a Simple Molecular Model in a Computational Chemistry Scheme
- Analysis of Acoustic Signal in the MICRO Discharges Using Continuous Wavelet Transform
- Plasma-catalytic Conversion of Methane by DBD and Gliding Discharges
- Investigation of Hot Gas Mixture Free Jet
- Piezoelectrical Properties of Plasma Layers Zn-Bi-O
- Modification of Polymer Surfaces Using Atmospheric Pressure Barrier Discharges
- Influence of Silicon, Oxygen and Nitrogen Admixtures Upon the Properties of Plasma Deposited Amorphous Diamond-Like Carbon Coatings
- Thin Films Deposited from Trimethylmethoxysilane
Articles in the same Issue
- Preface
- Power Supply Systems of Ozone Generators with Magnetic Frequency Multipliers
- Simultaneous Decomposition of Diesel Particulate Material and NOx Using Dielectric Barrier Discharge
- Phenol Oxidation in Aqueous Solution by Gas Phase Corona Discharge
- LIF Observation of Ground-State OH Radicals in DC Nozzle-to-Plane Positive Streamer Corona
- Measurement of Low Gas Concentration Using Photonic Bandgap Fiber
- A Study on a Diode-Bridge Type Differential Capacitance Detection Circuit
- Microwave Reactor for Nitrous Oxide Processing
- Volume-Surface Discharge as an Ion Source for Plasma Technologies
- Development of Agricultural Soil Sterilization Using Ozone Generated by High Frequency Dielectric Barrier Discharge
- Modeling of the Temperature Distribution in Arc Discharge Plasma Reactor
- Arc Plasma Reactor Power System with 5-Limb Transformer
- Discharge Plasma Characteristics in Pure Ar Gas at Multi-Atmospheric Pressure Using the Automatically Pre-Ionized Plasma Electrode
- A New Type of Reactor with a Combination of Surface Discharge and Advanced Oxidation Process in Air and its Applications
- Study of a Wide Area Carbon Nanotubes Preparation for an Environmental Application
- Research on Waste Water Purification by Ozone Treatment and Pulsed Discharge Treatment
- Energetic of the Oxidation of NOx by Ozone Using a Simple Molecular Model in a Computational Chemistry Scheme
- Analysis of Acoustic Signal in the MICRO Discharges Using Continuous Wavelet Transform
- Plasma-catalytic Conversion of Methane by DBD and Gliding Discharges
- Investigation of Hot Gas Mixture Free Jet
- Piezoelectrical Properties of Plasma Layers Zn-Bi-O
- Modification of Polymer Surfaces Using Atmospheric Pressure Barrier Discharges
- Influence of Silicon, Oxygen and Nitrogen Admixtures Upon the Properties of Plasma Deposited Amorphous Diamond-Like Carbon Coatings
- Thin Films Deposited from Trimethylmethoxysilane
