Microstructural characterization of alloys of the quasibinary Cu–NiBe system
-
Savo Spaić
Abstract
Alloys of the quasibinary section Cu –NiBe were experimentally investigated with differential thermal analysis, optical microscopy, electron microanalysis, transmission electron microscopy and X-ray diffraction. The construction of the quasibinary Cu–NiBe phase diagram was made based on the experimental results. The constitution of alloys of the whole section was studied along with the investigation of the microstructure and crystallographic relationship of the NiBe phase in aged alloys from the Cu-rich corner of the Cu–NiBe system.
References
[1] G. Li, B.G. Thomas, J.F. Stubbins: Metall. Mater. Trans. A 31 (2000) 2491.10.1007/s11661-000-0194-zSuche in Google Scholar
[2] A.A. Tseng, T.C. Chen, K.P. Jen, T. Ochiai: J. Mater. Eng. Perf. 3 (1994) 619.10.1007/BF02645260Suche in Google Scholar
[3] Q. Xu, D.J. Edwards, T. Yoshiie: J. Nuclear Mater. 283–287 (2000) 1229.10.1016/S0022-3115(00)00175-6Suche in Google Scholar
[4] W.A Monteiro, F. Casandy, P. Bandaru, in: T. Chandra, T. Sakai (Eds.), THERMEC ’97, Processing of Steels & Other Materials, The Minerals, Metals & Materials Society, Warrendale, PA (1997) 1769.Suche in Google Scholar
[5] S. Spaić, A. Križman, V. Marinković: Metall 39 (1985) 43.Suche in Google Scholar
[6] Ch. Bao-Chan: Izv. vish. uchebn. zavedeniy, Tsvetnaya metallurgiya 1 (1958) 138.Suche in Google Scholar
[7] A. Rotem, D. Shechtman, A. Rosen: Metall. Trans. A 19 (1988) 2279.10.1007/BF02645051Suche in Google Scholar
[8] B.N. Singh, D.J. Edwards, M. Eldrup, P. Toft: J. Nuclear Mater. 249 (1997) 1.10.1016/S0022-3115(97)00184-0Suche in Google Scholar
© 2003 Carl Hanser Verlag, München
Artikel in diesem Heft
- Frontmatter
- Articles/Aufsätze
- An atomistic Monte Carlo simulation of precipitation in a binary system
- Thermodynamic assessment of the Pd–Zr system
- Cyclic deformation and dislocation structure evolution of a copper bicrystal with components rotating gradually along the grain boundary
- Microstructural characterization of alloys of the quasibinary Cu–NiBe system
- Microstructural characterisation and thermal stability of a metastable Mg-8.6 wt.% Zr alloy produced by physical vapour deposition
- Development of microstructure in solution-heat-treated Mg-5Al-xCa alloys
- The effect of Ti alloying on the mechanical properties and microstructure of a Zn–Al–Cu–Mg alloy
- Dry wear response of a Zn-based alloy containing 37.5% Al as affected by sliding conditions
- Microstructure selection map for rapidly solidified Al-rich Al–Sr alloys
- Dependence of the microstructure, residual stresses and texture of AA 6013 friction stir welds on the welding proces
- The effect of carbon on the restoration phenomena during hot deformation of carbon steels
- Deformation behavior during hot torsion of an ultrahigh carbon steel containing 1.3 wt.% C
- Effect of impact damage on electrical resistivity of C/C–SiC composites
- Depth-resolved residual stress evaluation from X-ray diffraction measurement data using the approximate inverse method
- Combined scanning probe microscopy and electron microscopy study of microstructure evolution in copper processed by equal channel angular pressing
- Notifications/Mitteilungen
- Personal/ Personelles
- Information
- Books/Bücher
- Conferences /Konferenzen
Artikel in diesem Heft
- Frontmatter
- Articles/Aufsätze
- An atomistic Monte Carlo simulation of precipitation in a binary system
- Thermodynamic assessment of the Pd–Zr system
- Cyclic deformation and dislocation structure evolution of a copper bicrystal with components rotating gradually along the grain boundary
- Microstructural characterization of alloys of the quasibinary Cu–NiBe system
- Microstructural characterisation and thermal stability of a metastable Mg-8.6 wt.% Zr alloy produced by physical vapour deposition
- Development of microstructure in solution-heat-treated Mg-5Al-xCa alloys
- The effect of Ti alloying on the mechanical properties and microstructure of a Zn–Al–Cu–Mg alloy
- Dry wear response of a Zn-based alloy containing 37.5% Al as affected by sliding conditions
- Microstructure selection map for rapidly solidified Al-rich Al–Sr alloys
- Dependence of the microstructure, residual stresses and texture of AA 6013 friction stir welds on the welding proces
- The effect of carbon on the restoration phenomena during hot deformation of carbon steels
- Deformation behavior during hot torsion of an ultrahigh carbon steel containing 1.3 wt.% C
- Effect of impact damage on electrical resistivity of C/C–SiC composites
- Depth-resolved residual stress evaluation from X-ray diffraction measurement data using the approximate inverse method
- Combined scanning probe microscopy and electron microscopy study of microstructure evolution in copper processed by equal channel angular pressing
- Notifications/Mitteilungen
- Personal/ Personelles
- Information
- Books/Bücher
- Conferences /Konferenzen
