Band 5, Heft 1

In this paper, Leaf Area Index (LAI) and Crop Height (CH) are modeled to the most known spectral vegetation index — NDVI — using remotely sensed data. This approach has advantages compared to the classic approaches based on a theoretical background. A GER-1500 field spectro-radiometer was used in this study in order to retrieve the necessary spectrum data for estimating a spectral vegetation index (NDVI), for establishing a semiempirical relationship between black-eyed beans’ canopy factors and remotely sensed data. Such semi-empirical models can be used then for agricultural and environmental studies. A field campaign was undertaken with measurements of LAI and CH using the Sun-Scan canopy analyzer, acquired simultaneously with the spectroradiometric (GER1500) measurements between May and June of 2010. Field spectroscopy and remotely sensed imagery have been combined and used in order to retrieve and validate the results of this study. The results showed that there are strong statistical relationships between LAI or CH and NDVI which can be used for modeling crop canopy factors (LAI, CH) to remotely sensed data. The model for each case was verified by the factor of determination. Specifically, these models assist to avoid direct measurements of the LAI and CH for all the dates for which satellite images are available and support future users or future studies regarding crop canopy parameters.

The timing of the local last glacial maximum in the mountains of the Northern Iberian Peninsula is not synchronous with the global Last Glacial Maximum (LGM) probably due to the marginal position of the Northern Iberian Peninsula within the European continent. The study of a Cantabrian massif, the Asón platform and summits, provides new data on the extent and timing of the local last glaciation. Here we can place the last maximal extent of glaciers during Early Würm, according to OSL dating on till samples. The main glaciers developed at least between 78-65 ka BP, well centred on MIS 4 and even the transition to MIS 5. The erosive efficacy of these glaciers decreased later, ca. 45–40 ka BP, until they abruptly disappeared from the edges of the massif. A new ice advance left well-defined moraines at the edges of the massif’s internal depressions, indicating a tongue disjunction phase with two glacier sub-stages, probably one at the beginning of the cooling ca. 27–25 ka BP, followed by a retreat and another glacial advance ca. 21–18 ka BP. After these episodes the glaciers disappeared from the Asón Mountains and only some residual glaciers were formed that may be related to the LGM.

The Sitno Natura 2000 Site covers an area of 935,56 hectares. The Sitno region is significant due to the number of rare and endangered species of plants, and as a result is considered a location of great importance to the maintenance of floral gene pools. The study area suffers human impacts in the form of tourism. The main purpose of this study is to the measure landscape elements, determine the ecological significance of habitats within the Sitno area, and from this data, organize the study area into conservation zones. The results of this landscape quantification are numerical values that can be used to interpret the quality of ongoing ecological processes within individual landscape types. Interpretation of this quantified data can be used to determine the ecological significance of landscapes in other study areas. This research examines the habitats of Natura 2000 Sites by a set of landscape metrics for habitat area, size, density, and shape, such as Number of patches (NP), Patch density (PD), Mean patch size (MPS), Patch size standard deviation (PSSD) and Mean shape index (MSI). The classification of land cover patches is based on the Annex Code system.

The Mellin transform is a mathematical tool which has been applied in many areas of Mathematics, Physics and Engineering. Its application in Geophysics is in the computation of solution of potential problems for the determination of the mass as well as the depth to the basement of some solid mineral deposits. In this study, the Mellin transform is used to determine the depth to the top (h) and the depth to the bottom (H) of the basement of a profile of an anomalous magnetic body. Ibuji, the study area is located in Ifedore Local Government area of Ondo state, Nigeria, underlain by Precambrian complex rocks and bounded by geographical co-ordinate of Easting 5°00t’00″ to 5°4t’30″ and Northing 7°24t’00″ to 7°27t’36″. The magnetic anomaly profile due to a two- dimensional body(vertical thin sheet)over magnetic spring of the study area was digitised and the values of magnetic amplitude (nT) with respect to its horizontal distance (say interval of 5 m) obtained from the digitized profile was then used in the computation of Mellin transform using Matlab programs. In order to determine the depths H and h, the amplitudes were considered at three arbitrary point (s = ¼, ½ and ¾) such that, (0 < s < 1), where s is a complex variable of real positive integer. The value obtained for H was 47.95 m, which compared favourably with the result obtained using other methods. Meanwhile, the value obtained for h has a convergence restriction, whereby, at lower values of s, there is divergence, while at higher values of s, (about 0.9), the result converges and h was obtained to be 32.56 m. The Ibuji magnetic anomaly was therefore analysed to have a depth to the bottom (H) of 47.95 m and depth to the top of 32.56 m using this mathematical tool.

In this study thermal comfort conditions are analyzed to determine possible thermal perceptions during different months in Iran through the Physiologically Equivalent Temperature (PET). The monthly PET values produced using the RayMan Model ranged from −7.6°C to 46.8°C. Over the winter months the thermal comfort condition (18–23°C) were concentrated in southern coastal areas along the Persian Gulf and Oman Sea. Most of the country experienced comfort conditions during the spring months, in particular in April, while during the summer months of July and August no thermal comfort conditions were observed. In November coastal areas of the Caspian Sea had the same physiological stress level of thermal comfort as April. The map produced showing mean annual PET conditions demonstrated the greatest spatial distribution of comfortable levels in the elevation range from 1000 to 2000 meter a.s.l., with annual temperatures of 12–20°C and annual precipitation of under 200 mm. The statistical relationship between PET conditions and each controlling parameter revealed a significant correlation in areas above 2000 meter, annual temperature over 20°C and annual precipitation of 200–400 mm with a correlation coefficient (R 2) of 0.91, 0.97 and 0.96, respectively.

The land subsidence which occurs at the Larissa Basin (Thessaly Plain, Central Greece) is due to various causes including aquifer system compaction. Deformation maps of high spatial resolution deduced by the Persistent Scattering Interferometry (PSI) technique (using radar scenes from ERS and ENVISAT satellites) for the period 1992–2006 were produced to study the spatial and temporal ground deformation. A developed GIS database (including geological, tectonic, morphological, hydrological, meteorological and watertable variation from wells in the area) offered the possibility of studying in detail the intense subsidence. The PSI based average deformation image clearly shows that subsidence generally takes place inside the Larissa Plain ranging from 5–250 mm. The largest amplitude rates (−25 mm/yr) are observed around the urban area of Larissa City (especially at Gianouli and Nikea villages), while the Larissa City center appears to be relatively stable with a tendency to subside. The rest of the plain regions seem to subside at moderate rates (about 5–10 mm/yr). The surrounding mountainous area is stable, or has slightly been uplifted with respect to the NE located reference point. It was found that there is a correlation between the seasonal water-table variation (deduced from wells data), the seasonal water demand for irrigation associated with specific types of cultivation (cotton fields), the monthly rainfall, and the observed subsidence rate in the rural regions of the Thessaly Plain.

Mineral resource evaluation requires defining geological rock-type domains. The traditional simulation methods have serious limitations for applications to large numbers of domains, which have complex contact relations. Plurigaussian simulation is an effective method which can be applied, in a simple way, to any number of domains, using both local and global geological information to infer the distributions of rock types. This work not only presents the application of the plurigaussian simulation method to the Balya lead-zinc deposit, but also assesses the spatially varying rock type proportions, and accounts for uncertainties between them. These parameters are extremely important for mining deposits, since the mineralizations of interest generally occur only in certain rock types. Furthermore, being able to model the different geological rock types is vital to good mine operations, production planning, and management. The results indicate that the plurigaussian method correctly reproduces the different orientations of the individual rock types, as seen in drill holes, and the proportion of each rock type, even if this varies in space.

A three-dimensional numerical circulation model is described. The model is based on non-linear hydrodynamic equations, modified according to hydrostatic and Boussinesq approximations. A space-splitting scheme is used for numerical approximations of governing equations. The simple hypothesis on elliptic stream functions shape is utilized to reconstruct the near-surface wind field. The calculated currents correspond reasonably well with observed velocities in different locations lake-wide.

Flash floods are one of the most significant natural hazards of today. Due to the complexity of flash flood triggering factors, to prevent or mitigate flood triggered losses, numeric model based flood forecasting models are capable tools to predict stream water levels. The main goal of the current research was to reproduce two flow peaks with the HEC-HMS rainfall-runoff model and test the model sensitivity for various input parameters. To obtain sufficient input data, we monitored soil depth, maximum infiltration rate, soil moisture content, rainfall, time of concentration and flow. To obtain input data, parameters were calculated, measured in the Sás Valley experimental watershed (SW Hungary) or optimized with the built in function of the HEC-HMS. Soil moisture was monitored in the 1.7 km2 pilot catchment over the period between September 2008 and September 2009. HEC-HMS had a good performance reproducing the two events, however simulated flow time series are highly influenced by the antecedent soil moisture, infiltration rate and canopy storage. Outflow modeled data were verified for two flood events (June 4, 2008 and July 9, 2009). The HEC-HMS was over-sensitive for input soil moisture and with increasing input rainfall and increasing outflow, larger simulation errors were observed.

This paper summarizes analytical data accumulated in the world literature and other materials about the regularities of the REE distribution in minerals contained in ultramafic and mafic rocks as accessory phases. These minerals are tentatively divided into two groups. The first includes garnets, zircons, apatites and perovskites, which can accumulate increased amounts of REE in their structure. The second consists of minerals whose structure can accumulate only limited contents of these trace elements. These are chrome-spinels, ilmenites, and micas. These minerals, in respect of REE geochemistry, are studied to a varying degree because of the different levels of accumulations of these elements, different degrees of occurrence in rocks, tiny sizes of their grains and other reasons. The analytical database formed on their basis includes about 600 original analyses. The overwhelming majority of presently available data on REE geochemistry in accessory minerals from ultramafic and mafic rocks have been published only in the recent 15 years. The studies became possible due to the development and introduction of new highly sensible microprobe analyses allowing detection of REE and many other trace elements in minerals grains directly in thin sections. The greatest numbers of these analyses were performed for garnets and zircons, fewer for apatites, and the fewest for chrome-spinels, ilmenites, micas, and perovskites. In general, the regularities of REE distribution in these minerals from ultramafic and mafic rocks are less studied compared to the rock-forming minerals from ultramafic and mafic rocks. Among the analytical methods, which were used to study the REE composition of accessory minerals, the most efficient was the mass-spectrometry with inductively coupled plasma (ICP-MS).

The first mineralogical and geochemical investigation of the travertine limestone, soil and corresponding plants associated with the Neogene basin of Varnavas, NE Attica, revealed a significant enrichment in the metalloid As. The total concentrations of As ranged from 61 to 210 ppm in limestone and 33 to 430 ppm in the associated soil demonstrating a wide variation of values. Calcite is a common authigenic mineral within travertine limestone, forming fine uniform micritic aggregates, having As and Mg concentrations lower than detection limits of EDS analysis. Clastic dominated minerals are quartz (both fine- and coarse-grained), muscovite, clinochlore, illite, pyrite, galena, arsenides, rutile, sphene, zircon, REE-minerals and albite. Goethite and Fe-Mn-oxides occur between calcite grains. The presence of fossilized micro organisms, resembling foraminifera, in travertine limestone combined with hydrous Fe-Mn-oxides, suggests a possible marine transgression during the evolution of the basin. The As content in plants ranges from 1.1 to 28 ppm As in shoots, and 0.8 to 114 ppm As in roots. The translocation factor, which is defined as the ratio of metal concentration in the shoots to the roots, is relatively low (average 0.33%) suggesting that the internal transport of metals from the roots to shoots was restricted. The bioaccumulation factor, which is defined as the ratio of metal concentration in the plants to that in soil, exhibits a wide range from relatively low (5.2–9.0% for As, Fe, Cr, Ni and Pb), much higher (56–67% for Cu and Zn) and exceptionally high (160% for Mo). A significant correlation between the translocation factors for Fe and As may confirm that Fe-Mn oxides/hydroxides represent the major sorbing agents for As in soils. The presented data, due to As contamination in travertine limestone, soil and plants, suggest a potential environmental risk not only for that part of Greece but in general for similar depositional environments.