Startseite Electrochemical Lithium Insertion/Extraction in Partially Reduced α-MoO3
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

Electrochemical Lithium Insertion/Extraction in Partially Reduced α-MoO3

  • A. M. Hashem , H. Abbas und A. E. Abdel-Ghany
Veröffentlicht/Copyright: 25. September 2009

Abstract

This work concerns with synthesis, structural, thermal and electrochemical characterization of molybdenum oxides (stoichiometric MoO3, sub-stoichiometric oxide MoO3−x (where x is a small fraction) with layered type structure. XRD investigations of the samples proved that the crystal structure of the layered α-MoO3) has been maintained after the reduction process.

The reduced samples exhibited a drastically improved charge/discharge cycling stability and capacity retention on cycling in 1 M LiClO4/propylene carbonate. At higher cycle numbers (approx. cycle 50) the discharge capacity of the reduced molybdenum oxides stabilizes at a level of approx. 50 mAh g−1, whereas the non-reduced MoO3 has retained only about 45 mAh g−1 after 20 cycles. This significant improvement of the rechargeability may be related to improvement in the electronic conductivity after reduction process.

Published Online: 2009-9-25
Published in Print: 2004-11-1

© 2004 Oldenbourg Wissenschaftsverlag GmbH

Heruntergeladen am 18.10.2025 von https://www.degruyterbrill.com/document/doi/10.1524/zpch.218.11.1259.50809/html
Button zum nach oben scrollen