Startseite Influences of counterface materials and reinforcements on the sliding wear of copper matrix composites
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

Influences of counterface materials and reinforcements on the sliding wear of copper matrix composites

  • Yongzhong Zhan EMAIL logo , Guoding Zhang und Zhenyi Liu
Veröffentlicht/Copyright: 20. Dezember 2021
Veröffentlichen auch Sie bei De Gruyter Brill
Informationen für Autor*innen
International Journal of Materials Research
Aus der Zeitschrift International Journal of Materials Research Band 95 Heft 2

Abstract

The influences of counterface materials and reinforcements on the sliding wear behavior of copper matrix composites have been investigated. Experiments were performed using a block-on-ring type wear machine on which SiC/Cu and (SiC+Gr)/Cu hybrid composites were slid against various counterfaces, i. e. GCr15 bearing steel, 45 medium carbide steel and AlSi alloy. Experimental results show that increasing counterface hardness is in favor of the establishment of a wear resistant mechanically mixed layer (MML) on SiC/ Cu composite, while massive materials transfer and seizure take place when tested against soft counterface. The wear resistance of hybrid composite is improved by forming a graphite-rich MML, and the hardness of steel counterfaces does not influence the wear behavior obviously. The graphite film formed on the two sliding surfaces alleviates materials transfer and avoids the occurrence of seizure with soft counterface.

Keywords: Copper matrix composites; Wear behavior; Counterface materials; Graphite particles
Dr. Yongzhong Zhan, State Key Laboratory of Metal Matrix Composites, School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai, 200030, P. R. China, Tel.: +86 21 6293 3106, Fax: +86 21 6282 2012

References

[1] J.A. Vaccari: Amer. Machinist 135 (1991) 42.Suche in Google Scholar

[2] M. Noguchi, K. Fukizawa: Adv. Mater. Process 143 (1993) 20.Suche in Google Scholar

[3] I. Sallit, C. Richard, R. Adam, F. Robbe-Valloire: Mater. Charact. 40 (1998) 169.10.1016/S1044-5803(98)00007-2Suche in Google Scholar

[4] A.P. Sannino, H.J. Rack: Wear 189 (1995) 1.10.1016/0043-1648(95)06657-8Suche in Google Scholar

[5] R.L. Deuis, C. Subramanian, J.M. Yellup: Comp. Sci. Tech. 57 (1997) 415.10.1016/S0266-3538(96)00167-4Suche in Google Scholar

[6] P.K. Rohatgi, S. Ray, Y. Liu: Inter. Mater. Rev. 37 (1992) 129.10.1179/imr.1992.37.1.129Suche in Google Scholar

[7] D. Nath, S.K. Biswas, P.K. Rohatgi: Wear 60 (1980) 61.10.1016/0043-1648(80)90249-5Suche in Google Scholar

[8] W. Ames, A.T. Alpas: Metall. Mater. Trans. A 26 (1995) 85.10.1007/BF02669796Suche in Google Scholar

[9] Y. Liu, J.D. Hu, Z.Y. Cao, P.K. Rohatgi: Wear 206 (1997) 83.10.1016/S0043-1648(96)07496-0Suche in Google Scholar

[10] J. Zhang, A.T. Alpas: Mater. Sci. Eng. A 161 (1993) 273.10.1016/0921-5093(93)90522-GSuche in Google Scholar

[11] A.R. Riahi, A.T. Alpas: Wear 251 (2001) 1396.10.1016/S0043-1648(01)00796-7Suche in Google Scholar

[12] G. Straffelini, A. Molinari: Wear 236 (1999) 328.10.1016/S0043-1648(99)00292-6Suche in Google Scholar

[13] P.D. Wood, P.K. Datta, J.S. Burnell-Gray, N. Wood: Mater. Sci. Forum 251–254 (1997) 467.10.4028/www.scientific.net/MSF.251-254.467Suche in Google Scholar

[14] S.C. Tjong, F. Chen: Metall. Mater. Trans. A 28 (1997) 1951.10.1007/s11661-997-0127-1Suche in Google Scholar

[15] Y.B. Liu, S.C. Lim, S. Ray, P.K. Rohatgi: Wear 159 (1992) 201.10.1016/0043-1648(92)90303-PSuche in Google Scholar
Received: 2003-05-12
Accepted: 2003-11-27
Published Online: 2021-12-20

© 2004 Carl Hanser Verlag, München

Artikel in diesem Heft

  1. Frontmatter
  2. Articles BBasic
  3. Thermodynamic modeling of the Rh–Zr system
  4. Ni grain boundary diffusion in coarse-grained Fe-40 wt.% Ni alloy and comparison with Ni diffusion in the nanocrystalline alloy
  5. Crystallization kinetics of an amorphous Zr70Cu20Ni10 alloy
  6. Oxidation-induced cavity formation in binary β-NiAl alloys
  7. Articles AApplied
  8. Influences of counterface materials and reinforcements on the sliding wear of copper matrix composites
  9. Model of artificial neural network for complex data analysis in slag glass-ceramic
  10. Quantitative investigation of material erosion caused by high-pressure discharges in air and nitrogen
  11. Role of alloying elements on machinability of plastic-molding steels
  12. A simple model for the strength and elongation of ultra-fine grained low carbon steels
  13. Notifications/Mitteilungen
  14. Personal/Personelles
  15. Conferences/Konferenzen
https://doi.org/10.3139/ijmr-2004-0021
Schlagwörter für diesen Artikel
Copper matrix composites; Wear behavior; Counterface materials; Graphite particles

Artikel in diesem Heft

  1. Frontmatter
  2. Articles BBasic
  3. Thermodynamic modeling of the Rh–Zr system
  4. Ni grain boundary diffusion in coarse-grained Fe-40 wt.% Ni alloy and comparison with Ni diffusion in the nanocrystalline alloy
  5. Crystallization kinetics of an amorphous Zr70Cu20Ni10 alloy
  6. Oxidation-induced cavity formation in binary β-NiAl alloys
  7. Articles AApplied
  8. Influences of counterface materials and reinforcements on the sliding wear of copper matrix composites
  9. Model of artificial neural network for complex data analysis in slag glass-ceramic
  10. Quantitative investigation of material erosion caused by high-pressure discharges in air and nitrogen
  11. Role of alloying elements on machinability of plastic-molding steels
  12. A simple model for the strength and elongation of ultra-fine grained low carbon steels
  13. Notifications/Mitteilungen
  14. Personal/Personelles
  15. Conferences/Konferenzen
Jetzt anmelden und 20% sparen
Institutioneller Zugang
Wie funktioniert Authentifizierung?
Haben Sie eine Idee, wie wir unsere Website verbessern können?
Bitte schreiben Sie uns.
© 2025 De Gruyter Brill
Heruntergeladen am 17.11.2025 von https://www.degruyterbrill.com/document/doi/10.3139/ijmr-2004-0021/pdf?lang=de
Button zum nach oben scrollen